Water is discharged through a nozzle having a diameter of jet of 100 mm at a velocity of 60 m/s at a point 240 m. below the reservoir.1. Compute the total head loss.2. Compute the horsepower produced by the jet.3. Compute the power lost in friction

Water is discharged through a nozzle having a diameter of jet of 100 mm at a velocity of 60 m/s at a point 240 m. below the reservoir.1. Compute the total head loss.2. Compute the horsepower produced by the jet.3. Compute the power lost in friction

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A turbine system is harnessing the energy of flowing water from reservoir 1 to reservoir 2. The difference in elevation between the two reservoirs is 120ft. For a design flowrate of 50ft^3/s, the head loss is 30ft. Solve the theoretical power extracted by the turbine. Neglect the difference in atmospheric pressure between the reservoirs. O 511hp O 402hp O 245hp O 281hp
5): For the system shown below: 1-Find the water power of the turbine (PT) if the required power output is PE (take PE between 5-25 kN) and the turbine efficiency is n (take n between 75 to 98%) 2- Find the flow rate in the pipe AB. 3-Find the value of Z1 for operating this system (take Z2 between O to 20 m). * Pitot tube Piezometer. 0.3m 1.0m z1 22 T. Id= 200mm d= 100mm
6. The nozzle which furnished the water to a certain hydraulic turbine 275 mm in diameter and has coefficient of velocity and discharge of 0.98 and 0.955 respectively. The nozzle is supplied from a 60 cm pipe in which the water approached the nozzle with a total head of 330 m. Compute the energy per second delivered by the jet to the turbine and the energy measure in horsepower lost in passing through the nozzle.
During a flow of 450 L/s, a pressure of 65 kPa was measured at point C in 320 mm diameter horizontal the supply line of water turbine and a -47 kPa pressure T. was measured at point D, 2 m below point C at the 460 diameter exit pipe. mm Compute the total head extracted by a. the turbine. b. Compute the power supplied to the turbine in horsepower.
Oil with sp. gr. of 0.87 is being pumped from a lower reservoir to an elevated tank as shown. The pump in the system is 78% efficient and is rated 185 kW. Determine the energy added by the pump. 160mm w EL. 200m 200mm 9 El.150m Oif. Sp.gr.=(0.82
The nozzle which furnished the water to a certain hydraulic turbine 275mm in diameter and has coefficients of velocity and discharge of 0.98 and 0.96, respectively. The nozzle is supplied from a 60cm pipe in which the water approached the nozzle with a total head of 330m. Compute the following: a. Energy per second delivered by the jet to the turbine. b. Energy measured in hp lost in passing through the nozzle.
A pump draws water from a reservoir A and lifts it to reservoir B as shown. The loss of head from A and lifts it to reservoir B as shown. The loss of head from A to (1) is 5 times the velocity head in the 12-inch pipe and the loss of head from (2) to B is 23 times the velocity head in the 7-inch pipe. Compute the pressure heads (2) in ft when the discharge is 447 gpm. Round your answer to 2 decimal places.
The pump draws oil with specific gravity of 0.90 from a reservoir and delivers it to the hydraulic cylinder. The cylinder has an inside diameter of 5.0 inch and in 15 seconds the piston must travel 20 inches while exerting a force of 11,000 lb. It is estimated that there are energy losses of 11.5 lb-ft/lb in the suction pipe and 35.0 lb-ft/lb in the discharge pipe. Both pipes are 3/8-in Scheulde 80 steel pipe with inside diameter of 0.423 inch. Calculate the pressure at the cylinder.
Water at 10°C flows at the rate of 900 L/min from the reservoir and through the copper tube type K . Compute the pressure at point B, just considering the energy loss due to the straight pipe and neglecting the others losses(elbows and tank outlet)
PLEASE PROVIDE A COMPLETE SOLUTION WITH FIGURE FOR ME TO FOLLOW :) ANSWER IS GIVEN FOR REFERENCE. THANK YOU!