Answered: u are dealing with a vertical walled…

u are dealing with a vertical walled reservoir having a surface area of 500,000 m² and that an inflow of 1.0 m²/sec occurs. How many hours will it take to raise the reservoir level by 30 cm?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A hydraulic jump at the base of a spillway of a dam is such that the depth upstream and downstream…

A: As per authoring guidelines, if the question number is not specified, the first question or three…

Q: A horizontal, frictionless channel of circular cross-section and diameter equal to 5 feet flows at a…

A: Diameter = 5 ftDepth = 3ftVelocity = 2 ft/sFind:Maximum upward step height (max ) that this flow…

Q: = 3.7.9. The water surface elevation difference between two reservoirs 2,000 m apart is 26 m.…

Q: 3 wells are sunk in a confined aquifer in a straight line at 25 m intervals. If one end well is…

Q: A pipe of 324 mm diameter, having friction factor as 0.04, connects two reservoirs with 15 m…

A: given- diameter of pipe d=324 mmfriction factor f=0.04L=1500 m

Q: A pipe of 324 mm diameter, having friction factor as 0.04, connects two reservoirs with 15 m…

Q: A well is constructed to pump water from a confined aquifer. Two observation wells, MW1 and MW2, are…

Q: Neglect the weight of the drum in the following problem. A sealed cylindrical drum has a diameter of…

A: The volume, mass and density is corelated with one another, V=MD here, volume is V, mass is M and…

Q: 4.49. If 100 m³/s of water flows in a channel 8 m wide at a depth of 0.9 m, calculate the downstream…

Q: A cylindrical well is 2m in diameter and 12 m deep. If there is 3m of water in the bottom of the…

A: Given that, the diameter of the cylindrical well, D=2m Depth of the cylindrical well, H=12 m water…

Q: If 150 L/s of water flows through the system shown in the figure below, calculate the pressure at 2.…

A: For the point 1 - P1 = 0, V1 = 0, Z1 = 35m For the point 2 - Z2 = 0

Q: Water discharging into a 10 m wide rectangular horizontal channel from a sluice gate is observed to…

Q: (1-0.98) Q.53 The working life of dam built to store irrigation requirement is expected to be 100…

A: Given data: The working life of dam built to store irrigation requirement is expected to n = 100…

Q: A well is constructed to pump water from a confined aquifer. Two observation wells, MW1 and MW2, are…

Q: A rectangular canal is 2.5 meters wide. The flow rate via the canal is 378 m/s, with a 3.3 cubic m/s…

A: Given data 2.5 m wide canal Velocity of flu is equal to 378 m per second Discharge is equal to 3.3…

Q: A cylindrical vessel with a height of 4.1m and diameter 2.1m has an orifice located at the bottom…

Q: A hydraulic jump is formed in a 2 m wide rectangular channel carrying water at a flow velocity of 16…

Q: H.W. 1: It is required to dewater a construction site, The bottom of the construction will be Im…

A: Given data:- Transmissivity( T )=800 m2 /day t0=15 days r=60m

Q: An open canal of rectangular cross-section with horizontal base and vertical sides is built through…

A: Given data: Calculate hydraulic radius:

Q: An 18-inch-diameter (~46 cm) well within an aquifer with a transmissivity of 1070 ft2/day (~100…

A: Using relation:S=Q4πTln2.25Ttr2ss=20ftT=1070ft2d

Q: A reservoir 10m deep has a rectangular weir with a length of 2.5m situated at its short side. When…

Q: Design the pipe that will connect two reservoirs for a water distribution system of a certain sitio.…

A: Given = length of pipe = 2500 mtr Difference between elevation= 50 mtr

Q: If the designed dam is 12m height. what would be the bottom width of the dam?

A: For a Gravity Dam, B = HSc-C, whereB = base width of damH = height of damSc =Specific Gravity of…

Q: Two-year inflow values of a reservoir are given below. Determine the capacity of the reservoir using…

A: Capacity of reservoir is 26.6

Q: 2. Compute the constant draft from a 500 ha reservoir for a thirty (30) day period during which the…

Q: Duration: 110 dk. (30p): Water demand of a city with 10.000 population is supplied from a well…

Q: A conical tank with an upper radius of 4 m and a height of 5 m drains into a cylindrical tank with a…

A: Solution: Given Data: upper radius=4 mcylindrical tank radius=4 mheight=5 m

Q: ,. A 20 cm well completely penetrates an unconfined aquifer with k= 1 m/sec and the height of water…

A: Calculation of drawdown at distance 200 m from well when k= 1 m/sec and well yields at 0.5 m3/s

Q: A well fully penetrates a 60m thick confined aquifer. After a long period of pumping at a constant…

Q: A cylindrical vessel with a height of 4.3m and diameter 2.9m has an orifice located at the bottom…

Q: An open canal of rectangular cross-section with horizontal base and vertical sides is built through…

A: Given data: Slope of the bed (S) = 1 in 845 Depth of canal (d) = 6.5 m Width of canal (b) = 8 m

Q: The dam shown in the diagram at the right is constructed of a homogeneous clay material with a…

A: Given Hydraulic conductivity= 1×10-6 m/s

Q: Due to very tight space constraints and specific material requirements, an engineer has designed a…

Q: Determine the time it would take to lower the level of water from 3 m to 2 m in a reservoir of area…

A: Given: Initial height, H1 = 3 m Final height, H2 = 2 m Area of reservoir, A = 80 m x 80 m Length of…

Q: An aquifer having a cross sectional area of 100* 25 m2 has a pressure gradient of 25 cm between two…

A: Answer To determine the quantity of water flowing between these two points in a day we can use…

Q: A reservoir 15m deep has a rectangular weir with a length of 1.8m situated at its short side. When…

Q: Determine the time it would take to lower the level of water from 3 m to 2 m in a reservoir of area…

A: Discharge over a rectangle Notch- It takes its name from the shape of its notch. The discharge…

Q: A confined aquifer has a depth of 12 ft and a hydraulic conductivity of 125,000 ft/yr. If…

A: Specific dischsarge isV=-k×ΔhL Flow rate per unit width:q=-k×ΔhL×b

Q: A partially filled pipe 2.40 m in diameter flows at the rate of 12.75 m³/s. What is the critical…

Q: Groundwater flow in an unconfined aquifer that lies between two parallel canals that are connected…

Q: what is the steady state discharge ?

Q: A pipe of diameter 20 cm and length 2000 m connects two reservoirs, having difference of water as 20…

A: Given: Diameter of Pipe D=20 cm=0.20 m, Length of pipe L=2000 m, Difference of water level H=20m,…

Q: Q.53 The working life of dam built to store irrigation requirement is expected to be 100 yrs. The…

Q: A Dam can be approximated as a barrier with a vertical face that is 32.09 m in height and has a…

Q: SITUATION 11: A 300-mm diameter test well penetrates 27 m below the static water table. Water is…

A: Given a 300 mm diameter test well y = 27m; Water is pumped at a flow rate of 69 l/sec The rate of…

Question

Assume you are dealing with a vertical walled reservoir having a surface area of 500,000 m² and that an inflow of 1.0 m²/sec occurs. How many hours will it take to raise the reservoir level by 30 cm?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Solution:-

VIEW

Step 2 Solution:-

VIEW

Step 3 Answer:-

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A well is constructed to pump water from a confined aquifer. Two observation wells, MW1 and MW2, are constructed at distances of 10 m and 100 m, respectively. Water is pumped from the pumping well at a rate of 0.8 m³/min. At steady state, drawdown is observed as 5 m in MW2 and 19 m in MW1. Note that drawdown is greater for well MW1 located closest to the pumping well. Determine the Transmissivity (cm²/s) if the aquifer is 40 m thick. (Please enter your answers with 2 decimals)
Given are the measurements of weir of a reservoir below. After heavy rainfalls in the city the depth of water over the weir became 4 meters. If the total discharge through the weir was 1 000 000 m³, what is the average rate of flow of the water until the flow over the weir lasted? 4.0 m L-200 m
Problem 2.2: What reservoir capacity is required to produce a uniform yield of 72*10° m³/year for a site where the monthly inflows during a critical flow period are tabulated as below? All monthly flows are in 106 m³/month. Years O 1 2 3 N D 18 8 16 16 21 4 8 15 18 Answer: V = 51*106 m³. J 27 9 35 F M A 13 30 10 2 3 4 15 19 8 M 5 1 5 J 4 0 0 J 3 0 2 A S 0 0 0 0 5 6
The flow net constructed for a dam is shown in the figure below. Taking coefficient of permeability as 3.8 x 10-6 m/s, the quantity of flow (in cm3/ sec) under the dam per m is 50m 6.3m |1.6m :4 9.4m 17.2m Impermeable stratum
A closed cylindrical tank is 10 m long and 3 m in diameter, when the tank is lying in a horizontal position, the water inside is 2m deep. How deep will be the water inside if the tank is in its vertical position?
i need the answer quickly
Give me answer fast
Explain with diagram
An open canal of rectangular cross-section with horizontal base and vertical sides is built through earth of ordinary surface. The canal is 6.5m deep and 8m wide, while the slope of bed is 1 in 791. What will be the discharging capacity using Kutter’s formula?
3. At a particular time, the storage in a river reach is 60 x 10³ m³. At that time, the inflow into the reach is 10 m³/s and the outflow is 16 m³/s. after two hours, the inflow and the outflow are 18 m3/s and 20 m³/s respectively. Determine the change in storage during two hours period and the storage volume after two hours. 4 500 x 106 m³ of water has been stored in the reservoir of a dam at the beginning of November
A well produces water from a confined aquifer at a rate of 550 m3/day for a period of 30 days, and then the pumping rate decreases to 300 m³/day for another 20 days. What is the resulting drawdown at the well at the end of this 50 day pumping period if T = 50 m²/day, S = 0.001, and the well radius in 0.2 m?
You are asked to design a rectangular clarifier for a wastewater treatment plant. The clarifier is designed to settle 2,000 m3/day with an overflow rate of 32m3/m2-day. If the tank is 2.4 m deep and 4.0 m wide, what should the length and detention time be?