Weight W is supported by spring OC, which is attached to two cables at O. The un-stretched length of spring OC is Im. The spring constant is equal to K. a= 6 b= 8 m c6 m dm KN/m W N a = 6 m b = 8 m c = 6 m W = 250 N K = 626 N/m %3D %3D Find the tension TA in cable OA ENTER 3 tries remaining. 1 point(s) possible Find the tension Tg in cable OB N ENTER 3 tries remaining. 1 point(s) possible Find the distance d of the spring's lower end to the ceiling

Q: Let F₁ = [F1] N and let F₂ = 350 N. g) Determine the magnitude FA of the force at pin A. h)…

A: Given data: F1= 839 N  F2= 350 N  Free Body Diagram of the member AB:

Q: If the mass of the gusset plates at the joints and the thickness of the members can be neglected,…

A: We are given mass of each truss member per unit length = 4 kg/m each member length = 4 m total mass…

Q: 1.1.8, T is wrong, please correct.

A: Approach to solving the question: Detailed explanation:Examples: Key references:

Q: 2. The uniform plate has a weight of 400lb. Determine the tension in each of the supporting cables,

A:

Q: *2-8 Part of a control linkage for an a rigid member CBD and a flexible cab applied to the end D of…

A:

Q: The 540-lb cylinder at A is hoisted using the motor and the pulley system shown. The speed of point…

A:

Q: The rigid beam is supported by a pin at D and cables at AE and CF. If the load P is applied at B on…

A: A rigid beam is hinged at D, the beam can rotate about D but it cannot deform.A load P is applied at…

Q: The frame ACD is supported by ball-and-socket joints at A and D and by a cable that passes through a…

A:

Q: A load of 175 N applied to the members shown below causes a tension of 40Ó N in cable DC. a)…

A:

Q: The sign shown has a mass of m = 121 kg and is supported by two cables and a ball and socket at A.…

A: The  mass of the signboard, m = 121 kgThe board is supported by two cables at points E and B.To…

Q: 3. For the cables shown in Figure ST – 064 1. Compute the tension in each segment if P = 400 N. 2.…

A:

Q: Determine the angle between cable AC and strut AO. Determine the magnitude of AC and AO.

A: Given: Required; Angle between AC and AO  Magnitude of AC and AO

Q: Problem 4) Assume the loads applied to the beam result in a uniformly horizontally d once…

A:

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.