Venturimeter is installed in a pipe of diameter 40 mm. If the throat diameter of venturimeter is 20 mm and the pressure difference between the pipe and throat section is found to be 120 kPa. Then neglecting the frictional losses, the water velocity in main pipe is (m/s)

Q: please explain how to get the friction factor

A: The objective of the question is to calculate the friction factor, the power supplied to the pump,…

Q: The diameters D & d piped, Venturi- meter like horizontal water flow sistem seen in the drawing is…

A:

Q: A water discharge of 8 m3 s is to flow through this horizontal pipe, which is 1 m in diameter. If…

A: Given Data⇒ Discharge Q=8m3s Horizontal Pipe Diameter of pipe(d)=1 m   Assumptions made in…

Q: Water at 59 F flows through a straight section of a 6-in-ID cast-iron pipe with an average velocity…

A: Given dataT=59FV=4 ft/sg=32.2 lb.ft/s2ρ=62.3 lb/ft3y1-y2=2ft

Q: A centrifugal pump delivers 1.27 m' of water per 1200 r.p.m. The impeller diameter is 350 mm and…

A:

Q: Q-3, B.: A Pitot static probe is mounted in a 25 em inner diameter pipe at a location where the…

A: Step 1: To calculate the volume flow rate through the pipe using the Pitot static probe…

Q: 5. The large tank shown in the figure is filled with water to a height of ho. Water exits the 5-cm-…

A: Step 1: Step 2: Step 3: Step 4:

Q: What is the velocity of the pipe center (m/s)? Given that h3%-88.3 cm h3 h2 =7 cm h =3 cm] Water

A: hps=88.3+7hps=95.3 cm or 0.953 mhp=7 cm or 0.07 m apply bernoulli's equation between 1 and…

Q: Air flows through the 8 cm diameter pipe in the figure at 1 atm 20 oC conditions. The manometric…

A:

Q: Problem 3 Water is issued steadily from a pipe to the air with a diffuser as shown below. Gravity…

A: From continuity equation, volume flow rate is,Here  is cross-sectional area of the long pipe,  is…

Q: Oil (Density = 860kg/m³, Dynamic viscosity = 0.002 Pa.s) flows through a pipe of 100mm diameter with…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.