Water is pumped through a vertical 5.0 cm cement-lined steel pipe to an elevated tank on the roof of a building. The measured pressure at the discahrge side of the pump is 1380 kPa. What pressure can be expected at a point in the pipe 76 m above the pump when the flow is 9.5 L/s? Use f= 0.023 a. 100 kPa b. 225 kPa c. 150 kPa d. 75 kPA

Q: The efficiency at the best operating point is:

A: The best operating point is that point at which a pump is least prone or least probable to failure…

Q: 15. A pump operating at 660 hp delivers water, from a large pressurized supply tank to a large…

A: Given: The pump power, P = 660 hp The water flow rate, Q = 150 ft^3/s The total length, H = 1000 ft…

Q: Water is pumped through a vertical 5.0 cm cement-lined steel pipe to an elevated tank on the roof of…

A:

Q: ump efficiency= 97% Pump speed= 1848 rpm Pump discharge= 172L/s of water to a height at 61 m.…

A:

Q: 3. Based from the pump performance curve below, calculate the following: a) Specific speed b)…

A: Given data Pump performance curve From the pump performance curve,  specific speed and suction…

Q: In the system, 900 L/min of oil is pumped with (s=0.92), from an underground storage tank to the…

A: Given: The flow rate of the oil, Q = 900 L/min The specific gravity of the oil, SG = 0.92 The loss…

Q: 8.78. A pump is designed to operate at 1 800 r/min with 83.7% efficiency, and deliver 250 1/s with a…

A: Given:N=1800 rpmη=83.7%Q=250 L/s =250*10-3 m3/sP=141 KW

Q: -1. A large tank contains air, gasoline (pc= 680 kg/m³), light on p 800 kg/m³) and water. The…

A: Given:Density of the gasoline, ρG=680 kg/m3Density of light oil, ρo=800 kg/m3Pressure p of the air,…

Q: What pump power is required if an engineer wants to pump water from one reservoir to another…

A: To find: The power required by pump. Given: The length of pipe is L=100 m. The diameter of pipe is…

Q: ong Stag 2. The following data relate to an inclined venturimeter: Diameter of the pipe line = 400…

A:

Q: 1. The submersible pump in the figure sends 12.5 gal/min of water through a 1" diameter pipe.…

A: Given:Water flow rate, Q=12.5 gal/min=12.5448.831ft3/s=0.02785 ft3/s     1 ft3/s=448.831 gal/minPipe…

Q: I need the answer as soon as possible

A: Dear student,                     According to the guidelines I am allowed to answer only one…

Q: Head, m Consider the plot below, what is the operating flow rate of the pump in this ?system 25 20…

A: To determine the operating flow rate of the given pump.

Q: An air compressor takes air at 100 Kpa and discharges to 600 Kpa. If the volume flow of discharge is…

A: Given :  P1 = 100 KPa P2 = 600 KPa volume flow of discharge, V.2 = 1.2 m3/sec To find : capacity of…

Q: Diffrentiate between pumps and turbines

A:

Q: Figure below shows a siphon that is used to draw water from a tank. The siphon tube has an inside…

A:

Q: A large pipe with a cross-sectional area of 1.00 sq m descends 5.00 m and narrows to 0.500 sq m,…

A:

Q: b. A client is desirous of pumping water at 60°F from one reservoir to another at 120 ft higher…

A:

Q: Water is to be supplied to the inhabitants of a college hostel through a supply main. The following…

A: We have provided data from the question are,  L=4000 m  N=Number of inhabitants=3000  Q=180…

Q: Q4: Centrifugal fan Q₁ 1.8 m3/s and Pa 1.2 kg/m² and P, 740 pa and N₁ 1100 r.p.m find. 1-W₁1 10.7 2-…

A: (a) To find: The compressor work. Given: The flow rate of the fan is Q1=1.8 m3s. The density of air…

Q: 72. A pipe is connected vertically to the discharge side of a pump. The top of the pipe is a short…

A:

Q: A 20-KW motor with 80% efficiency drives a centrifugal pump delivery 0.08m3/sec against a head of…

A: Introduction The efficiency of the pump consequently, is never more than a hundred percent since…

Q: Pump has a displacement of 98400 mm". It delivers 91.2 Lpm of oil at 1000 rpm and efficiency is 81.7…

A:

Q: The distribution system requires to lift water to an area with an average elevation of 100 mamsl…

A: The Answer is below

Q: What is the performance of pump (in %, whole number) that supplies 80 gpm of water (80°F) with…

A: Solution is attached below:

Q: 3. Based from the pump performance curve below, calculate the following: a) Specific speed b)…

A: Given data pump performance curve  Specific speed and Suction Specific speed is to be calculated.

Q: An air stream enters a variable area channel at a velocity of 30" " m/s with a pressure of 120kPa…

A:

Q: 5. Write down the Benoulli equation and explain the meaning of each terins 6. Water is flowing…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Determine the pump head (unit: meter or kPa), using the following parameters

A:

Q: Draw the right diagram for the problem. Show complete solution. Water at 60 F from a lake through…

A:

Q: A pump with an impeller diameter of 0.02 m, an impeller speed of 58.3 rpm, a total capacity of 12…

A:

Q: Show in Figure 1 is the water flow system. The velocity head difference is = 2.0m. Volume flow rate…

A: Given data as per the question velocity head =2 m volume flow rate =0.5 m3/s h1 =1 m h2 =2 m hA = 3…

Q: I. High-compressive strength II. Good machinability III. Good resistance to wear and thermal fatigue…

A: The statements which are true for gray iron. Answer: I) High-compressive strength II) Good…

Q: Thirty (30) liters/second of stream water must be pumped up a vertical height of 12 meters to…

A: Water flow rate, Q=30 Lit/s Water pumped to vertical height, H=12 m Pump efficiency, ηpump=62% Motor…

Q: A three lobe rotary pump moves 0.0825 gal of a coal slurry in each lobe volume. The volume flow rate…

A:

Q: Shown below is the water jet flow from a pressurized closed tank. The vertical distance between free…

A: Given data:- h1 =13 m h2 = 15 m Y=9.81 kN/m^3 Find the pressure at 1.

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.