Water at 50oF ( γ = 62.4 lbf/ft3 ; pv = 0.1733 psia) is to pump between open reservoir A and B whose surfaces are at elevations 5910 ft and 6060 ft, respectively (patm = 11.8 psia). The water is to be delivered at 20 cfs through a 24-in diameter pipe of length 2000 ft. Assume pipe friction factor f = 0.03. (a) Find the specific speed of the most suitable pump if the speed of operation is to 600 rpm. (b) If this pump is installed 10 ft above the water surface of reservoir A with suction pipe total length 300 ft will it be safe against cavitation? (c) What maximum elevation above water surface of reservoir A the pump can be installed without pump cavition? Pump NPSHR is 8 ft.

Q: Albert bought a portable device to pump his truck tyres. On the manual, he found out that the device…

A: Given, P1=87KPaP2=3000KPaT1=20°C=293KFAD=0.22m3/minLD=1.3n=1.3N=1500rpm We know…

Q: The heat transfer Q from the steam turbine shown in figure below is 0.085 MW. Determine the power…

A: Given, Total heat loss = Q˙ = 0.085 MW = 85 × 103 W Pressure at inlet = P1 = 20 bar = 2000 kPa…

Q: Grape juice is being pumped at 27ºC from an open tank through a sanitary tube (Di = 0.03561 m) for…

A:

Q: Q1) It is desirable to use the 32-in pump of Figure below at 1170 r/min to pump water at 60°F from…

A: Given data: The friction factor is f=0.00725 The ID of pipe is d=16 in

Q: Albert bought a portable device to pump his truck tyres. On the manual, he found out that the device…

A: Solution : Given data for the above : Delivery Pressure :  30 bar RPM Speed  : 1500 RPM…

Q: 5. Water is pumped at a rate of 6 x 10-4m³/s in a horizontal pipe of 0.04 m diameter and 150 m…

A: Flow rateDaimeter of the pipeLength of the pipePressure drop in the is 150.15 KPaHeight of the…

Q: Siemens manufactures industrial steam turbines for use in various fields of application. One of the…

A: In simple terms, a steam turbine heats water to extremely high temperatures before converting it to…

Q: Q.17 34 °API gas oil at 80 °F is being pumped from a storage tank on the ground to another tank…

A: Given: The API = 34 The temperature, T = 80 F The height of the hill, H = 390 ft The mass flow rate…

Q: →Water is being pumped from a reservoir with water surface elevation of 12 m to another reservoir at…

A:

Q: The jet velocity in a pelton turbine is 70 m/s. The peripheral velocity of the runner is 30 m/s. The…

A:

Q: Francis turbine is used to produce power (Figure below), which has 300 m long penstock pipe of 1.0 m…

A: Given: Length of pen stock pipe L1=300 m Diameter of pen stock pipe d1=1m water level difference…

Q: Water Bows through an adabatic pumping system at a steady fow ate (h) of a kt/ The conditions at the…

A: Given: For compressor, The mass flow rate of water, m = 3 kg/s The inlet pressure, P1 = 90 kPa The…

Q: An air compressor is to compress 50 m^3/min from 19.666 kPa to 598.491 kPa. Assuming condition is…

A:

Q: A Pelton wheel is designed for producing a mechanical output of 12,000 kW while working under a head…

A: Let d=Jet diameter  S.P =Shaft Power =12000KW H =Head =400m N=750rpm g=Acceleration due to gravity…

Q: 09. Water is supplied at 150 ft/s and 60 psi to a hydraulic turbine through a 3-ft inside diameter…

A: The power loss from inlet to exit of turbine is required to be calculated. The power loss is the…

Q: The velocity of water at the inlet and outlet sections of a draft tube are 8 m/s and 2 m/ s…

A: Given:V1=8 m/V2=2 m/shf=0.6 m

Q: 1. Oil with p=876 kg/m3 and p=0.24 kg/m's is released into the atmosphere I with a pressure of 88…

A:

Q: Siemens manufactures industrial steam turbines for use in various fields of application. One of the…

A: A moving fluid pushes a sequence of blades installed on a rotor shaft in a turbine generator, which…

Q: A reaction type hydro-electric plant use a 95% efficiency generator to produce its rated output of…

A: Given data: ηgen=95%Pout=20 MWPloss=2.5 MWH=30 mh=5 m Need to determine the power by the turbine ,…

Q: Albert bought a portable device to pump his truck tyres. On the manual, he found out that the device…

A:

Q: Lukewarm water at 60 °C in a storage tank is being pumped at 300 L/min from the tank. The line from…

A: Water temperature, T=60oCWater flow rate, Q=300 L/min=300*10-360m3/s=0.005 m3/sLength of suction…

Q: review the example. Thank you very much  Question :  Determine the power required (Watts) to drive…

A: Given:Speed of the pump, N=1 rpsDischarge of oil, ρ=850 kg/m3Flow rate, Q=375.3 gpmbore, d=250…

Q: A water is pumped at a rate of 87.87 in3/min through a 0.197-in radius pipe on the main floor of a…

A: Given,  Flow rate of water , Q = 87.87 in3/min =1.4645 in/s Radius of the pipe at inlet, ri =0.197…

Q: A 28-in pump is used to deliver water from a lower reservoir to a higher reservoir . The total…

A: Given:d=10 inL=62 ftf=0.022H=365-0.04718Q2

Q: Albert bought a portable device to pump his truck tyres. On the manual, he found out that the device…

A:

Q: At a hydroelectric plant the difference in elevation between the surfaace of the water at the intake…

A: The objective of the question is to calculate the various efficiencies and power values of a…

Q: Albert bought a portable device to pump his truck tyres. On the manual, he found out that the device…

A:

Q: The net head influence to a Caplan turbine is 45m. the working fluid hits the rotor and the rotor…

A:

Q: A centrifugal pump is being used to deliver 4500 L/s of water at 20°C. The pump head is determined…

A: The volume flow rate of the water, The head of the pump, The efficiency of the pump, For water at…

Q: A pump is used to raise water from open tank to another one. If the pipe diameter is 300 mm, Length…

A:

Q: Q16: Water is being pumped from the bottom of a well 150 ft deep at a rate of 50 gal/min through a…

A: Given: The depth of well, h = 150 ft The flow rate, V = 50 GPM The diameter of the pipe, d = 3.03 in…

Q: a) If the pipe connected to the pump inlet has a diameter of 24 mm with length (LCP) of 5 m and…

A:

Q: Water at 59 F flows through a straight section of a 6-in-ID cast-iron pipe with an average velocity…

A: Given     Velocity, v = 4 fps      Length, L = 120 ft Elevation, z2 = 2 ft Diameter, d = 6 in = 0.5…

Q: PROBLEM 02: Water entering a pump through an 200mm diameter pipe at 27.6 kPa has a flow rate of 0.1…

A:

Q: Albert bought a portable device to pump his truck tyres. On the manual, he found out that the device…

A:

Q: Q1) Find: (a) inlet temperature (T1 =?), (b) mass flow rate of R-134a ((m =?), (c) exit dia meter…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.