Subinterface G0/1.10 on R1 must be configured as the default gateway for the VLAN 10 192.168.10.0/24 network. Which two commands should be configured on the subinterface to enable inter-VLAN routing for VLAN 10?*

Q: Tom accesses host C with IP address IPC via host B with IP address IPB from host A with IP address…

A: To make sense of the data written out by tcpdump, one needs a good grip on the TCP/IP protocol…

Q: You have been hired as an assistant to the head network administrator in an ISP (Internet service…

A: According to the information given:- We have to define the protocol to use in this scenario to…

Q: QUESTION 1 Which of the following is not true regarding a software defined networking (SDN) based…

A: Answer for all mcqs with explanation given below

Q: Write all commands to configure the next-hop Static IPv6 Routes in router Ibri for adding the remote…

A: 2001:d1e7:b2a7:b2a9:d::/70 2001:d1e7:b2a7:b2a9:d::400::/70 2001:d1e7:b2a7:b2a9:d::800::/70…

Q: A Wireshark trace of TCP traffic between hosts A and B indicated the following segments. A sent a…

A: The state of connection for the host A and B

Q: Question 1     Tom accesses host C with IP address IPC via host B with IP address IPB from host A…

A: Answer tcpdump tcp src IPB and dst IPA and src port 22 and 'tcp[13] & 16 !=0'.

Q: A) For the Figure besides, if the local_ preference for Router RTC is set to 150 and for Router RTD…

A: Solution to the given question: Introduction: Local Preference:    This Attribute is used within…

Q: if host1 send a connection request at t=1 and host2 send a connection request at t=1 in TCP…

A: if host1 send a connection request at t = 1 and host2 send a connection request at t = 11 TCP…

Q: Which dynamic addressing method is used for an IPV6 address where devices obtain the necessary…

A: SLAAC is the native IPv6 method used to provide end hosts with IPv6 addresses and default gateway…

Q: 29. Two routers are deployed on the same LAN and both run OSPF. Which of the following multicast…

A: Direct IP encapsulation of OSPF packets is done with the protocol field set to 89. Depending on the…

Q: /hen host A successful send the datagram to H, switch s1, s2, s3, s4 will have oth host A and Host…

A: NOT TRUE:  When host A successful send the datagram to H, switch s1, s2, s3, s4will have both host A…

Q: Which of the following statements are true about MAC protocols? A. Medium Access Control protocols…

A: Dear student, you have uploaded multiple questions in a single frame. As per our guidelines, experts…

Q: a random access protocol

A: Given :- In the above given question, the statements are mention in the above given question   Need…

Q: In the topology, Laptop 1 (Please assign an IP address from your design) sends a packet to Laptop 3…

A: 1(a) ==> The network topology has been configured using cisco packet tracer. For this…

Q: Router A sends two RIP messages to two intermediate neighbouring routers, B and C. Do the two…

A: Step 1: Routing Information Protocol (RIP) Messages Source and Destination IPs for RIP…

Q: 11. The router which is Joining local areas to backbone area in hierarchical structure of OSPS is…

A: Solution:- 11. Routing devices that belong to more than one area and connect one or more OSPF local…

Q: XYZ has deployed Routing Information Protocol (RIP) as their routing protocol. Recently, a User from…

A: Step 1  The answer is given in the below step

Q: Assume that Host C hosts a Web server that is accessible via port 80. Assume that A and B are the…

A: Introduction: Consider a Web server that supports persistent connections operating on Host C on port…

Q: Based on the following topology, provide the commands for HSRP Configuration for Vlans 10, 20 and…

A: ANSWER:-

Q: Which of the following are true about MAC and IP addresses as a packet/frame goes through 2 routers…

A: In this case, the destination ip address will change each time when the packer enters the router and…

Q: Using the following topology, write the three routers R1, R2 and R3 routing table based on dynamic…

A: By using the following topology ,the three routers R1,R2 and R3 routing table based on dynamic…

Q: Which layer of OSI model is responsible for delivery of the entire message from the source host to…

A: The transport layer is responsible for the process to process delivery of the entire message.…

Q: 15. The following technology allows multiple access using spread-spectrum technology and a different…

A: Spread-Spectrum Technology:Spread-spectrum technology is a method used in wireless communication to…

Q: Given two IPV6 nodes would like to communicate using IPV6 datagram, but they are connected to each…

A: a. Tunneling   Explanation:- To minimize any dependencies during the transition, all the routers in…

Q: 10. Your Arundel office has the network-ID 192.168.1.0 and uses a subnet mask of 255.255.255.0. You…

A: Static Route Configuration Static routes can be set up to guide packets to the desired network. A…

Q: Currently a company is user one router for their computers. They want to separate the network into…

A: In a network, routers are used to connect multiple devices and manage the traffic between them. They…

Q: 2. From the network system shown below. If File server sends a data to the Web server, then answer…

A:

Q: 3. An unencrypted DNS response packet captured by Wireshark on a DNS client has 3 protocol headers…

A: Given that An unencrypted DNS response packet captured by wireshark on a DNS client packet has 3…

Q: Suppose nodes A, B, and C each attach to the same broadcast LAN (through their adapters). If A sends…

A: The MAC layer is denoted as a sublayer of the data link layer that is responsible for data…

Q: Assume all the links in the Internet provide reliable delivery service--select the answer which best…

A: Correct Option 2. IP provides an unreliable delivery service and will discard datagrams for various…

Q: Assign IP for individual router interfaces of following computer network and what will be the…

A: Computer Networks is the set of the computers which are interconnected with the transmission medium…

Q: When you create a VPC. you provide the set of private IP addresses that you want instances in your…

A: When you create a VPC. you provide the set of private IP addresses that you want instances in your…

Q: Which of the following statements is true about routing functions? A router uses network addresses…

A: Routers On computer networks, a router receives and transmits data. Occasionally, network hubs,…

Q: Lonside that there are links that allow hosts to be connected to trunk ports on switches. 1) What…

A: IEEE 802.1Q is a standard for connecting numerous switches and routers as well as establishing VLAN…

Q: What is a characteristic of an IPv4 loopback interface on a Cisco IOS router? O a. It is a logical…

A: A network interface is a physical or logical connection point in a device through which data can be…

Q: Which of the following is NOT true about the Transport Layer?   a. The Transport Layer protocol…

A: Here, Four options are given.

Q: QUESTION 5: Assume the hosts and routers use classless IPv4 addressing scheme. Routing Table for…

A:

Q: The SEU has deployed Routing Information Protocol (RIP) as their routing protocol. Recently, a User…

A: Given:

Transmission Delay

Data is an essential part of network communication. To effectively transmit data through all kinds of networks, it must be streamlined into smaller data packets. Instead of sending a whole file to the other side, these variably-sized packets are sent across the network path to reduce transmission latency. Once they reach their destination, these packets are reconstructed into a complete file. This process is called packet-switching.

Coding Theory

Code is an alternative representation of some information—like a word, image, sound, and so on—that follows a set of rules. While  coding theory may refer to the practice of studying such codes and their applications, in recent years, the term pertains to error-correcting codes.