Water at 25 oC is pumped at a constant rate of 10 m3 /h from a large reservoir resting on the floor to the open top of an experimental absorption tower. The point of discharge 5 m above the floor, and friction losses in the 1-½-in. Schedule 40 steel pipe from the reservoir to the tower amount to 2.55 J/kg. At what height in the reservoir must the water level be kept if the pump can deliver only 0.1 kW?

Q: A pump delivers water, density =1000kg/m3, at a volume flow rate of 0.004256 m3/sec.  If the head…

A: Given:Water density, ρ=1000 kg/m3Volume flow rate of water, Q=0.004256 m3/secHead developed by the…

Q: 1. Water (p = 1000- kg H = 10-3 flows in a horizontal constant-area pipe; the pipe cross ms section…

A:

Q: 5. A generator produces electricity from a water tank as shown. Determine the electrical output from…

A:

Q: A pump draws 20 m3/h of water having a density of 1000 kg/m3 from the open storage feed tank to an…

A:

Q: Q5. Two tanks A and B of surface areas 600 m2 and 300 m2 are connected by an orifice of 0.18 m2 in…

A:

Q: 1 J A pump is used to circulate a water from lower Tank to upper tank. The height difference between…

A: Given data: The height difference between the free surface is h=5 m The total head losses in the…

Q: 5) The power input of the pump is 10 kW and the friction head loss between A and B is 1.25 m, as…

A:

Q: A water is pumped at a rate of 87.87 in3/min through a 0.197-in radius pipe on the main floor of a…

A: Given,  Flow rate of water , Q = 87.87 in3/min =1.4645 in/s Radius of the pipe at inlet, ri =0.197…

Q: 2500kW power is generated shown below with a water flowrate of 20 m3/s. The head loss for the entire…

A: Given: Power of the turbine is 2500kW. Flow rate of water is 20 m3/s. Head loss in entire flow is…

Q: Water is being pumped (at Q) from a reservoir to a nearby storage facility for a local farm. The…

A: Flowrate (Q): 0.54 m^3/sElevation difference (h): 3.5 mHead from pump (hp): 47.5 mPipe length (L):…

Q: formulae

A: Assumptions i) water flows out to the open atmosphere from the valve outlet. ii) The tank is large…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.