Water flows in a trapezoidal channel with side slope 1V:3H, bottom width of 16ft and water depth of 4.5ft. The channel bottom drops 0.1ft every 100ft. Length, n=0.015 Compute the flow rate in ft3/s (using Manning) Group of answer choices 862.32 683.22 386.23 386.32

Q: From the Navier-Stokes equations for incompressible flowin polar coordinatesfi nd the most general…

A: Consider the following diagram:

Q: 8.5 A small reservoir has a spillway crest at elevation 200.00 m. Above this elevation, the storage…

A: A small reservoir has a spillway crest at elevation 200.00 llp0w The storage and outflow from…

Q: 2.1 In a rectangular channel F, and F, are the Froude numbers corresponding to the alternate depths…

A:

Q: Water flows in the canal of trapezoidal cross section shown in Fig.. The average velocity in the…

A:

Q: 6- Estimate the TOTAL streamflow in the channel below given the values in the table and the flow of…

A:

Q: Consider plane inviscid flow through asymmetric diffuser,as in Fig. C8.3. Only the upper half is…

A: The velocity distribution function explains average distribution molecular velocity and the pressure…

Q: - A trianqular oPen channeL with (o.25m) depth and 60 angle conveys water. if the bed slope is (1:…

A:

Q: Calculate values of the followings: y, B and v in the channel.

A:

Q: Determine the discharge, in L/s,

A: Solution: Givendata, Weir head = 0.30 m weir sides = 14.04 length of crest = 2m

Q: Q.27 A reservoir discharges through a sluice 0.915 m wide by 1.22 m deep. The top of the opening is…

A:

Q: The National Institute of Diabetes and Digestive and Kidney Diseases reports that the average cost…

A:

Q: Solve the following: Problem 1: Determine the uniform flow through a trapezoidal concrete lined…

A:

Q: The head over a rectangular sharp crested notch at the end of a channel is 0.75 m. If an error of…

A:

Q: An orifice is placed at the side of 2 m diameter vertical tank. The center of the orifice is 10 m…

A: Find horizontal velocity :ux=2gHux=2(9.81)(3m)ux=10.95445ms

Q: An open channel is triangular in cross-section with side's slopes 1: 1; if the depth of flow is 25cm…

A:

Q: A trapezoidal channel with IV:2H side slopes. Bottom width is 8 ft, slope is the channel has a flow…

A:

Q: Hand written and clean writing please..

A:

Q: Calculate the flow in an earth-lined (n = 0.022) trapezoidal canal having bottom width of 5.5m, side…

A:

Q: A cylindrical tank 400 mm in diameter, discharges water through a 30 mm orifice under a constant…

A: given:Diameter of orifice, d=30 mm or 0.03 mhead above orifice, h=5 mg=9.8 m/s2Q2: Diameter of pipe,…

Q: Water Resources Engineering: Given the stream section and the following measurements, calculate the…

A: The discharge is given by

Q: Time (hrs) 0 12 24 36 48 60 72 84 96 108 Inflow Discharge (m3/hr) 20 191 249 164 110 82 62 48 32 28…

A:

Q: 7. Estimate the discharge of water in a trapezoidal channel section having a depth 3m, width of 6m,…

A:

Q: Analyze the pipe network system by hardy cross method. 20 m3/min 5 m3/min 1500m 445mm 1000m 800m…

A: According to the Hardy Cross method, a balanced distribution network must satisfy the following…

Q: A pump draws water from a reservoir A (EL 0m) and lifts it to reservoir B (EL. 80m), the headloss…

A: Given: The flow rate is 15 L/sec. The diameter of the pipe at point 1 is 15 cm. The diameter of the…

Q: Route the inflow hydrograph below using the Muskingum method; At = 1 hr, X = 0.2, K = 0.7 hr. Time…

A: Step 1:Step 2:Step 3:Step 4:

Q: Three reservoirs Z, Y, and X meet at junction P. Reservoir Y (25m above Reservoir X) is at Elev.…

A: Given  rate of flow from z = 605L/sec Ele = 282m

Q: Q1: Compute the stream flow discharge for the measurements data below? Distance from bank (m) 10 20…

A:

Q: Q (5-7)/ Water flows uniformly in an earth rectangular cross section open channel. Data available…

A:

Q: If the median size of bed material of a natural channel is 2 mm, then the Manning's n for the…

A: Size of bed material d=2mm

Q: Water is flowing through a cast iron pipe at the rate of 3500 GPM. The inside diameter of the pipe…

A: Answer is (d) 6.810 m/sec

Q: Assuming the conduit in the figure is a 36” wrought iron pipe flowing full, and that the outlet is…

A: Conduit dimension = 36 '' For wrought iron, the friction factor will be = 0.008To find:The head loss…

Q: Time (hrs) 0 12 24 36 48 60 72 84 96 108 Inflow Discharge (m3/hr) a. Draw the Inflow and Outflow…

A: To plot the inflow and outflow hydrograph. And to identify the peak discharge rate in inflow and…

Q: Reservoir B in the figure receives 0.06 m^3/s of flow. Determine the flow in line AD.

A: QB=0.06m3s-1QB+Qc=QAwe knowhf=flQ212.1D5

Q: Water flows under a sluice gate in a horizontal rectangular channel of 2 m wide. If he depths of…

A:

Q: vhich is running full is 8m. Determine the discharge through the channel section if the

A: To find : Discharge through channel.

Q: The Reynold's number associated with a trapezoidal channel is 3,000,000. The ratio of fluid dynamic…

A:

Q: Atube15mlongistoconnecttwolargetankswhosedifference in water level is 2m. The tube is to carry 5L/s…

A: Given: The length of the tube is 15 m. The head loss is 2 m. The flow rate is 5 L/sec.

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.