Use benzene as calibrating liquid. (ŋbenzene = 0.6516 cP) Use 4 decimal places. Room Temp: 20°C. answer 7 and 8

Q: Average morality of NaOH= Dillo M+ 0,1|3 M + 0.1124 M 0.3354M 3. EO.112 M

A: Precision is the degree of closeness between the various experminental data obtained. Precision can…

Q: P*V (kPa*mL) pente (Ay/Ax) Volume (mL) 1/Pression (kPa^-1) Pression ( kPa ) 0.010343123 96.6826…

A: Percent error is the difference between the expected value and the actual value as compared to the…

Q: onde Weighed mass of NaCl Purity of NaCl Molar concentration of NaCl using weighed mass and purity 2…

A: Concentration of solution refers to amount of solute present in a given amount of solution or…

Q: Trial 1 0.063g 1. Mass of Mg consumed, g 2. Moles of Mg consumed, n Oml 3. Initial eudiometer…

A: Moles of Mg consumed Mass of Mg consumedAtomic mass of Mg=0.063 g24.3 g/mol=0.00259 mol

Q: | 2. (To make 100mL of 50mM CaCl₂, weigh ANSWER (include unit) of CaCl₂, place in a graduated…

A: Given questions belongs to preparation of solutions and stoichiometry.  “Since you have posted…

Q: b. Identify the unknown compound from the 3 possible choices in the table below. The physical…

A: The unknown compound is acetic acid.

Q: Dimensional Analysis Worksheet 1. 261 J kJ 2. 3.0 x 1022 molecules mol 3. 9,474 mm cm

A:

Q: 0.200 molH3C6H5O7 LH₂C6H₂O7 0.200 mol H₂CH₂O7 LH₂CH₂O7 X 25.0 L H₂C,H,O, 1000 25.0 1000 A solution…

A: 25.0 mL of 0.200 M citric acid H3C6H5O7 is titrated with 0.750 M NaOH solution to reach the third…

Q: O= 0.24 xu? > D.24 x10-16 KT 3. 人2 JE OP -23 = 1.381 *10 P= 1D/325 pa 23 d= (Vz) (0-24x10 18nt)…

A:

Q: Table 5.1. Determination of the purity of KHP sample. Parameter Trial 1 Trial 2 weight of container…

A:

Q: A 5.00 (±0.01) mL5.00 (±0.01) mL Class A transfer pipet is used to transfer 5.00 mL5.00 mL of a…

A:

Q: Q1: Use the data in the table to answer the questions: Solute separation Solvent separation…

A: This question has two parts : (a) Calculation of total change in energy (∆ETotal) . (b)…

Q: Benzoic acid is an organic acid with a K₂ = 6.47 x 10-5 at 25.0°C. Calculate the pK₂ of benzoic acid…

A: The value of dissociation constant for benzoic acid =The value of for benzoic acid = ?

Q: Trial 1 Trial 2 Trial 3 Temperature of Water (°C) 27 27 27 Mass of empty flask + stopper (g)…

A: Density is defined as the mass of substance upon the volume.

Q: Given x(t) = (1.58 m/s²) t² - (4.1 m/s) t %3D What is the average acceleration in m/s? at t = 1.95 s…

A: d2x/dt2  is called acceleration

Q: In 1-2 sentences identify the dependent variable(s) and explain the trend we observe.

A: Rise in temperature and concentration of CO2 in ppm are dependent variables.

Q: From Experiment Correct Value % error AHdissolving |(kJ/mol) -24

A:

Q: QUESTION 4 For the following expressions, how many significant figures will the answers have: a)…

A: According to bartleby guidelines I need to solve only first three subparts of the given question. If…

Q: Freezing point of mixture (from graph 2) Freezing point of naphthalene (from graph 1) Change in…

A: To plot the temperature time graph for the naphthalene and the mixture from the given data and find…

Q: joules needed to melt 20.0 g of ice at 0°C and to warm the liquid to 65.0°C Express your answer to…

A: 1st) Calculate moles 2nd ) Calculate energy for phase change process3rd) Calculate energy for…

Q: 1-38. To entertain children between the ages of 2 and 90, I enjoy popping corks from bottles…

A: (a) The formula mass of acetic acid and sodium bicarbonate is

Q: Price the following prescription using Percentage Mark-Up plus Minimum Fee for the first…

A: The objective of this question is to analyze the pricing for the given prescriptions using these…

Q: A tank with 43.2 kg of water is leaking at a rate of 0.0135 kg/s. How many hours will it take until…

A:

Q: ), answer the following questions a) With reference to the Pb-Sn phase diagram for a 25wt% Pb-75wt%…

A: The given composition is not an eutectic composition, so there will be formation of proeutectoid…

Q: Evaluate the following expressions. Impose the rules for significant figures different ways for the…

A: Significant figures of value determine the precision and accuracy of a calculation. When expressing…

Q: 1) Question: It is desired to prepare 1 liter of sulfuric acid solution in 6 norms. How many ml of…

A: Given: The mass percentage of H2SO4 is 98%. The normality of 1 liter of sulfuric acid solution is 6…

Q: Q4 A pump delivers the following volume of a solution over 4 h. Volume (mL) | Time (h) 50 1.0 100…

A: The volume v/s time data given is,

Q: Compounds Time (s) Mean Density (g/mL) Mean Time (s) Density Trial 1 Trial 2 Trial 1 Trial 2 Benzene…

A:

Q: 1. You have measured the response for a set of 4 method blanks for your method used to measure…

A: The objective of the question is to determine the followingThe lowest detectable concentration for…

Q: Determine the value of the slope (m), y-intercept (b), and the coefficient of determination (r²) A)…

A:

Q: Two aqueous hydrogen bromide solutions containing 1.00 wt% HBr (SG=1.0041) and 60.0 wt% HBr…

A: Given Two aqueous hydrogen bromide solutions containing 1.00 wt% HBr (SG=1.0041) and 60.0 wt% HBr…

Q: Taking into account that dH = TdS + Vdp,what is true about temperature? A) T = (p/S)VB) T =…

A: Given:

Q: Consider the four (4) K vs. T plots below, identified as "A," "B," "C," and "D." Select the plot(s)…

A: 4 Kc v/s t plots are give and we have to find which plot is ideal for a thermochromic thermometer.

Q: Chemistry Question

A: (a) The freezing and boiling point of water in Fahrenheit scale is 320 F and 2120 F. The freezing…

Q: T (°C) -8    2       12        22      32      42      52      62 V (Liters)  1.60  4.84  8.10…

A: A question based on graph, which is to be accomplished.

Q: Carbon dioxide gas is placed inside container A. Hydrogen gas is placed inside container B. Both…

A: Option D is Correct Answer. Both containers will have same number of particles in them

Q: Bonus: An aerosol can contains gases under a pressure of 4.50 atm at 20.0 degrees Celsius. If the…

A: Given :- Initial pressure of gases = 4.50 atm  Initial temperature = 20.0 °C = (273 + 20)K = 293 K…

Q: 1. The concentration of sulfur dioxide is 8,800µg/scm. Convert this value to a) ppmv and bug/acm at…

A:

Q: 14. You are calibrating a buret that is graduated to 0.1 mL. The measured volume delivered is 25.31…

A: Burette correction is the quantity that must be added algebraically to a particular buret reading to…

Q: Compounds Time (s) Mean Density (g/mL) Mean Time (s) Density Trial 1 Trial 2 Trial 1 Trial 2 Benzene…

A:

Q: Balance each of the following neutralization reactions.

A:

Q: The data below was collected using the procedure described in your lab notebook: Mass (before…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: [References] One beaker contains 224 g of water at 23 °C, and a second beaker contains 87.0 g of…

A: When the two water samples of different temperatures are mixed, the heat flow takes place from the…

Q: please help me. double and triple check your answers, previous tutors got it wrong. this is  a…

A: The mole fraction of B5H11 is calculated as,

Q: Trial 1 2 3 S Final Volume Reading NAOH (ml) 36.65 38.23 35.80 Initial Volume Reading NaOH (ml) Net…

A: Standardization of sodium hydroxide

Q: I need help on the percent difference !!

A: In the given question we have to calculate volume of water and Percent difference for 50 mL…

Analytical Tools

Analytical tools or analysis tools help one to get into a conclusion or results from the data collected. Analytical tools can be applied for simple data sets and also in the case of big data analytics.