Two uncharged capacitors of capacitance 4 µF and 6 µF are connected in series across a 250 V dc source. After being fully charged, the capacitors are disconnected and are reconnected in parallel with each other. What is the final charge stored on the 4 HE capacitor? Write the given, FBD or diagram and solution (Answer: 480 microcoulombs)

Q: If the resistors used for charging and discharging were the same, the charging and discharging…

A:

Q: 7. Three capacitors are connected in parallel across a 230 V, 60 Hz supply. These capacito have…

A: Given: 3 capacitor in parallel. C1=10μF, C2=30μF, C3=60μF Circuit will be:

Q: Question 7: Three capacitors having capacitances 20 μF, 30 uF and 40 μF are connected in series with…

A: The given data is shown below

Q: What is the voltage across a capacitor after being charged from a 10 V DC source for a period of one…

A: Given data: A capacitor charged from voltage, V = 10 V (DC) Time period, t = one time constant = RC

Q: Capacitor 1  labeled capacitance-47 measured voltage-4.44 calculayed voltage-208.68 Calculated…

A: The given data is shown the following table. We need find out total capacitance by using total…

Q: Find the equivalent capacitance and inductance. C1 C2 HHH L1 m L2 m Ceq = ? Leg = ? BA

A:

Q: 4. Six capacitors are connected as shown in the figure. Ci V (a) If Cs-2.30nF, what does C: have to…

A: Given                      C3 =2.30 nFC4 =1.30 nFC5 =1.70 nFC6 =4.70 nF C2+C3 =5 nFC1×C2+C3C1+C2+C3…

Q: 5. What capacit in series with a 1.5-k2 resistor will draw 50 mA from a 120-V, 60-Hz source?

A: Brief description: Capacitor is an electrical element which is used to store the charges in the form…

Q: In the capacitor network shown in the following figure (see image for capacitor network) if the…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.