Using E=203,000MPa, calculate the actual maximum deflection of 90mm composite slab, with a steel deck thickness of t=1.21mm if the live load is 2.4kPa. The span of the deck is 2000mm. Provide the numerical answer in mm to three significant figures (you do not need to enter the units in your answer.

Q: A prestressed beam is given in the figure below. X Aps = 696 mm2 H = 540 mm B = 350 mm y = 90 mm L =…

A: Area of steel, Aps=861 mm2 H=560 mm B=350 mm y=110 mm Initial pre-stress, fps=1208 MPa

Q: When solving the problems for Section 1.6, assume that the material behaves linearly elastically.…

A: Given data in question  Diameter  Elasticity modulus  Poissons ratio  To find out  Largest force P

Q: 14x22 beam is subjected to a moment of 55 ft-kips. What is the bending stress in th pe your…

A:

Q: A composite beam is comprised of polymer matrix and fibre reinforcement. The composite beam is…

A: L = 800 mm a = 70 mmw = 15 N/mm = 1 mmEm = 9 GPa or 9000 MPaEf = 72 GPa or 72000 MPa

Q: A beam section is shown in the figure below is a simply supported over a span of 15m. The beam is…

A: Given:- The length of the beam = 15 m  The beam is reinforced with straight tendons The compressive…

Q: f) the maximum bending moment in the beam. Enter your answer in kNm to 3 decimal places.

A: Given figure is a simply supported beam. Point load = 3.3 kN, acting at the midspan. Total span…

Q: Distinguish between the initial tangent modulus, the secant modulus, and the actual modulus.…

A: 1) Initial tangent modulus: It is slope obtained by drawing a tangent to the stress−strain curve at…

Q: Assuming elastic behavior, why does the maximum shear stress always correspond to the neutral axis…

A: Given data:

Q: Problem 2 A simply supported timber beam has a span of 6 m long and carries a uniformly distributed…

A: Calculate the maximum shear force in the beam.Maximum shear force = 1/2 * Total loadTotal load = 28…

Q: 12. Assume a uniformly load simply support beam with a rectangular cross section. The width of the…

A: Given Data: The width of the both the beams (aluminum and steel) is b. The depth of the aluminum…

Q: AW14x22 beam is subjected to a moment of 99 ft-kips. What is the bending stress in the beam in psi?…

A: Given data - Section W14×22Moment = 99 kips- ft Find out - Bending stress in beam ?

Q: Q-2: Estimate short-term and long-term deflections for simply supported beam shown in Figure below,…

A: Modulus of elasticity(E)=26 kN/mm2,Yield strength(fy)=460 kN/mm2,Dead load(DL)=10 kN/m,Live…

Q: determine the modular ratio n. Enter your answer to 4 decimal places.

A:

Beams

In structural engineering, a beam is a component made of a variety of materials (including steel alloys, and wood) that can resist loads applied laterally to the beam axis. Members, elements, rafters, shafts, and purlins are all terms used to describe beams.