defeat Water is pumped from a lake to a storage tank 80 m above at a rate of 0.005 m³/s. If the GL pump-motor efficiency is 75%, and the irreversible head loss is 15 m. a) Find the consumed electric power by the pump. b) Find the pressure difference across the pump. 20 80 m ZT² Pump Storage tank 20 Zz Z

defeat Water is pumped from a lake to a storage tank 80 m above at a rate of 0.005 m³/s. If the GL pump-motor efficiency is 75%, and the irreversible head loss is 15 m. a) Find the consumed electric power by the pump. b) Find the pressure difference across the pump. 20 80 m ZT² Pump Storage tank 20 Zz Z

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

5): For the system shown below: 1-Find the water power of the turbine (PT) if the required power output is PE (take PE between 5-25 kN) and the turbine efficiency is n (take n between 75 to 98%) 2- Find the flow rate in the pipe AB. 3-Find the value of Z1 for operating this system (take Z2 between O to 20 m). * Pitot tube Piezometer. 0.3m 1.0m z1 22 T. Id= 200mm d= 100mm
Complete solution pls
6. The nozzle which furnished the water to a certain hydraulic turbine 275 mm in diameter and has coefficient of velocity and discharge of 0.98 and 0.955 respectively. The nozzle is supplied from a 60 cm pipe in which the water approached the nozzle with a total head of 330 m. Compute the energy per second delivered by the jet to the turbine and the energy measure in horsepower lost in passing through the nozzle.
PROBLEM E A hydroelectric power plant operates under a discharge of 500 cfs with 90 % turbine efficlency. The overall head loss Is 1.5 times the velocity head In the 7-ft-dlameter penstock. With the conditions stated, determine the following: (a) the velocity (ft/s) In the penstock, (b) the head loss (ft). (c) the head (ft) extracted by the turbine, (d) the power Input (hp) to the turbine, and (e) the power output (hp) expected from the turbine. 30 ft Water d=7 ft 5 ft
The system presented on Figure 1 pumps water from the left reservoir to ensure a water in the elevated basin stays level. Knowing that the offset from water-surface to water-surface 7.5m and the water temperature is 5oC, you must: a) Determine the out-flow from the basin's orifice; b) Determine the efficiency of the pump (n) feeding the basin if the pump's absorbed power is 2550W; Consider that hs=0 c) Determine how long it will take for the basin to fully empty if the pump ceases to function. Lconduit 20m; Chw-130; D=0.15m 1m h Dorifice =0.075m; h=1.2m; Dimension of the rectangular basin: 3m x 2m *The orifice coefficient can be presumed to be 0.9 Figure 1
Two reservoirs A and B have elevations of 250 m and 100 m,respectively. The two tanks are connected by a 250-mm diameterpipe, 250-m long, with a turbine placed along its length. If the flow ofwater in the pipe is 140 L/s and C = 120, then:Determine the power output of the turbine in kW if the efficiency ofthe turbine is 85%.
Water is flowing in a 3 m wide rectangular channel. A hydraulic jump occurs and the flow upstream is 360 mm deep while the flow downstream from the jump is 1300 mm deep. A) Find the discharge flowing in the channel. B) Find the energy absorbed by the jump in kW. Please answer correctly
8. Energy Equation Water at the Lake William Dam enters a hydraulic turbine through a 30 cm diameter pipe at a rate of 0.6 m³/s and exits through a 25-cm diameter pipe. For the system, elevation effects are negligible and the pressure drop across the turbine is measured to be 148 kPa. For a combined turbine-generator efficiency of 83 percent, calculate (a) hurbine and (b) Wubrine- You look in the FE handbook and see: W turbine = 7/turbine-gen”ightutine, e turbine-genhtubine, e 30 cm diameter 25 cm diameter Turbine Generator
Please include complete solution
A four-stage (parallel) pump delivers 15 m3 1950 rpm. It is desired to construct a pump at a certain number of stages in series that should run at 1450 rpm delivering 18m/min with 280m of head in total. What should be the new diameter of the impeller and number of stages? per minute of liquid. The total head obtained is 27m. Initially, the impeller measures 24cm in diameter running at
An oil fluid flows through pipe with a constant diameter. Determine the total energy head (in meter) at point A from the datum line 3 meters below the point B. po = 900kg/m3, PA = 50 kPa, pg = 94.10 kPa. 0.75 m A 5 m 2 m/s 30 B
Energy Equation: Example 2: h₂ 80 m = Datum D = 0.2 m 0.02)V² 2g L = 2000 m- = 0.02 V² D2g A horizontal pipe carries cooling water at 10°C for a thermal power plant. The head loss in the pipe is hL Q = 0.06 m³/s where L is the length of the pipe from the reservoir to the point in question, V is the mean velocity in the pipe, and D is the diameter of the pipe. If the pipe diameter is 20 cm and the rate of flow is 0.06 m³/s, what is the pressure in the pipe at L = 2000 m? Assume a₂ = 1.