Water at 40°C is continuously sprayed into a pipeline carrying 5 tonnes of steam at 5 bar, 300°C per hour. At a section downstream where the pressure is 3 bar, the quality is to be 95%. Find the rate of water spray in kg/h. (Ans. 912.67 kg/h)

Q: Saturated water vapor at 110 ºC enters an adiabatic diffuser at a speed of 220 m/s. At the outlet,…

A: Given: Speed at the inlet to the diffuser→V1=220 m/s Temperature of saturated water vapor→T1=110°C…

Q: Vortex tube simple modeling [1] A vortex tube takes in high-pressure air at 650 kPa and 305 K, and…

A: sub-part (a): To determine the temperature at the cold end, we can use the conservation of energy…

Q: In a variety, water at 1 kg/s flow rate, P1= 5 MPa and T1= 100 °C is mixed with water at 5 kg/s flow…

A:

Q: Air at 20℃, 100 kPa is compressed in a piston/cylinder without any heat transfer to a pressure of…

A:

Q: Number 3

A: To find change in enthalpy

Q: A 0.20 kg/š óf áir are compressed isothermally from P,= 100 kPa and V,= 0.15 m3/s to P,= 700 kPa.…

A:

Q: 4. Complete the table below. Show your solutions and draw the corresponding T-s diagram for each…

A: Pressure (kPa) Temperature (oC) Specific volume (m3/kg) Internal energy (kJ/kg) Enthalpy (kJ/kg)…

Q: 1. Find enthalpy if 5kg of certain gas go through a reversible non flow that has constant pressure…

A: Given Data: Mass of the gas, m=5 Kg The pressure of the gas, P=700 kPa

Q: EXERCISES ON PROPERTIES OF STEAM 3). Ten kg of water 45 °C is heated at a constant pressure of 10…

A:

Q: 8. If 1215 Jof heat was put into the gas during state a-b, how many of those joules went to internal…

A: Given in Question 8: Heat added=1215 J Given in Question 9: mass of water, m=1 kg specific heat of…

Q: Water at 100 °C with a quality of 15% has its temperature raised 20 °C in a constant volume process.…

A:

Q: Find the following: a.Steam temperature in degree celsius b.entropy of steam at the turbine in exit…

A: Given: Power developed by steam turbine: →P=200 MW Temperature of the condenser →Tc=46°C=319.15 K…

Q: 96 kPa and V, = 7.65 mº/min to p, 620 kPa, find th h 1 e change of entropy and the heat for (a)…

A: P1=96kPa P2=620kPa V1=7.65m3/min

Q: Q5. What is the change in enthalpy (in Btu/lb) of carbon dioxide gas if the change in internal…

A:

Q: A rigid tank of 1 m^3 contains nitrogen gas at 600 kPa, 400 K. By mistake, someone lets 0.7 kg flow…

A: Given data: V=1 m3T1=400 KP1=600 kPame=0.7 kgT2=375 K Need to determine the final pressure.

Q: Boiler evaporates 31500 kg / hour of water at a pressure of 165 bar and temperature 350 C and the…

A: Boiler efficiency can be defined as the as the ratio of heat absorbed by the water to increase it's…

Q: A confined volume of 27 moles an ideal gas (with y 1.42) goes through an expansion process so at the…

A:

Q: Steam at 7 bar, dryness fraction 0.96, is throttled-down to 3.5 bar. Solve for the change of entropy…

A:

Q: An electric resistance heater submerged in 4-kg water (T, = 20 °C, C, = 4.18 kJ/kg.K) is turned on…

A: The correct answer is 1.526 kJ/K

Q: Nitrogen (M=28.01 Ib/lbmol) gas flows in a convergent nozzle at 30 psia and 140 (°F) with negligible…

A:

Q: The power requirement of a 3-stage compressor (in kW, two decimal places) in order to supply air at…

A: To Find : The actual power requirement. Given :  The temperature is T=20°C. The discharge is Q=250…

Q: a) Starting with AS-dQr/T, clearly explain all steps - evaluating the integral and finding the…

A:

Q: . Determine the mass flow rate at the inlet and exits, in kg/s. I V₁ = 30 m/s P1 = 5 bar T₁ = 360°C…

A:

Q: Find the specific volume and enthalpy of steam at 7.6 bar when the condition of steam is (1) Wet…

A: Given     Pressure , P = 7.6 bar

Q: 1 1 Helium is compressed through a compressor steadily. At the inlet the pressure is P₁ = 100kPa and…

A:

Q: a) The exit velocity b) The inlet to exit area ratio c) The inlet exit density ratio

A: Given that: Refrigerant R134a is flowing inside the diffuser. The diffuser is adiabatic, hence net…

Q: Helium condenses. 120kpa , 310 k then 700 kpa , 430 k Heat is dissipated with 20 kj/kg . Kinetic…

A:

Q: Air at 15 degree Celsius and 95 kpa enters the diffuser of a jet engine and steadily with a velocity…

A: The given values are- T1=288 K , P1=95 kPa , v1=250ms , A1=0.5 m2, v2≈0Assuming it as a steady flow…

Q: Q.6.A. Oxygen enters a nozzle with a negligible velocity at 440 K and 12 bar, and leaves at 1.9 bar.…

A:

Q: 1 1 Helium is compressed through a compressor steadily. At the inlet the pressure is P₁ = 100kPa and…

A:

Q: Tsource P₁ =W₁ 2 11. Control volume: Turbine To process m, P2, T2, V₂

A: Turbine  The turbine is among the most often utilized pieces of technical equipment today. They are…

Q: Water vapor enters a continuous flow adiabatic turbine at 15 MPa pressure, 500 °C temperature and 90…

A:

Q: Air with a mass flow rate of 600 kg/s is compressed at constant temperature with an initial pressure…

A: Given:P1=720.059 mm of HgP2=4650.382 mm of HgV1=7.65 m3

Q: Calculate the change in the entropies of the system (AS,») and the surroundings (ASur), and the…

A:

Q: Ans. 3908 m’/min. 14.5 Find the cylinder dimensions of a single-cylinder, double-acting compressor…

A: Answer: The dimensions of the cylinder are: D = L = 27.865 cm.

Q: A large tank contains air at 2.84 bar gauge pressure and 24°C temperature. The air flows from the…

A:

Q: A pipeline carries a flow of 77.72 m /min of steam at 1.00 MPa and 20.09°C superheat. Determine the…

A: Volume flow rate of steam, V˙=77.72 m3/minSteam pressure, P=1.00 MPaSteam superheated by,…

Q: 1 Helium is compressed through a compressor steadily. At the inlet the pressure is P₁= 100kPa and…

A:

Q: water at 100 kPa, 30 °C, enters a pump with a flow rate (m) of 18 kg/s with a velocity of 2 m/s. At…

A:

Q: Find the mass in metric tons per day of at -5 °C that would theoretically made in a refrigerating…

A: