Answered: Water strands upto the height of 5.7 mm… | bartleby

Related questions

Question

Water strands upto the height of 5.7 mm
in a capillary tube held vertical with its lower
end dipped in the water. Find the surface
tension of water if diameter of bore of capillary
tube is 5 mm. Density of water is 10° kg/m³.

Expert Solution

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

#12-21. A pipe carries water at a flow rate of 25 gpm. Determine the minimum inside diameter so that the average velocity of the fluid does not exceed: a. 10 ft/s b. 8 ft/s c. 4 ft/s.
A spherical object (radius=4cm) weight on air is 0.45 N and when submerged in water its weight is 0.36 N. Calculate the density of the water.
To what height should a cylindrical vessel be filled with a homogenous liquid to make the force with which the liquid presses on the sides of the vessel equal to the force exerted by the liquid on the bottom of the vessel?
A uniform cross-sectional area U-tube is open to the atmosphere, is partially filled with mercury (density = 1.36 x104 g/cm3 ). Water is then poured into both arms. If the equilibrium configuration of the tube is as shown in Figure, with h2 = 1.00 cm, determine the value of h1.
(b) Water enters a house through a pipe with an inside diameter of 2.0 cm at an absolute pressure of 4.x 105 Pascal (about 4 atm). A 1.0-cm- diameter pipe leads to the second-floor bathroom 5.0 m above. When the flow speed at the inlet pipe is 1.5 m/s find, the flow speed and pressure in the bathroom.
If liquid enters a horizontal conduit with circular cross-sectional radius of 2 m at 8 m/a and exists the conduit a short distance later after the cross-sectional radius has increased to 2.5 m, what is the density of the fluid if the pressure is 11,000 Pa greater at the exit?