Wet material, containing 215% moisture (dry basis) is to be dried at the rate of 1.5 kg/sec in a continuous dryer to give a product containing 5% moisture (wet basis). The drying medium consists of air heated to 373°K and containing water vapor equivalent to a partial pressure of 1.40 Kpa. The air leaves the dryer at 310°CK and 70% saturated. Calculate how much air will be required to remove the moisture. A. 213,233 kg/hr B. 177,142 kg/hr C. 177,242 kg/hr D. 198,234 kg/hr Solve and arrive the exact given one of these choice. Elaborate the process and make the schematic diagram. Thanks!

Q: Water at a flow rate of 40 kg/s should be cooled from 40°C to 30°C in a humid cooling tower.…

A: Given:Mass flow rate water, m˙w=40 kg/sInlet and outlet temperatures of water, Twi=40oC, Two=30oCAir…

Q: 8. Consider two rooms that are identical except that one is maintained at 25°C and 40 percent…

A:

Q: . A parallel-flow heat exchanger is used to cool milk (C=3.845 J/Kg. 0 C) entering at 110 Celsius.…

A: The heat transferred through a heat exchanger can be calculated using the formula given below as-…

Q: Air at 0° C and 95% relative humidity has to be heated and humidified to 25° C and 40% relative…

A: Given: State 1  Dru Bulb Temperature Tdb1=0oC Relative Humidity RH1=95% State 1  Dru Bulb…

Q: what is its mixing ratio

A:

Q: Fruit juices at 20 ° C containing 5% total solids were concentrated via a single effect evaporator.…

A:

Q: The process of oxidizing air in a humidifier, air at a dry bulb temperature of 25 degrees Celsius…

A:

Q: x kg/s of moist air at 35°C dry bulb temperature and 20% RH is mixed with kg/s of moist air at 20°C…

A:

Q: In order to increase the humidity of an air stream having a temperature of 55°C and humidity of…

A:

Q: Show the step-by-step process. Do not use shortcut methods. Make it as detailed as it can be. MAKE…

A: Given Process plant moisture = 100%  Product moisture = 10% Heated air  temperature = 100 C Heat air…

Q: if steam at 375 kpa , having a dryness fraction of 96% , is produced from saturated water at 375 kpa…

A: Given that: P = 375 kPa x = 0.96 state 1 = saturated liquid state 2 = liquid-vapor phase at P and x…

Q: The artisanal production of cold-pressed extra virgin olive oil proceeds as follows. A stream of…

A:

Q: Air with a relative humidity of 95% and temperature of 35°C is pumped into a chamber filled with a…

A: Given : ϕ=0.6 T1=35 C , RH=95% T1=40 C , RH=5% t = 15 mins = 900 secs To find :

Q: How does a liquid-desiccant dehumidification system remove moisture from the air?

A: The concentrated fluid desiccant assimilates dampness from the approaching air and dehumidifies. The…

Q: 20 kg of foodstuff initially has a water content of 70% (dry basis). This material is dried to a…

A:

Q: Part A How many grams of ice at -14°C must be added to 712 grams of water that is initially at a…

A: GIvenT1=-14oCm2=712g=0.712kgT'0=83oCTf=19oCCw=4190 J/kg CCi=2050 J/kgCLHF=334 ×103 J/kg

Q: A geothermal heat pump or 'ground source heat pump,' is a highly efficient renewable energy…

A: It is asked to design the heat pump based on the given design criteria Required heat demand = 12.3…

Q: 3. A product having a moisture content of 60% (wet basis) is dried in a tunnel-type dryer at a rate…

A:

Q: In an attempt to conserve water and to be awarded LEED (Leadership in Energy and Environmental…

A: To findthe rate of intake of air at ambient conditions in cubic feet per minute.The hours of…

Q: A room is to be maintained at a state of 20 celsius degree dry-bulb and 50 percent saturation by a…

A: Given: The dry bulb temperature of the room initially, Tdb1 = 20oC The relative humidity, w1 = 50%…

Q: A product having a moisture content of 60% (wet basis) is dried in a tunnel-type dryer at a rate of…

A:

Q: A fire-tube steam boiler must produce 1.5 kg/s of saturated steam with 3% humidity, at 160°C. The…

A:

Q: 600 lps of air at 30°C dry-bulb and 22°C wet-bulb temperatures is heated to a temperature of 45°C…

A: Given:Inlet air condition, V˙1=600 L/s=0.6 m3/s, Tdb1=30oC, Twb1=22oCOutlet air condition,…

Q: at 25 ° C containing 5% total solids were concentrated via a single effect evaporator. The…

A: mp = 3000 kg/hInital concentration is 0.05 and final concentration is 0.40Steam pressure is 169.06…

Q: Consider a boiler that burns sub-bituminous coal. The boiler has a cyclone furnace burner and has a…

A: Given : P = 500 MW C = 25 MJ/kg To find : Annual emissions of mercury

Q: Can anyone answer  letter b? Thank you in advance!   The manufacturing of pie filling involves…

A: (b) the flow rate of liquid sugar into the process; according to the given details provided.

Q: I need this question in 1 hour, I will give you a good review......... A saturated mixture of 2 kg…

A: Given data:Initial mass of liquid water: mw = 2 kgInitial mass of steam: ms = 0.7 kgInitial…

Q: One m3/s of air at 12°C and 50% RH is heated and humidified using saturated steam at 100 °C to a…

A:

Q: With the help of a neat figure discuss the working principle of evaporative cooling system. What are…

A: Introduction Evaporative cooling has been utilized to cool living spaces since the dawn of human…

Chemical and Phase Equilibrium

Phase diagrams or equilibrium phase diagrams are the graphical representations that show the phase transformations of the constituting elements with respect to the pressure, temperature, and compositions. The diagrams show the conditions that limit the different phases, namely solid, liquid, and gas. The diagram can also be utilized to verify the relations between the state variables. Most of the phase diagrams are temperature-pressure phase diagrams, with the variable parameter as the composition. Usually other variables such as solubility and pressure parameters are not indicated in the phase diagram. For a one-component system (unary phase diagram), the phase diagram is generally a function of temperature and pressure as the state variables, or temperature and volume. However, for a binary system (two-phase) having two components, the phase diagram is a function of temperature and composition as the state variables only. Coexisting of the different phases of the constituting elements is indicated in the phase diagram. A ternary phase diagram can be characterized by consisting of three phases in equilibrium.