Using 10-m scales, interpolate contours analytically and plot the contours following the 5-m contour interval. POINT 1 2 3 4 A 878.8 882.5 883.5 883.6 B 883.2 885.9 893.7 887.2 C 882.8 888.6 891.8 889.3 D 883.5 890.4 892.6 889.5 E 886.2 888.5 892.8 893.5 A. Show the computation for the horizontal distance of contours in the 10-m distance per grid. B. Show the plot of the contour in your solution. Put all answers in your solution.

Q: On a map drawn to a scale of 1:2200, contour lines are 0.5 inches apart at a center location. The…

A: The scale of the map = 1:2200The spacing between the contour lines= 0.5 inchesThe contour intervals…

Q: what is the meaning of cohesion

A: Cohesion is nothing but attractive forces in molecules between the same substances Cohesion is…

Q: INTERPOLATING CONTOURS ANALYTICALLY. Using a suitable scale, plot a rectangular area 5435 m (length…

A: Introduction- The practice of spacing contours proportionally between plotted ground locations…

Q: Using 10-m scales, interpolate contours analytically and plot the contours following the 5-m contour…

A: Contour Diagram A contour diagram is the plan drawing of an area which indicates the levels of area.…

Q: Draw contours for the following data using the grid method. The following data of a piece of land…

A:

Coordinate Geometry of Survey

Coordinate geometry (COGO) is a method of inserting surveying or engineering data into geographic information system (GIS), computer-aided design (CAD), or mapping software. These data can be collected on the proposed construction site using standard surveying techniques and instrumentation or may be taken from existing maps, engineering plans, drawings, or records. Data gathered on the site includes coordinates of points, bearings, and distances between points. The data are noticed and noted through conventional surveying procedures, like a traverse or layout measurement series and it can be either digital or non-digital. The maps and plans are inclusive of boundaries, divisions, and other components, and these features are shown with coordinate values, the lengths, offset distance, and bearings between them.