A confined aquifer has a depth of 12 ft and a hydraulic conductivity of 125,000 ft/yr. If measurements at two observation wells 2500 ft apart indicate a drop in the piezometric surface of 8.0 ft, then what is the specific discharge (Darcy flux) of this aquifer? What is the flow rate per unit width of the aquifer?

A confined aquifer has a depth of 12 ft and a hydraulic conductivity of 125,000 ft/yr. If measurements at two observation wells 2500 ft apart indicate a drop in the piezometric surface of 8.0 ft, then what is the specific discharge (Darcy flux) of this aquifer? What is the flow rate per unit width of the aquifer?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

9.An unconfined aquifer with K-30 m/day is bounded by a stream on one side as shown in Figure 2, At a distance of 80 m from the stream, a well of 0.4 m diameter is pumped at rate of 3000 m³/day. What is the drawdown in the well? Q=3000 m³/day 20 m m 801 Figure 2 C C d=0.4 m K=30 m/day Impermeable Layer m³ / day
Explain with diagram
12 Determine the quantity of seepage under the dam cross section shown in m3/s/m if the soil has hydraulic conductivity, k=0.0001 meter cube per second. Note the numbers in the figure from left to right are:2.0m, 1.8m, 2.4m and 8.0 m, respectively. 2.00m 8.00 m 1.80 m Datum 12.40m 777 Enter your answer
The figure shows the cross section of a levee that is 500 m long and is underlain by a 2-m-thick permeable sand layer. It was observed that the quantity of water flowing through the sand layer into the collection ditch is 250 m³/day. What is the hydraulic conductivity of the sand layer? Elv. 160 m Levee 1 Elv. 150 m 2 m Ditch 125 m I Impervious O Sand
QUESTION 1 Calculate the transmissivity of an artesian aquifer that has a thickness of 5.5 m and is pumped at a rate of 1.52 m³/min. There are two observation wells located at 150 m and 280 m away with drawdowns of 0.8 and 0.72 m respectively. (15) QUESTION 2 An aquifer has T = 175 m²/day, S = 1.3 x104, and provides a flow of 20 L/s to a well. Find the drawdown at the two observation wells located 15 and 65 m from the producing well after 1 day, 2 months, 10 months and 2 years. (15)
TELEGRAM Q1: A 30cm diameter well penetrates vertically through an aquifer to an impermeable stratum located 18.0 m below the static water table. After a long period of pumping at a rate of 1.2 m3/min, the drawdown in test holes 11m and 35 m from the pumped well is found to be 3.05 and 1.62m respective. What is the hydraulic conductivity of the aquifer? Express in meters per day. What is its transmissivity? Express in cubic meters per day per meter. What is the drawdown in the pumped well?
Charyeong wants to determine the permeability of an aquifer. The aquifer has a 300 mm diameter test well that penetrates 27 m. below the static water table. After 24 hours of pumping at 61 liters/sec, the water level in an observation well 93.53 m. from the test well was lowered to 24.83 m. and the other observation well at 33.3 m. from the test well, was lowered to 23.02 m. Determine the coefficient of permeability of the aquifer in m/day.
CALCULATION USING DARCY'S LAW 1) An aquifer has 2 piezometers installed (A and B) and the distance between them is 1km, the hydraulic loads are 850m and 625m respectively. The average hydraulic conductivity of the aquifer is 3.9 x 10-2 m/day and the effective porosity is 25%, calculate how long in years it takes for the water to walk between piezometer A and B.
The soil under a dam consists of five layers as follows: Hydraulic conductivity (cm/hr) Layer Depth (m) 1 5 4.8 2 2 8.0 3 0.6 18.0 4 1.0 3.0 5 3.5 1 Calculate: v What is the average vertical (perpendicular to flow) hydraulic conductivity of the soil? V What is the transmissivity of the soil, given the water table is at the ground surface?