Use the D'Arsonval ammeter shown. a. Calculate the value of the shunt resistor, RA, to give a full-scale current reading of 5 A. Answer in milli-ohms.  .b. How much resistance is added to a circuit when the 5 A ammeter in part (a) is inserted to measure current? Answer in milli-ohms. c. Calculate the value of the shunt resistor, RA, to give a full-scale current reading of 100 mA. Answer in ohms.  d. How much resistance is added to a circuit when the 100 mA ammeter in part (c) is inserted to measure current

Q: What is the equivalent of 1 Farad into ratio?

A: This question belongs to circuit theory . It is based on the concept of relation among capacitor ,…

Q: The diode starts to conduct when the voltage across it is 0.6 V. Vin is a variable DC voltage…

A: To find the input voltage at which diode starts to conduct

Q: 3. WHAT IS THE RESISTANCE AND WHICH COLOR CODES ARE GREE (VALUE 10%) 4.DETERMINE THE RESISTANCE O…

A: The solution is given below

Q: Q1.Three-phase half-wave controlled rectifier is shown in the figure below.Delivers 250W power with…

A:

Q: Design a multirange d.c. milliammeter with a basic meter having a resistance 75 ohm and full scale…

A:

Q: D3 D1 V1 sine R1 1 kHz D2 D4 Given: • V1 = 5.9 Vrms • R1 = 7 kOhm • Diode voltage = 0.9 V What is…

A:

Q: the voltage that would be developed across a 50 ohm load connected to the terminals of a battery…

A: In this question we will find load voltage. .

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.