Water is following in a clean and straight natural channel of rectangular cross-section with a bottom width of 300m and a bottom slope of 0.001. If the water depth is measured to be 3m, determine the flow rate of water through the

Water is following in a clean and straight natural channel of rectangular cross-section with a bottom width of 300m and a bottom slope of 0.001. If the water depth is measured to be 3m, determine the flow rate of water through the

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Water flows through a 1.8-m-wide rectangular channel with a Manning coefficient of n = 0.012. If the…

A: The expression for the flow area of the channel is given as, Here, AC is the flow area of the…

Q: Water flows in a rectangular concrete channel that is 12m wide at a depth of 2.5m. The channel slope…

Q: Consider a wide rectangular water channel with a per-unit-width ﬂow rate of 5m3/s⋅m and a Manning…

Q: Given that Q = 20 m3/s, calculate the flow depth of the stream after the scour hole.

Q: Water is flowing uniformly in an open channel (triangular shap has a 1:2 (v:h) side slope and a…

Q: A trapezoidal channel having side slopes of 1:1 and bed slope of 1 in 852 is required to carry a…

A: Given: The side slope of the channel is 1:1. The bed slope is 1 in 852. The discharge is the channel…

Q: Water flows in a 1.5-m wide rectangular channel with a constant bed slope So = 0.144 (see figure…

Q: A drainage canal in the shape of trapezoid with a bottom width of 2,3m and a side slope of 1…

A: B=2.3m y=2.8m n=0.012 S=0.0004

Q: Water flows from a lake into a steep rectangular channel 3 m wide. Determine the lake level above…

Q: Q (5-2)/ Water flows uniformly in an earth rectangular cross section open channel. Data available…

Q: Find the approximate flow rate at which water will flow ina conduit shaped in the form of an…

Q: Find the approximate flow rate at which water will flow in a conduit shaped in the form of an…

A: Given; Area of cross section (A)=0.075 m2 For equilateral triangle, A ;…

Q: Fluid Mechanics question: Water flow from a pone through a 10cm diameter pipe. Find the flow rate…

A: Given: Elevation of point ‘A’ from ‘B’ = 10 Diameter of the pipe = 10cm

Q: Find the flow for a rectangular channel, 5 m wide for uniform at depth of 2 m. The channel has a…

A: A = Flow Area, (ft2) n = Manning's Roughness Coefficient. R = Hydraulic Radius, (ft) S = Channel…

Q: Water flows in the symmetrical trapezoidal channel lined with asphalt. S=0.001, n=0.015, determine…

A: The given data is shown below: S=0.001n=0.015

Q: Give Answer fast and right.

A: Calculations:Given data y = 2.438 - depth of flow in meters B = 12 - bottom width in meters z =…

Q: For a trapezoidal channel having discharge 14 m'/s. It have sluice gate opening 0.5 m. The channel…

A: Given Q = 14 m3/s B = 6m S0 = 0.0033 n = 0.024 Side slope = 1H : 2V S0, z = 1/2 =0.5 First find…

Q: Find the bed width and bed slope of a canal with the following data: discharge permissible mean…

Q: For a trapezoidal channel (n=0.025, So = 0.002) with a bottom width of 15 m and a side slope of 2.5,…

A: Channel - Trapezoidal Manning's Coefficient, n = 0.025Bed slope, SO = 0.002Bottom width, B = 15m…

Q: a triangular concrete-lined channel n=0.017 has a constant mild bed slope of 0.0015, side slopes of…

A: Data given n=0.017 S = 0.0015 slope = 1H:1V, z=1 yn = 2.6 m y2 = 5 m interval of depth = 0.01 m For…

Q: Water flows in a rectangular finished concrete channel that is long enough that uniform flow…

A: Given- Q=9.6 m³/sb = 2.2 mn=0.012S∘ =0.00205 h=0.34 m

Q: A 1-m-diameter clay tile (n=0.014) sewer pipe runs half full on a slope of 0.004. Compute the flow…

A: To Determine Flow Rate, Q

Q: Determine the slope of the bed of a rectangular channel of width 6 m and depth of flow 3 m. Assume…

A: The hydraulic radius is given by,

Q: To convey a discharge of 25 m3/s, a lined canal (n = 0.015) laid at a slope of 1 in 1600 is…

Q: 7. Water flows in a 3m wide rectangular channel. If the critical depth was measured to be 0.542m,…

A: Given data- Width of the rectangular channel- W=3 m, Critical depth y=0.542 m, To Find- The maximum…

Q: A triangular channel with most efficient proportion discharges water at the rate of 1m^3/s. Assuming…

Q: Find the discharge through a trapezoidal channel of 8 m wide and side slopes of 1 horizontal to 3…

Q: An open channel has a vee shaped cross section with sides inclined at an angle of 60° to the…

A: Given :

Q: The flow depth in a long trapezoidal channel (bottom width = 8 m, side slopes 1:1) for a flow of 28…

A: Given : Bottom width = 8m Side slopes = 1:1 Q = 28 m3/s Bottom slope = 0.0001 To Determine : Flow…

Q: A concrete channel, rectangular in shape, is laid on a channel bed of slope 0.0010. At an upstream…

A: Given data Wide, b=4.5 mDepth at upstrem, d1=1.5mDepth at downstream, d2=1.17 mLength, L=300mSlope,…

Q: A 5 m wide rectangular channel carries a discharge of 16 m3/s. Manning's roughness coefficient for…

A: Given data in question Width Discharge slope Constant To find out Depth of flow

Q: A trapezoidal open channel carries water at a depth of 2m. The canal has a bottom width of 6m and a…

A: solved

Q: A rectangular channel of width 550 mm has a discharge of 0.1 m/s and a uniform flow depth of 250 mm.…

A: Given: Width of channel, W = 550 mm Discharge, Q = 0.1 m3/s Depth of flow, H = 250 mm C = 55

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Given

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

Please try to solve
Civil Engineering 1. A main irrigation canal with a bed width of 2.5 meters and a side slope of 1.5 vertical, 2 horizontal is to be constructed at a uniform land slope/gradient. The capacity of the stream is 35 m³/s. If n=0.025, determine depth and the slope of the land. Show the full solutions and formula used.
steep-sided triangular section channel ( = 60o) has a flow rate of 300 m3/s. Find the critical depth, yc, for this flow rate. Verify that the Froude number is unity.
Civil
A triangular channel with most efficient section discharges water at the rate of 1.45 m3/s. Assuming n=0.018 and s=0.0021. Calculate the normal depth of flow in meters. CHOICES 1.05 5.10 1.50 10.5
Question 9 The water surface elevation at upstream section is 100m. The bed slope is 0.002 under uniform flow. The channel section has depth of 3 meters and width of 4 meters. Determine the water surface elevation downstream by 1.5 kilometers in meters.
Water flows in a concrete rectangular channel (n = 0.013) that is 12.0 m wide and water depth of 2.5 m. The channel slope is 0.0028. Calculate the water velocity V and flow rate Q.
Subject : Fluid mechanics Determine the normal depth (m) in a rectangular channel with flowing discharge of 90 m3/s, roughness of n=0.025, slope of 0.001, with bottom width of 6 meters.
Water flows from a lake into a steep rectangular channel 3.0 m wide, and the lake level is 4.0 m above the channel bed at the outfall. Find the discharge.