Water at 15°C is drained from a large reservoir using two horizontal plastic pipes connected in series. The first pipe is 20 m long and has a 10-cm diameter, while the second pipe is 35 m long and has a 4-cm diameter. The water level in the reservoir is 18 m above the centerline of the pipe. The pipe entrance is sharp-edged, and the contraction between the two pipes is sudden. Neglecting the effect of the kinetic energy correction factor, determine the discharge rate of water from the reservoir.

Q: Water at 60 deg. F is pumped from a reservoir to the top of a mountain through a 6-in SCH 120 pipe…

A: Given:Water temperature, T=60oFPipe=6 in Schedule 120 Average velocity of water, V=12 ft/sElevation…

Q: A mechanical device pumps the fluid from a depth of 150 m under steady conditions. The density of…

A: Given data  depth=150m  density of fluid=1020 kg/m2  efficiency =70%  velocity of fluid =150m/s…

Q: a cylindrical tank 90 cm high and 60 cm in diameter, open to the atmosphere, initially completely…

A:

Q: A 3-m-high large tank is initially filled with water. The tank water surface is open to the…

A: Given:Initial height of the tank, H=3 mOrifice diameter, d=10 cm=0.1 mLength of the horizontal pipe,…

Q: Two reservoirs are connected with two plastic pipes (mounted in series) of different diameters. The…

A: Diameter of first pipe, DI=20 cm=0.2 mLength of first pipe, LI=200 mDiameter of second pipe, DII=15…

Q: Inside the wall of a house, an L-shaped section of hot-water pipe consists of three parts: a…

A: Given:The height of the elbow is the length of the straight vertical piece is The initial…

Q: A tank 1.5 m stands on a trolly and is full of water. It has an orifice of diameter 0.1 m at 0.3m…

A: Given:h=1.5 md=0.1 mCd=0.6

Q: A garden hose attached with a nozzle is used to fill a 20 Liters bucket. The inner diameter of the…

A:

Q: A reducing elbow is used to deflect water flow at a rate of 14 kg/s in a horizontal pipe upward 30°…

A:

Q: A reducing elbow is used to deflect water flow at a rate of 95 kg/s in a horizontal pipe upward 45°…

A:

Q: In a hydroelectric power plant as shown in the figure, 100 m3/s of water flows froman elevation of…

A: Given Volumetric flow = 100 m3/s Elevation = 130 m Overall efficiency = 0.8 % To find Electric power…

Q: Consider incompressible, frictionless flow of a fluid in a horizontal piping. The pressure and…

A: Given,  P1 = 150 kPa v1 = 1.25 m/s P2 = 140 kPa Density = 700kg/m3 v2 = ? By applying Bernoulli's…

Q: In a pumping system handling water, the level in the suction tank is 3.2m below the pump shaft…

A:

Q: The blades of a wind turbine turn a large shaft at a relatively slow speed. The rotational speed is…

A:

Q: The blades of a wind turbine turn a large shaft a relatively slow speed. The rotational speed s…

A:

Q: Water at 20°C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to…

A:

Q: A fluid flows at 455 cubic meters per minute inside a rectangular duct, whose cross-section has a…

A:

Q: Water at 5°C is drained from a large reservoir using 2 horizontal copper pipes connected in series…

A:

Q: Water flows through a 90 degree elbow connected to a pipe with diameter of 1.5 cm. At inlet pressure…

A:

Q: incd from a large reservoir using two horizontal plastic pipes connected in series. The irst pipe m…

A:

Q: The owners of a smallholding water their vegetable garden using collected rainwater from atank.…

A: Diameter of Tank, b=8 m Diameter of hose, c=7m Height of Tank, a=9 m Height of stand, 6m Length of…

Q: he cylindrical in the figure is filled with 31.4 m3 of water at t = 0. The radius of the tank is 1 m…

A: Given:Radius of tank=r=1mHeight of tank=h=10mNow,area of tank base=A=πr2=π×(1)2=πVolume of…

Q: air pressure above the water is . The required NPSH of the pump is 8.2 m. The suction pipe has a…

A:

Q: A ZA = 5m Control L₁ = 36 m D₁ = 4 cm volume -boundary B ZB=13 m Pump D₂ = 8 cm

A: The power input to pump is..The efficiency of motor  is.. Since you have posted so many parts in one…

Q: Water is flowing through a venturi meter whose diameter is 7 cm at the entrance part and 4 cm at the…

A:

Q: In a pumping system handling water, the surface level of water in the open suction tank is 3m below…

A: Inlet conditions, diameter of pipe=d1= 7.62 cm =0.0762 m discharge =Q= 0.0126 m3/s friction factor =…

Q: Water in a duct of area 0.1 m2 has an average velocity of 7 m/s. The duct tapers slowly to 0.4 m2.…

A: Given data: The area of the duct at section 1 is, A1 = 0.1 m2. The average velocity at section 1…

Q: The tank below is cylindrical and has a vertical axis. Its horizontal cross-sectional area is 10 m2.…

A: Given : The horizontal area of cross section of tank = 10 m2 The specific gravity of gasoline = 0.72…

Q: Three pipes are connected in series with properties given as: for pipe A, L= 300 m, diameter = 15…

A: Given: The length of pipe A, LA = 300 m The diameter of pipe A, dA = 15 cm = 0.15 m The length of…

Q: Consider water flowing through the pipe network shown in the figure below. The flow can be assumed…

A:

Q: Water flows through a horizontal verturi meter whos inlet diameter is 31 cm and throat diameter is…

A:

Q: Water is being pumped from a  reservoir with water surface elevation of 12 m to  another reservoir…

A: Given that, Elevation of water, he=12 m,Elevation of reservoire, hr=69 m,Flow rate of water, Q=25…

Q: Water at 20°C flows through a 11.5-cm-diameter pipe that has a 180° vertical bend, as in the figure.…

A: Calculate the velocity of the water. m˙=ρA1v1W˙g=ρA1v12309.81=1000π40.1152v1v1=2.26 m/s

Q: Water at 20C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to…

A: Given:Water temperature, T=20oCWater flow rate, Q=9 m3/h=93600m3/s=0.0025 m3/sThe point of discharge…

Q: 1. The water in an 8-m-diameter, 3-m-high above-ground swimming pool is to be emptied by unplugging…

A:

Q: A reducing elbow is used to deflect water flow at a rate of 95 kg/s in a horizontal pipe upward 45°…

A: Given: The mass flow rate, m = 95 kg/s The inclination of pipe, θ = 45° The density of water, ρ –…

Q: Water at 60 deg. F is pumped from a reservoir to the top of a mountain through a 6-in SCH 120 pipe…

A: Givend=6in=6×0.0254=0.1524 mV=12 ft/s=12×12=144 in/s=144×0.0254=3.6576…

Q: water is pumped at a rate of 24 cm/s thr puse to a 0.35-cm radius pipe in a solar h ressure in the…

A: given:Q=24cm3/srl=0.50cmrs=0.35cmPS=1.2×105pa

Q: Water is raised from a reservoir up 40 m to a storage tank through a 8 cm diameter pipe. If it is…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.