Vin (t) R₂ www R₁ L₁ Vth(t) For the above circuit, assume the following: Vin(t) = 15cos (2, 500t + 45°)V, R₁ = R₂ = 1k, C₁ = 2μF, L₁ = 0.5H: A) Find the impedance Zc, in (X +jY) form and in units of kn. B) Find the impedance ZR₁ in (X+jY) form and in units of kn. C) Find the impedance ZR₂ in (X +jY) form and in units of kn. D) Find the impedance Z₁₁ in (X + jY) form and in units of kN. E) Find the Thevenin Impedance Zth in (X+jY): and un of ΚΩ. F) Find the Thevenin Voltage Vth in Avth 20th form and in units of [V]4[°].

Q: A certain voltage is +11.1 V for 21.8 ms and -11.1V for the succeeding 21.8 ms and continues…

A: For the first time at , .For the succeeding , .The resistance value is .

Q: A certain regulator has a percent load regulation of 1%. a) What is the unloaded output voltage if…

A: The rectifier is used to convert the AC signal into the DC signal, so the bridge rectifier is AC to…

Q: Draw the output signals of the circuits in the figure

A: Consider the positive half of the signal;When input voltage starts increasing, up to 10V current in…

Q: What is the I total

A: For the given series RLC circuit the value of total current needs to be calculated and the same can…

Q: can you do d and e as well

A: Note: Given solution is not correct.    Given: A circuit, To do:

Q: Is this an L circuit matching box?

A: An image is given as shown-

Q: Draw the output voltage waveform for each circuit in Figure R www 2.2 ΚΩ +30 V Vin OV -30 V 8 D₁ D₂…

A: The problem has been solved as follows

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.