Water flows at 0.07 cubic meter per second through a pipe. A horizontal venturi meter with throat diameter of 150-mm was used to measure the velocity inside the pipe. Based on manometer reading, the differential gauge is deflected 1.2 meter. If the specific gravity of the manometer fluid is 1.60, the diameter of the pipe, in millimeter (mm), that was used is

Q: Problem 4 Two tanks are connected using a manometer. Air is trapped in the right tank above the…

A: To find out the difference in Piezometric head of water between left and right tank.  Where,  H =…

Q: Example Problem: Venturi meter system. The venturi meter shown in figure blow carries water at 60°C.…

A: P1=PA+γWy+1.18PA-PB=γ0.46-1.18+1.25×γw1.18PA-PBγ=-0.72+1.27×1.18PA-PB9.65=-0.72+1.27×1.18PA-PB9.65=0…

Q: 04 The apparatus shown in the figure is used lo measure the velacily of air at the certer of a duct…

A: Solution Given that Diameter of duct=10 cm Diameter of mounted tube= 2 mm The temperature of air T=…

Q: 2. A pitot-static tube (C=1.0) is used to measure air speeds. With water in the differential…

A: Density of air and head water is given and it has been asked to determine velocity through pitot…

Q: erted manometers used Date: pi pe - Find the pressure difference of K Fluid x (s.g- 0.9) 0.5 m

A:

Q: Calculate the discharge through a venturimeter connected to a differential manometer. The liquid…

A: Introduction- The venturi meter is being used to determine the rate of flow of a fluid passing along…

Q: The pressure in a container is 45 kPa. If this pressure is measured using a manometer (U-tube) with…

A: P = 45 kPa or 45000 Pa = 2600 kg/m3

Q: Current Attempt in Progress A piston having a cross-sectional area of 0.35 m² is located in a…

A:

Q: torrsa and the local gravity is 978.892 cm/s". Determine the (a) density, (b) specific gravit and,…

A: Manometer: - It is an instrument by which one can find fluid pressure.

Q: 1. In Figure below, sensor A reads 3.5 kPa (gage). All fluids are at 15°C. Determine the elevations…

A: PA=3.5kPa

Q: r per second through a pipe. A horizontal venturi meter with throat diameter of 150-mm was used to…

A: We know the formulaQ=A1A2A12-A222ghh=x(SmSw-1)h=1.2(1.61-1)=0.72m

Q: Please give the right answer and show all of your work please

A: Velocity at section 2 is 54.333 m/sExplanation:

Q: Manometer with three liquids as shown. SGs are given. Calculate gauge pressure for oil. 20 KPa Water…

A: Given, to determine, Gauge pressure for oil.

Q: If the pressure (in psi) measured at the center of the pipe (+) is 0.12 psi, what should be the…

A:

Q: Using Hazen-Williams Eq., determine the headloss in both feet and psi when 750 gpm flows through the…

A:

Q: i) What is the gauge air pressure in the tank at Point 1?

A:

Q: 39 mm Venturi meter (C = 0.96) is installed in a 78-mm-diameter horizontal pipe carrying oil having…

A:

Q: Current Attempt in Progress (Bernoulli/continuity/Pitot tube) Two Pitot tubes and two static…

A:

Q: Inlet h = ? 2 Throat Water Oil, s = 0.852 Outlet

A:

Q: A fluid of specific gravity 0.8 is flowing in a pipe. The pressure drop across a flow secti between…

A: specific gravity of fluid is 0.8

Q: 10. Which device is popularly used for measuring difference of low pressure? a) Inverted U-tube…

A: Fluid mechanics is the discipline of physics that studies the mechanics of fluids (liquids, gases,…

Q: Mercury (5.g. = 13.6) 0.4 ft y Oil B (s.g. = 0.91)

A:

Q: A flow rate measuring device is installed in a horizontal pipe through which water is flowing. A…

A:

Q: As you have seen in lectures (and in Lab 3), the height above the pipe centre to which water rises…

A: Given data in question  Discharge 0.025 m3/s Diameter 20 cm and 15 cm Length 5m To find out  Head…

Q: В A SG= 1.50 Water 30сm 80cm

A:

Q: A mercury Manometer is attached to a pipe having suction pressure. The right limb is open to the…

A: Right limb which is open to atmosphere as per given data : For equilibrium condition a) Difference…

Q: Question Air flows through a duct, and the Pitot-static tube measuring the velocity is attached to a…

A: Given data- Density of air ρ1=1.22 kg/m3, Density of water ρ2=1000 kg/m3, Coefficient of tube…

Q: A 300mm by 150mm venturi meter is installed in a vertical pipeline carrying water as shown in the…

A: Our objective in this numerical challenge is to use the provided data to calculate the discharge…

Q: -oil(sg.30.85) 680 mm 1700mm water

A:

Q: A Prandtl tube (Pitot-static tube with C = 1) is used to measure the velocity of water. The…

A:

Q: A nozzle meter is connected with a pipe line to measure fluid flow rate as shown in Fig. 2. The…

A:

Q: For a U type manometer, a special manometer fluid with a density of 700 ∓ 1 kg/m3 is used. One end…

A: Given The manometer fluid has a density  =700kg/m3 The local atmospheric pressure is pa = 744 mm…

Q: •7-53. Draw the shear and moment diagrams for the beam. 30 lb/ft 180 lb ft B 9 ft- 4.5 ft Prob. 7-53

A: Given data:

Q: Determine the capillary rise (in cm) in a glass tube of radius 0.25 mm that is immersed vertically…

A: Given data : Surface tension (σ)=0.0725 N/mRadius (r)=0.25 mmAssume Angle of contact (θ)=0∘

Q: A fluid of specific gravity 0.8 is flowing in a pipe. The pressure drop across a flow secti between…

A: Given:- Reading of manometer=X=0.5 m Specific gravity of flowing fluid=S= 0.8 Specific gravity of…

Q: Орen Орen Water 4.9 in. 3.3 in. mercury T (SG=13.6) 1.4 in.

A:

Q: Q1 A U-tube manometer is used to measure the pressure of oil of specific gravity 0.85 flowing in a…

A:

Q: In the inclined manometer shown in the figure below, the reservoir is large. Its surface may be…

A: Specific gravity = 0.86Inclined glass tube length = 100θ   = 30°Pressure at A=?

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?