Under a torsional test for Brass, having a radius of 2.5 mm and a gage length of 72.6 mm, what is the modulus of rigidity knowing that when the specimen at the elastic zone experience a torque of 10 N.m, the angle of twist was 30 degrees? [assume the curve in elastic zone is a straight line passing by the origin] Select one: O a. 394.4 MPa O b. 22.597 GPa c. 79.2 GPa O d. 22597 kPa

Under a torsional test for Brass, having a radius of 2.5 mm and a gage length of 72.6 mm, what is the modulus of rigidity knowing that when the specimen at the elastic zone experience a torque of 10 N.m, the angle of twist was 30 degrees? [assume the curve in elastic zone is a straight line passing by the origin] Select one: O a. 394.4 MPa O b. 22.597 GPa c. 79.2 GPa O d. 22597 kPa

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

2. An implant is made of a titanium alloy having an allowable shear stress of tallow = 50 MPa. If the diameter of the implant is 120 mm, determine the maximum torque T that can be transmitted. What would be the maximum torque T' if an 80-mm-diameter hole were bored through the implant? 1S T (Answer: T =16.96 kN.m; T'=13.613 kN.m)
H please
The brass has a shear modulus (G) of 40 GPa. In the torsion test calculated results, (G) was found to be 37 830 MPa. What is the percentage of errors in the experiment? Select one: a. 0.54% O b. 5.425% c. 0.05425% O d. 3.779%
In a tensile test for an aluminum alloy, the sample is 2 inches long and 0.5 inches in diameter. The proportional portion of the tension stress-strain diagram for an aluminum alloy is shown below. Determine the axial stress of the sample under a tensile load of 9 kips: ____ ksi. Pay attention to units and calculate your answer to 1 decimal place.
ELECTRICAL ENGINNERING THANK YOU SO MUCH
40. A tensile test specimen has a gage length 2.0 in and diameter 0.875 in. Yielding occurs at a load of 35,500 lb. The corresponding gage length 2.0113 in (neglect the 0.2 percent yield point). The maximum load of 45,000 lb is reached at a gage length 2.543 in. If the specimen necked down to a diameter 0.765 in, determine the percent reduction in area (round to the nearest whole %)
Question 3 3. A string 4 mm in diameter has original length 2 m. A force of 200 N. pulls the string. If the final length of the spring is 2.02 m, determine: (a) stress (b) strain (c) Young's modulus.
A square cross-section v-notched specimen of height 75 mm has each side of 14 mm has been selected to perform Charpy impact test. A v-notch of thickness 1.75 mm is made at the middle of the specimen length. Determine the cross-sectional area at notch. Cross-sectional area at notch (in mm2)