The frame ACD is supported by ball-and-socket joints at A and D and by a cable that passes through a ring at B and is attached to hook at G and H. Knowing that the frame supports at point Ca load magnitude P = 125 N and weighs 35 N, center of gravity at C, determine the tension in the cable. 0.35 m 0.875 m G H 0.925 m 0.75 m D 0.75 m В 0.5 m 0.5 m

Q: Let F₁ = [F1] N and let F₂ = 350 N. g) Determine the magnitude FA of the force at pin A. h)…

A: Given data: F1= 839 N  F2= 350 N  Free Body Diagram of the member AB:

Q: Consider the frame shown in (Figure 1). The spring has a stiffness of k = 880 lb/ft Figure 6 in. +…

A: Given Data -  Spring Coffiecient k = 880 lb/ft  Spring compression = 0.5 inch    Find out -  The…

Q: A steel girder is part of highway 251A bridge in OK. Inspection reports have indicated that some…

A:

Q: *2-8 Part of a control linkage for an a rigid member CBD and a flexible cab applied to the end D of…

A:

Q: D. 70° The uniform plank ABC weighs 400 N. It is supported by a pin at A and a cable that runs…

A:

Q: No. 2. A rigid bar ABCD is pinned at end A and supported by two cables at points B and c (see…

A:

Q: Q4 -The homogeneous bar ABCD shown in the Figure is supported by a Cable that runs from A to B…

A:

Q: Determine the internal moment at joints F and G. 8m F A B 4m+ 8m 20 kN/m 8 m G D E 44m 4

A: To find the internal moment at the Joints F and G of the symmetric frame shown in the figure.

Q: Find the maximum force P that can be applied to the foot pedal. The 6 mm diameter pin at B is in…

A:

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.