Two single-phase transformers A and B are connected in parallel to serve a 600-A single phase load at 080 pf lagging. The equivalent impedance of the transformers are 2 + j3 and 2.3 + j5 ohms, respectively. Determine the ratio of the kw output of transformer A to the kW output of transformer B. Assume the transformers have equal ratings and turns ratio. Draw the parallel transformer diagram

Q: A transformer shown in Figure 10 is needed that will cause an actual load resistance of 250 to…

A: (a) Redraw the given circuit diagram.

Q: 7. What is the no-load voltage when the full-load secondary voltage is 108 V and transformer…

A: Given: In a transformer, Full load secondary voltage V2fl=108 V. Transformer regulation VR=10%.

Q: If you have 3-phase power and you need to step down (or up) in 3-phase voltage, how many…

A: The objective of the question is to determine the number of single-phase transformers required to…

Q: Determine the ratio of the kW output of transformer A to the kW output of transformer B. Both…

A:

Q: Three single phase transformers are connected in a Delta-Wye configuration.  Each transformer is…

A:

Q: ! Required information A centre-tapped transformer has the schematic representation shown in the…

A: The transformer,

Q: QUESTION 12 A single phase 600v/120v transformer has a load of 30 ohms resistive and 20 ohms…

A:

Q: A 3-phase transformer is assembled by connecting three 720 -VA, 360/120 V single phase transformers…

A: A 3-phase, Y−Δ connected transformer is assembled by connecting three 720 VA, 360/120 V single-phase…

Q: In single phase transformer, if the primary turns N1 is greater than the secondary turns N2, then…

A: N1>N2 Then V1>V2 C option are correct

Q: A non-ideal 1-phase transformer has turns ratio 5:1 with 120Vac primary.  The primary impedance is 1…

A: