Q1) A separately excited, 4 pole dc motor has 150 armature conductorsconnected as a wave with armature resistance of 0.15 ohms connecteddirectly to a 120 Volt supply. If the induced EMF of one armature conductoris 1.5 Volt then the current drawing by the motor is?

A separately excited DC motor is a machine in which the field winding and the armature winding are…

Answered: Volt supply. If the induce

Engineering

Electrical Engineering

Volt supply. If the induce

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

25. Write the necessity of power supply and briefly describe different types of SMPS and UPS.
Draw the circuit of a single-phase-to-single-phase cycloconverter that is based on the use of two bi-phase half-wave rectifiers. The input voltage of such a cycloconverter is 220 V, 100 Hz. Draw the waveforms of all thyristor currents and source current of cycloconverter for a resistive load of 10 Ω and for output frequency.
A housing estate is being built and the electrical system for each house from a range of 2 to 20-bedroom houses from single floor apartments to 3 storey buildings are on offer throughout the estate. There are commercial buildings to be constructed for shopping purposes as well. What risks exist and what are the components and methods we use to mitigate these risks both at the substation and at the consumer/ residential side. Describe how these would all fit together.
What does a "matched load" mean?What if it is not compatible (matched)? Explain in detail.
Q11. The power supply unit using IC7815 which dissipate the power through a resistor is 27.5mW. The value of load resistor is 2.1KO, then the input voltage to IC7815 is calculated as, a. 24.663V b. 25.663V C. 22.663V d. 26.663V
Please answer all mcq with brief explanation I will like for all subpart please..
Resistive load of 84.6 MVA is connected to a bus bar with 9.4kV. If the base of 100MVA and 10kV are selected, the load current (in per unit) is: a. 0.7 b. 1.0 C. 0.8 d. 0.9 e. 0.6
7. For certain applications of power supply a power semiconductor switch is required to operate with 400V, 200A load and switching frequency of 100 kHz .The power switching device suitable for this task is: (a) GTO (b) IGBT (c) MOSFT (d) BJT (e) Triac 8. The latching current of an SCR used in a phase-control circuit, comprising an inductive load of R= 10 ohms in series with L= 0.1H, is 10mA.The supply voltage is 325 sin 314 t volts. Obtain the minimum gate pulse width required for reliable triggering of the SCR if it is gated at an angle of 45° in every positive half-cycle. The load current i(t) for the circuit is given by : i(t)=[Vm/√R² + (ot)2] [sin (314t+45°-p) - sin( 45°-p)exp(-Rt/L)] where Vm= 325 V, -314, tan q = 3.14 (ANS: At> 4.35 µS) 9. The gate-cathode junction of the SCR in problem (8) above has a voltage - current characteristic which is a straight line passing through the origin with a gradient of 3000 volts/amp, calculate the minimum required gate source resistance given…