Two trials were completed in a kinetics experiment, resulting in the data collected below. Calculate the rate of each trial using the change iodine concentration: rate = Enter your answers in the boxes, rounded appropriately for significant figures. Use scientific notation, with E in the place of x10. For example, 1234 would be entered as 1.234E3 and 0.00123 would be entered as 1.23E-3. Do not use units. Trial Acetone, M 2. M H*1, M Time (sec) Rate 1 1.8 0.0025 0.33 136 2 1.8 0.0025 0.66 71 What are the units of rate? Use symbols only your answer. What is the order of the reaction with respect to hydrogen ion? Report your answer to the tenths place. What is the order of the reaction with respect to hydrogen ion rounded to the nearest whole number?

Two trials were completed in a kinetics experiment, resulting in the data collected below. Calculate the rate of each trial using the change iodine concentration: rate = Enter your answers in the boxes, rounded appropriately for significant figures. Use scientific notation, with E in the place of x10. For example, 1234 would be entered as 1.234E3 and 0.00123 would be entered as 1.23E-3. Do not use units. Trial Acetone, M 2. M H*1, M Time (sec) Rate 1 1.8 0.0025 0.33 136 2 1.8 0.0025 0.66 71 What are the units of rate? Use symbols only your answer. What is the order of the reaction with respect to hydrogen ion? Report your answer to the tenths place. What is the order of the reaction with respect to hydrogen ion rounded to the nearest whole number?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Which set is the correct coefficients for the following equations:B5H9 + O2 -------------- B2 O3 + H2O 2, 12, 5, 9 12, 2, 5, 9 1, 9, 5, 12
What is the measurement
A certain type of bacteria divides every 5 seconds If three of these bacteria are put in a petri dish, how many bacteria are in the dish at the end of 1 minute?
Remaining Time! 02:29:4. Consider the balanced chemical equations shown below. When a 6.00 g sample of a mixture of iron (Fe) and aluminum (Al) is treated with excess HCl(aq), 0.177 moles of H2 are obtained. What is the mass percentage of Fe in the original mixture? Choose the closest answer. Fe(s) + 2 HCI(aq) FeCl2(aq) - + H2(g) 2 Al(s) +6 HC((aq) 2 AICI3(aq) + 3 H2(g) 96 % 69 % 47 % 33 % 17 % Rack Question Menu - O O
Please determine the total mg/mL that you were able to recover from the column= experimental yield. Please show your data and calculation Online students the volume is 1.5 mL and the OD 550 is 0.35. Below is a standard curve I generated that you can use. OD 550 vs. mg/mL 4 3. OD 550 1 0 0.2 0.4 0.6 0.8 1.0 mg/mL
decomposition: HgO(s) → Express your answer as a complete chemical equation, with reactants and products. the phases in your answer.
1. Several students performed this experiment without paying adequate attention to the details of the procedure. Briefly explain what effect each of the following procedural hanges would have on the size of the volume- to- temperature ratio calculated by the students. (a) One student failed to replenish the boiling water in the boiling- water bath as the flask was being heated. At the end of the 6 min of heating, the boiling water in the bath was only in contact with the lower portion of the flask. (b) Following the proper heating of the flask in the boiling water, a student removed the flask from the boiling- water bath but only partially immersed the flask in the ice-water bath during the cooling period. (c) A student neglected to close the pinch clamp before removing the flask from the boiling water bath and immersing it in the ice-water bath. (d) One student neglected to measure the volume of the flask before leaving the laboratory. Because the procedure called for a 125-mL…
In order to form Ba(IO3)2, 500 mL of 0.5000 M Ba(NO3)2 was mixed with 500 mL of 0.0500 M NaIO3. Ksp= 1.57x10^-9How many millimoles of Ba(NO3)2 are there in the solution?How many millimoles of NaIO3 are there in the solution?How many millimoles of NaIO3 are needed to completely react with the Ba(NO3)2?
6. Ammonia can react with oxygen to produce nitric oxide and water. 4NH3 (g) + 502 (g) → 4NO (g) + 6H2O The rate at which ammonia is consumed in a laboratory experiment is 6.59 mol/L s. At what rate is water vapor produced? Round your answer to 2 decimal places
openvellum ecollege.com/course.html?courseld=16903471&0penvellumHMAC=041020UD6609 TUCTD3247D2609418712#T030T Constants Periodic Table To solve stoichiometry problems, you must always calculate numbers of moles. Recall that molarity, M, is equal to the concentration in moles per liter: M = mol/L. When solutions of silver nitrate and potassium chloride are mixed, silver chloride precipitates out of solution according to the equation AGNO3 (aq) + KCI(aq)→AgCl(s) + KNO3(aq) Part A What mass of silver chloride can be produced from 1.47 L of a 0.156 M solution of silver nitrate? Express your answer with the appropriate units. • View Available Hint(s) ? mass of AgCl = Value Units Submit Part B P Pearson Copyright © 2021 Pearson Education Inc. All rights reserved. Terms of Use | Privacy Policy I Permissions I Contact Us I 10:05 acer
Find Ann for the reaction below, from the following data: 4NH (g) + 502(g) › 4NO (g) + 6H20(g) Na(g) + 02(g) › 2N0 (g) N2 (g) + 3H2(g) › 2NH3 (g) Ha(g) + ½ Oz(g) › H20(g) AH=??? AH=_180.5kJ AH=_91.8kJ AH= 241.8kJ
The following volumes of 0.000300 M SCN are diluted to 15.00 mL. Determine the concentration of SCN in each sample after dilution. These values will be used during the experiment. To enter exponential values, use the format 1.0e-5. Sample 0.000300 M SCN (mL) [SCN'] (M) 1 1.50 3.50 7.00 4 10.00 3.