using the superposition theorem determine * the current through the 12 ohm resistor R1 24 2 2=? 40 E, 54 V R2 12 N E 48 V 1.62 A 3.5 O 2.67 A

Q: In the following circuit, Vs = 35. What is the voltage across R3? —— Vs R1 ΣΚΩ R2 ·1ΚΩ R3 www 1ΚΩ

A:

Q: Find 11, 12 and 13 currents. 302 10 V

A: The given circuit diagram is shown below,

Q: Use superposition to determine the current through the 5 kn. I (+1 V1 30V R1 10k R2 5k I1 3m

A: The current flowing through the 5k ohm resistor is I=4mamps.Explanation:Step 1:SUPERPOSITION…

Q: What is the total resistance of the following circuit, looking from the two terminals of the voltage…

A:

Q: Determine using the superposition theorem the current in 4Ω resistance between points AB as seen in…

A: The superposition theorem state that the sum of response of individual sources acting alone is equal…

Q: 6. Find the currents through, the voltages across, and the power dissipated by all the resistors. R5…

A:

Q: DEVICE |RESISTOR R1 1.0 k Q R3 560 n R2 3.9 k 2 R3 560 2 TOTAL R1 1.0K n 25V R2 3.9Kn

A: Calculating total resistor All the three resistors are in parallel

Q: R1 R3 3 Ix R2 W2V 6V O 3.6 V O 7V 0.3831 V O 2.4 V

A: Please refer the attached images for the complete answer..

Q: Find the current i across the 30 resistor. 2A 60 i O 7/3 O 2 O 14/3 O 4/3 O 2/3

A:

Q: 11t a tilt Vs 10V R1 4ohm R5 www 6ohm ww R2 8ohm b R3 12ohm www R4 3ohm

A: Given an electrical circuitasked to find the total resistance of the circuit

Q: 1 R, 3.5 ΚΩ 28.5 V Ig R3 3 ΚΩ R₁₂ 2 ΚΩ 24 V 12

A:

Q: SV 8A 2V P₂ P1 P3 3 A I=5A 0.61 PA + 3 V

A: The given circuit diagram is shown below,

Q: Is R2 R. 15V 2k 2k 1k

A:

Q: On the circuit of problem 12. What is the current flow across the resistor R2 86.32 ma 34.51 ma O…

A:

Q: 2 From the following bridge, you will calculate R11 to balance the circuit and the value between ab…

A: it is asked to find the value of resistor R11 which makes the bridge balanced

Q: EIS 100 mA .E1 5) For the following network, determine the value of R2 E1 12 V R1 4kQ El R1 2kQ E3.…

A:

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.