Vertical load is applied to point B of a 10 mm radius cylindrical bar as shown in the figure. Calculate the shear stress occurring in the point.

Q: A compression load of P = 55 kips is applied to a 3 in. by 3 in. square post, as shown. Determine…

A:

Q: TOP The assembly shown has pin support at E and roller support at V. A steel rod is connected at M…

A:

Q: O MPa and an axial stress of 325 MPa that act on an element imposes a bending stress of 250 MPa and…

A: Tangential stress is .Axial stress is .Bending stress is .Torsional stress is .

Q: A single-piece bicycle crank is shown below under the following load: the rider pedals forward with…

A:

Q: The solid shaft shown in the figure below is fixed at one end and has a lever at the other. The…

A: Given data, Applied force, F = 840 N Distance, b = 110 mm Shear stress induced at point A on the…

Q: A rigid plate (AC) is connected to flat steel bars by pins at A and B. The horizontal flat steel bar…

A: A rigid plate (AC) is connected to flat steel bars by pins at A and B. The horizontal flat steel bar…

Q: The member has a square cross section and is subjected to a resultant internal bending moment of…

A: Given data  Moment= 820N.m  Angle = 30° Find the stress at corner A,B,D and E

Q: Q1 The machine element shown in the figure below is fixed supported at point B and has an applied…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.