Two wooden members are joined by plywood splice plates that are fully glued on the contact surfaces. Knowing that the clearance between the ends of the members is 6 mm and that the ultimate shearing stress in the glued joint is 2.5 MPa, determine the factor of safety when L = 180 mm and P = 17 kN.  The factor of safety is

Q: Link AC is made of a steel with a 65-ksi ultimate normal stress and has a 14  ×   1214⁢  ×   12 -in.…

A:

Q: In the structure shown, an 8-mm-diameter pin is used at A, and two pins are used at B and D. Knowing…

A: Given data: pin A diameter = dA = 8 mm Ultimate shearing stress  at pin A = 100 MPa = 100 n/mm2

Q: For the connection shown, the average shear stress in the 18-mm- diameter bolts must be limited to…

A:

Q: ogeth le of 25° with the horizontal. Knowing that the allowable str 0 kPa and t = 600 kPa, determine…

A:

Q: Link AB, of width b =50 mm and thickness t = 6 mm, is used to support the end of a horizontal beam.…

A: Given Width = 50 mm Thickness = 6 mm Allowable normal stress = 2140 MPa Allowable shear shear stress…

Q: The solid circular drill rod AB is made of a steel that is assumed to be elastoplastic with ry= 22…

A:

Q: A steel pipe of 300-mm outer diameter is fabricated from an 8-mm-thick plate by welding along a…

A: Outer diameter d0= 300 mm Force P = 250 kNThickness =8 mmTorque,T=12 kN.mTo determine:a)The normal…

Q: Two wooden members of uniform rectangular cross section are joined by the simple glued scarf splice…

A: Given data: Applied force, P = 11 kN. Resolve the force P into normal and tangential components. F…

Q: 5 mm 20 mm 5 mm Steel core E = 200 GPa Brass shell E = 105 GPa 5 mm 20 mm .5 mm 250 mm

A:

Q: Load P is applied to a steel rod supported as shown by an aluminum plate into which a…

A:

Q: Two portions of member AB are glued together along a plane forming an angle with the horizontal.…

A: The ultimate stress (tension) is The ultimate shear stress is The force applied is The minimum…

Q: Link AB, of width b = 50 mm and thickness,t = 6 mm, is used to support the end of a horizontal beam.…

A: Given data: b=50 mmt=6 mmσ=2140 MPaτ=80 MPa Need to determine the diameter of the pins and average…

Q: Link BC is to be made of a steel for which the ultimate normal stress is 250 MPa. Determine the…

A:

Q: 7o solid steel shafts are connected to f a disk B. Knowing the modulus of = d the allowable shear…

A: given:shear stress τ=90MPa

Q: The member BD is attached to a rod at B, to a hydraulic cylinder at C, and to a fixed support at D.…

A: According to the question data τallow=40ksi at point D σAllow=60ksi =tensile stress in the rod AB we…