Reservoir B in the figure receives 0.06 m^3/s of flow. Determine the flow in line AD. evation of reservoir B.92.76 m90.07 mC. 91.06 mD. 89.09 mEl 100m1500 m, 450 mm, f 0.022542El 82m500m, 250 mmf=0.0178D 750 m, 300 mm, f 0.0168

QB=0.06m3s-1QB+Qc=QAwe knowhf=flQ212.1D5

Answered: Reservoir B in the figure receives 0.06…

Engineering

Civil Engineering

Reservoir B in the figure receives 0.06 m^3/s of flow. Determine the flow in line AD.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 8.5 A small reservoir has a spillway crest at elevation 200.00 m. Above this elevation, the storage…

A: A small reservoir has a spillway crest at elevation 200.00 llp0w The storage and outflow from…

Q: 542.A hydraulic jump was established in the river. The depth before the jump measured 3.38 cm and…

A: Given data in question Depths of flow Width of channel Discharge To find out Type of jump

Q: 1. Consider a rectangular channel section having a length of 500 feet. The width of the channel is…

Q: Note:hand written solution should be avoided.

A: Approach to solving the question: Detailed explanation:Examples: Key references:

Q: Group work Example Two reservoirs with a difference in water levels of 180 m and are connected by a…

A: Head = H = 180m Length = L = 64Km or 64000m Diameter of pipe = D = .6m Friction factor = f = .015

Q: In the Given Rectangular Dam, determine the magnitude of the resultant R and where it intersects the…

A: Formula used:Pressure along the sea water :P=γHR=Rx2+Ry2

Q: Water flows under a sluice gate in a horizontal rectangular channel of 2 m wide. If the depths of…

A: In this problem, we are asked to calculate the discharge of water flowing under a sluice gate in a…

Q: Water flows through a semi-circular weir 2 m deep and 2 m wide at the top under a head of 1.50 m.…

A: The given data is: Depth of weir=2 m Width of weir=2 m Head of weir=1.5 m C = 0.65

Q: 42. The flow in line AD 0.219 m³/s 0.203 m³/s 0.234 m³/s 0.126 m³/s 43. The flow in line DC 0.186…

Q: Water flows over a smooth submerged object in a channel of width 1.2 m. The water depth upstream of…

Q: For the two-dimensional flow system shown below (units in meters):Compute the total flow rate under…

A: From the flow net, the number of flow channels is 3 and the number drops is 10. Given, x = 4; y = 8

Q: ble 12.2: r turbulent flow in pipes (sr

A: solution of above problem is below:

Q: Find the flowrate (in cubicmeter/ second).

A: Discharge coeff is given by:C=0.651+HPwH=1.6-1=0.6mC=0.651+0.6m1m=0.514

Q: luid mechanics

A: Given That, Discharge = 25 m3/s width = 4 m Deapth = 1.2 m maninngs n = 0.012

Q: Determine the flow rate of water as the figure shown. b = 5 m Yi = 1.5 m P = 0.60 m Sharp-crested…

Q: A rectangular concrete channel 5m wide carries water as shown in the figure below. The channel bed…

A: GIVEN : WIDTH ( B )= 5 m SLOPE OF BED = 0.0013 TO FIND DISCHARGE ( Q )

Q: Reservoir, 8,450 ft

Q: The flow rate through the rectangular canal of 1.5 m depth is 0.9 m/s as shown in the Figure. If…

Q: Reservoir A has an elevation of 138 m. A pipe is connected from reservoir A to reservoir B. It has a…

A: Q=0.96 m3/s C=121 d=0.922m

Q: 2. A V-notch weir is located at one end of a tank having a horizontal square section 12 m x 12 m.…

Q: A trapezoidal channel is to be designed for the maximum efficiency to carry a discharge of 10m2/s.…

A: The maximum efficiency of the channel is achieved by calculating the dimension for the hydraulically…

Q: For a 2-D flow field, the stream function y is 3 given as y==(y² - x²). 2 The magnitude of discharge…

A: Given- 2-D flow field stream function- ψ=32y2-x2points (0,3) & (3,4).

Q: a discharge of 700L/s flows through a pipe having a diameter of 400mm and a length of 60m long.…

Q: wo reservoirs having difference in water levels as 12m are connected by a pipe line 3 km long and 30…

Q: (7) Water flows in a rectangular channel with base width B-5 m and depth D=1.5 m. It then flows…

A: Given data Initial and final depth 1.5 and 0.5 mWidths 5 m find out Discharge Force

Q: If the head loss in an 8 km long cast iron pipe carrying water at a rate of 1.42 m^3/s is not to…

Q: The water velocity in the channel shown in the figure has a velocity distribution across the…

Q: 2.Water exits a reservoir through a 1-Km long D=?mm diameter horizontal Tunnel as shown below. The…

Q: A trapezoidal channel has a bottom width of 6m and side slope of 1:1. The depth of flow is 2m at a…

A: Bottom width = 6 mside slope = 1:1Depth of flow = 2 mDischarge = 24 m3/secTo find :Specific energy ?

Q: Three reservoirs A,B,C are interconnected as shown in figure. The elevations of free surface in…

A: Data given ZA = 100 m ZB = 90 m Pipe 1: Length, L1 = 1500 m Discharge Modulus, K1 = 0.6 m3/s Flow…

Q: The figure shows the cross section of a channel carrying water. Determine h, b and that minimize the…

Q: A reservoir has an outlet through a rectangular suppressed weir with a crest length of 1m. If its…

A: Answer is 636 sec but according to your options the 501 sec is nearest.

Q: Find the flowrate (in cubicmeter/ second). 11 = 1.6 m Discharge P = 1 m W Broad-crested weir

A: given- Length of the weir B= 1 mHead over weir H=1.6 m

Q: Q.9.13 A reservoir discharges through a sluice 0.915 m wide by 1.22 m deep. The top of the opening…

Q: Example 12.3. A small reservoir has a spillway crest elevation 200.0 m. Above this elevation, the…

A: Elevation of spillway =200.00 m Storage: S=36000+18000y (m3) Outflow: Q=10y (m3/s) Assume the…

Question

Reservoir B in the figure receives 0.06 m^3/s of flow. Determine the flow in line AD.

evation of reservoir B.
92.76 m
90.07 m
C. 91.06 m
D. 89.09 m
El 100m
1500 m, 450 mm, f 0.0225
42
El 82m
500m, 250 mm
f=0.0178
D 750 m, 300 mm, f 0.0168

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

For a 2-D flow field, the stream function y 3 y==(y²-x²). is given as 2 The magnitude of discharge occurring between the stream line passing through points (0, 3) and (3, 4) is
Convert all units in SI. Round off to 2 significant figures. Use Francis Formula. A sharp-created weir 2ft high extends across a rectangular channel 8 ft wide conducting irrigation water. If the measured head is 4 3/4 in., determine the discharge.
Sol 4.
The following figure shows three reservoirs connected by pipes. Find the discharge in each pipe and the piezometric head H at the junction. 12 B 10 = 2000 m. L,= 2300 m. L= 2500 m 1 2 D,=1 m. D,=0.6 m. D,=12 m S-0013. -0.02. 1,-0023
Plz help me
Please give correct answer Subject is fluid mechanics
In the vertical wall of a reservoir (A) there is a drowned hole that it flows into another reservoir (B) with a real discharge speed of 4,5m/s. This one reservoir (B), in turn, has a square orifice with free discharge of the form shown in the figure. It requires a flow of 0,089 m³/s and there is no overflow of the system. Determine determine the area and edges of orifice 2. (See the image) Data: Orifice diameter 1 = 0.2m; Discharge coefficient for orifice 2 = 0.604; contraction coefficient for orifice 2 = 0.64. Consider both holessmall in relation to the depth of the reservoirs.