Water flows through an 8-in (ID=7.981 in) steel pipe at an average velocity of 6 ft/s. Downstream the pipe splits into an 8-in main and a 2 in(ID=2.067 in) bypass pipes. If the velocity in the bypass is twice the velocity of the main pipe, the volumetric flow rate (ft³/s) in the main pipe is A. 10.58 B. 5.29 C. 1.84 D. 0.25

Q: A cylindrical tank, containing water, with a diameter of 3 m and a water level of 5 m is to be…

A:

Q: 11. Water at 65 F is pumped to a tank through a 750 ft 12-in diameter galvanized iron pipe

A: Given:Length of pipe=750 ft =228.6 md=12 in =0.3048 mVolume flow rate, Q=5 cfs =0.1415 m3/s

Q: . Water is flowing through a pipe, driven by only gravity (no pumping). a. If water is flowing…

A:

Q: A 10 in discharge pipe is attached to a certain storage. The head loss from the surface to the…

A:

Q: . Water flows through a constricted pipe at a uniform rate. At one point, the diameter of the pipe…

A:

Q: A centrifugal pump used to take water from reservoir to another through 800 m length and 0.15 m i.d.…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: Water flows through a horizontal pipe with a narrow constriction in the middle, as shown in the…

A: Given : To find : Velocity , Area

Q: Three pipoes A,B and C coNnected in series discharges 160 L/s of water. The properties of pipe: for…

A:

Q: Water is circulated from a tank of large proportions through a filter and then back to the mentioned…

A: Given, Power added to the water by the pump, Wp' = 200 ft.lb/a KL elbow = 1.5 KL Exit = 1 KL Valve =…

Q: The blades on the radial-flow pump shown in (Figure 1) rotate at w = 200 rad/s. The blades are 2 in.…

A:

Q: A pipe, diameter 15 cm, leaves a straight pipe with a diameter of 10 cm at point A, and later…

A:

Q: pumped fluid distribution system is being designed to deliver Q=200 gal/min  of water to a cooling…

A: Vvhh

Q: 2. Water at 80 ° F, flows at a rate of 4.30 ft/s in a pipe having an inlet diameter of 1.0 inch…

A: Given: Volume flow rate of the water in pipe at section1: →Q=4.30 ft3s diameter of the pipe at…

Q: A strain gauge is bonded to a beam 0.1 m long and has a cross-sectional area 3 m. Young's modulus…

A: Since you have asked multiple questions in a single request, we would be answering only the first…

Q: Water from an open tank elevated 5m above ground is allowed to flow down to a pump. From the pump,…

A: Given that, Elvation of tank, z=5 m,length of pipe, l=100 m,Number of elbow, n=2,Volume flow rate,…

Q: An inclined venturi meter has an inlet diameter of 0.075 m and 0.019 m diameter at the neck. If the…

A: Given:Inlet diameter, d1=0.075 mNeck diameter, d2=0.019 mThe pressure difference, P1-P2=175.5…

Q: The diameter of a 12 ft length of pipe increases uniformly from 12 to 36 in (see Fig). Kerosene (y =…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: Calculate the power required for a water pump used in a closed system with flow rate Q = 0.0076m ^ 3…

A:

Q: A Francis turbine with diameter of the runner and width are 2.4m and 0.3m, operates at 428rpm and…

A: Given data: Diameter of runner, D = 2.4 mWidth of runner, b = 0.3 mSpeed of runner, N = 428 rpm =…

Q: Water reservoir A (El. 13.5m) to reservoir B (El. 51.3) is lifted at the rate of 30000L/min. The…

A:

Q: 7.) A pipe carrying oil of specific gravity 0.877 changes in size from 150 mm at section 1 and 450…

A: For the above mentioned question

Q: The frictional headloss in a 5.0 cm diameter wrought iron pipe is 80kPa per 30 m length of pipe, If…

A: Answer: The rate of flow of water is 6.5 L/s. Therfore, the correct answer is option (a).

Q: In our house water pipe line with diameter of 2.25cm is connected to shower head that has 40 holes.…

A:

Q: Q. No 3). A water supply pipe line is designed to supplying water to a nearby city. Determine…

A: The relative roughness for commercial steel pipe is 0.045 × 10-3. Obtain the friction factor at…

Q: 32. Water at 100 F is pumped at a rate of 125 gpm to a reservoir 50 ft higher. The pipe length is…

A: Water temperature, T=100 FWater flow rate, Q=125 gpm=125448.83 ft3/s=0.2785 ft3/s        1…

Q: 2.1. You are required to determine the flow rate of water in a pipe with Venturi installation and a…

A:

Q: 8.114 Three water-filled tanks as shown are connected by pipes as indicated. Determine the flowrate…

A: Given:  Assuming the flow of water is From Tank A to Tank B and Tank A to Tank C

Q: he conveyor belt is moving downward at 5 m/s. If the coefficient of static friction between the…

A: Given:v=5 m/sm=12 kgμk=0.71

Q: QUESTION 2 A vertical circular tank that is 1.5 m high, has sloping sides. The tank is 50 m and 30 m…

A:

Q: Water flows through two different pipes A and B of the same circular cross-section but at different…

A:

Q: A dilute sugar-water solution enters a pipe with an ID of 3.05 inches at rate of 15.6 ft^3/hr, then…

A: Givendi=3.05in=0.254ftdo=6.4in=0.533ftQ=15.6 ft3/hr

Q: In the figure shown, there are 38 meters of 5-cm diameter pipe, 23 meters of 15-cm diameter pipe,…

A: Length of first pipe, L1=38 mDiameter of the first pipe, d1=5 cm=0.05 mLength of second pipe, L2=23…

Q: In a 3.5 MW hydroelectric power plant, the elevation of the headwater is 2100 m and that of a…

A:

Q: The 2-Mg car increases its speed uniformly from rest to 19 m/s in 28 s up the inclined road Part 1:…

A:

Q: Need detailed solution. 4 decimal places. A fluid is flowing in a 6 in diameter pipe at a pressure…

A: