v (ft/s) 80 -4r + 80 20 r(s)

Q: 2. If a flea can jump straight up to a height of 0.440 m, (a) what is its initial speed as it leaves…

A: It is given that, the flea can jump a height of h=0.440 m It is required to find: a) the initial…

Q: A motion detector is mounted on the floor, pointing straight up. A baseball is held 8 feet above the…

A:

Q: ver drops a tennis ball from a certain height above a concrete floor. The ball's tion from the…

A:

Q: In the graph below, there are two columns of dots. Pick two dots (one from the left column, and one…

A: Answer: D. 1.667 m/s Given: X vs t graph is given. The time t  = 1.2 s.

Q: In an experiment two identical rocks are simultaneously thrown from the edge of a cliff a distance…

A:

Q: Construct a graph of instantaneous velocity versus time for a motion with variable acceleration.…

A:

Q: Ironman steps from the top of a tall building. He falls freely from rest to the ground a distance of…

A: Concept: According to the hint given, Using the kinematic equation we will determine the velocity of…

Q: A bicycle moves according to the velocity-versus-time graph shown in the figure. (The vertical axis…

A: Displacement is given by the area of the velocity - time graph   a) XA = area of triangle in the…

Q: A softball is popped up vertically from the ground with a velocity of 21.56 m/s. The acceleration…

A: Write the given values with suitable variables. u=21.56 m/sa=-9.8 m/s2 Here, u and a are the initial…

Q: A particle travels in a linear path A-B-C. It start from rest at A and reaches B after 2 s. The…

A: Apply the second kinematic equation from A to B to calculate the distance traveled in path AB.…

Q: (a) Find the average velocity in the time interval t-3.00 s to t-8.00 s. m/s (b) Determine the…

A: The position time graph for particles moving along the x axis is shown on the graph.The division…

Q: Suppose that the position of a particle is given by s = f(t) = 2t³ + 6t + 9. (a) Find the velocity…

A:

Q: A pebble is dropped from rest from the top of a cliff. It takes Δt = 3.7 s for it to reach the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Here we go again this time, d = 2.27 m. Suppose the block starts on the track at x = 0. What minimum…

A:

Q: Please show the solution A race car starts from rest and travels east along a straight and level…

A: Given, t=5 s  vx(t) = (0.86 m/s3)t2 (dvx(t)/dt)=2*(0.86 m/s3)t At t= 5 s (dvx(t)/dt)=2*(0.86 m/s3)*5…

Q: Suppose an object starts at time t=0 at a position defined as x=0 m. At t =.5 s the object is at…

A: The average velocity for first interval is,

Q: Here we go again this time, d = 2.98 m. Suppose the block starts on the track at x = 0. What minimum…

A: The initial velocity of the block is determined by the below equation where the free-body force…

Q: An astronaut on the Moon (g=1.62 m/s2) throws a rock from the ground level with a speed of 32.1 km/h…

A:

Q: Consider a grey squirrel falling from a tree to the ground. Use a coordinate system in which…

A: The squirrel starts its fall from a height of 1.3 m above the ground. This squirrel falls under the…

Q: Sketch position and velocity graphs that describe each of the following particles: (a) A particle…

A: (a) Within the initial graph, the particle starts from a positive position. As it possesses neither…

Q: Position, Velocity, and Acceleration 1. A position-time graph for a particle moving along the x axis…

A: (a) t1=1.50st2=4sx1=8mx2=2maverage velocity=x2-x1t2-t1=2-84-1.5=-2.4m/s

Q: On average, froghopper insects have a mass of 11.3 mg and jump to a height of 423 mm. The takeoff…

A: Given: Mass of the insect is m = 11.3 mg = 0.0000113 kg. Maximum height is H = 423 mm = 0.423 m.…

Q: The graph depicts an particle's velocity (in the x-direction) vs. time. At which points is the…

A: The acceleration in a velocity time graph is represented as the slope of the graph at that point.

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.