VLAN 10 192.168.10.0/24's default gateway is R1's subinterface G0/1.10. Which two subinterface instructions allow VLAN 10 inter-VLAN routing?* 5. Which Cisco layer 3 (multilayer) switch (S1) commands upgrade a layer 2 interface to layer 3 and allow IPV4 routing?-

Q: 2. Write the necessary commands to configure Inter VLAN communication (Router on a Stick) for the…

A: According to the information given;- We have to write the command to configure Inter VLAN…

Q: Problem 2.1.6 (Calculate network part). An end host has address 192.168.40.3 and netmask /24, please…

A: Given that the netmask is /24, the subnet mask is 255.255.255.0, as there are 24 1's in the subnet…

Q: . Explain how nmap tool can be used by both network administrator and hackers.

A: Nmap(Network mapper) Nmap is a free, open-source tool for vulnerability scanning and network…

Q: Hello, I need help for the expression of the capture filter in wireshark: *Apply a filter so that it…

A: Wireshark is the world's leading and most widely used network protocol analyst. It gives you a low…

Q: What is the subnet mask of 133.49.0.0/23 in the dotted decimal format? How many IP addresses are in…

A: Answer: 255.255.254.0 Explanation: Since /23 is given which means the last 9(32-23) bits of the…

Q: uppose you have been given this classful IP address 130.1.1.8. You want to create a network of 1024…

A: IP address:- An IP address is a single address that can recognize a device or a local network on the…

Q: Within this Wireshark screenshot, what is the value in the upper layer protocol of the IP packet…

A: within this Wireshark the value in the upper layer protocol of the IP packet header is

Q: You want to implement a mechanism that automates the IP configuration, including IP address, subnet…

A: The correct answer is given with explanation and also explaining why other options are not correct…

Q: How many layers make up the Internet Protocol stack? 5 7 8 10 Consider an HTTP client wants to…

A: Q1. Following are the layers in the internet protocol stack: Application layer Transport layer…

Q: DHCP-Server VPCS e0 PC3 Gi 0/0 192.168.1.1/24 GiO/2 Sw-1 GiO/O GiO/3 e0 VPCS PC2 Gi1/1 GiO/1…

A: Given:

Q: Which dynamic addressing method is used for an IPV6 address where devices obtain the necessary…

A: SLAAC is the native IPv6 method used to provide end hosts with IPv6 addresses and default gateway…

Q: Consider the below topology and Implement the given Routing Protocols on the topology using Cisco…

A: Introduction about EIGRP Routing protocol: The Enhanced Interior Gateway Routing Protocol (EIGRP) is…

Q: these two routers in order to establish full network connectivity, but I can't quite figure out how…

A: Here we are going to learn how to connect the devices in order to achieve the full connectivity of a…

Q: Question 2: Answer the questions regarding the given topology. Router A and Router B have 50 PCs and…

A: Actually, given IP address  192.168.10.0/25.

Q: Perform subnetting on the IP prefix 47.1.59.0/24 to divide the network into 6 subnets with at least…

A: in the IP address 47.1.59.0/24, 24 bits are allotted to the Network id part. So, 8 bits are remained…

Q: Router A sends two RIP messages to two intermediate neighbouring routers, B and C. Do the two…

A: Step 1: Routing Information Protocol (RIP) Messages Source and Destination IPs for RIP…

Q: A network of a class C 250.250.220.0 uses a subnet mask with 30 bit of one's - How many subnets…

A: 5.  Number of subnets: Given,   220.220.220.0 Its binary is 11011100.11011100.11011100.11011100 ,…

Q: You are assigned a network address 132.27.120.0/27. You want to create 2 subnets. For each subset,…

A: Given IP address is  IP Address: 132.27.120.0Network Address: 132.27.120.0  With the CIDR notation…

Q: Which Rapid Spanning Tree Protocol port state combines the disabled, blocked, and listening states…

A: Rapid Spanning Tree Protocol(RSTP) have only three port states left that correspond to the three…

Q: onnects to RouterB and a Cluster of two routers Here are the IP addresses: 215.151.210.17 for…

A: Networking is the backbone of modern communication, and understanding how to design and implement a…

Q: From the above scenario, RIP and internal EIGRP routing protocols were configured on the same…

A: As the routers connect to a total of 4 hosts so the network is small, EIGRP is used for medium to…

Q: B4. Given the topology below with IP address 172.9.125.128/25, create an IP plan using VLSM and fill…

A: The answer is given below:-

Q: Which Rapid Spanning Tree Protocol port state is a combination of standard 802.1D STP's disabled,…

A: Rapid Spanning Tree Protocol(RSTP) have only three port states left that correspond to the three…

Q: Consider the below topology and Implement the given Routing Protocols on the topology using Cisco…

A: Introduction about EIGRP Routing protocol: The Enhanced Interior Gateway Routing Protocol (EIGRP) is…

Q: Which of the below statements is not true about Exterior Gateway Protocol? An Exterior Gateway…

A: let us see the answer:- Introduction:- The correct option is d)  i.e. Exterior Gateway Protocols…

Q: Which of the following is the incorrect statement about the Internet Protocol version 4 (IPv4)?…

A: We are given 4 statements about IPv4 and we have to find out which one is not the characteristic of…

Q: QI/The network address of 192.168.1.10/26 provides how many subnets , host in each subnet ,…

A: The address given is a class C address as the first octet is in range 192-223. For a class C…

Q: The host 192.168.2.6 wants to send an IP packet to the host 192.168.3.8.  Please identify the…

A: The question is asking to identify the correct statement(s) about the path an IP packet will take…

Q: What is the upper limit of valid subnets that can be derived from the network 172.22.63.115/19?

A: For seamless communication and the most effective use of resources in the networking environment,…

Q: 3. An unencrypted DNS response packet captured by Wireshark on a DNS client has 3 protocol headers…

A: Given that An unencrypted DNS response packet captured by wireshark on a DNS client packet has 3…

Q: Hello, I need help creating a TCP SYN packet in Scapy. It can have any IP source and destination…

A: The sr() is using for sending a packets from source to destination and receiving from source. This…

Q: The Class C network 210.10.10.0 has been subnetted into 4 subnets. For each subnet (1st, 2nd, 3rd,…

A: Here is the explanation regarding the subnetting the address into 4 parts:

Q: In X.25 protocol, which of the following performs functions such as connection establishment,…

A: The following step provides the correct answer for the given question with an explanation.

Q: want to make a functional imitation of these 2 LANs, however I'm failing to do so when connecting…

A: A network which refers to the one it is any collection of independent computers that exchange…

Q: Q3: If a routing table of a router is depicted by the following table, what is the next hop for a…

A: A routing table is provided for the information.

Q: You are assigned a network address 132.27.120.0/27. You want to create 2 subnets. For each subset,…

A: Given network address: 132.27.120.0/27 So, here network ID (NID)=27, Host ID(HID)=32-27=5.  No of IP…

Q: Subinterface G0/1.10 on R1 must be configured as the default gateway for the VLAN 10 192.168.10.0/24…

A: To route between VLANs, the R1 GigabitEthernet 0/0/1 interface is logically divided into three…

Q: Select correct alternatives: O QUIC is an old protocol designed in the 80's as an alternative to UDP…

A: About QUIC

Q: Question Na What are some of the possible services that a link-layer protocol can offer to the…

A: Answer Explanation: Sure, here are more details on each of the link-layer services: 1. Framing:…

Q: Given the following output, on which interface will a packet destined for 192.168.1.34 /24 be…

A: As we can see, the address is 192.168.1.34 so the start address would be 192.168.1.0 but in given…

Q: A sublayer used for flow control and error control in the Data Link Layer LLC IS-IS CSMA SSL In ,TCP…

A: A sublayer used for flow control and error control in the data link layer :- LLC  Logical Link…