Two pipes 1 and 2 are connected in series. If the roughness coefficient of pipe 2 is twice of the roughness coefficient of pipe 1, and the diameter of pipe 1 is 430mm. Determine the diameter of pipe 2 if the slope of the energy grade line of poth pipes are the same.

Q: 7. A PFR is not meeting effluent requirements so baffles are going to be added to the tank to…

A: Given data:- The given tank size, deep=12 feet wide=40 feet long=120 feet The given influent…

Q: Glycerin (specific gravity 1.26) in a processing plant flows in a pipe at a rate of 805 L/s. At a…

A: Given data:

Q: Plot Xa and S/Sº vs Theta for So= 2000, 200, 20, and 2.

A: Given that :-Required that :-

Q: 7.30 FLUS For this refinery pipe, DA = 20 cm. Dg = 14 cm, and L= 1 m. If crude oil (S = 0.90) is…

A:

Q: An orifice with diameter 4mm and length 1mm is submerged in lic¡uid. The upstream pressure is 12MPa…

A: d = 4mm l = 1mm P1 = 12MPa P2 = 8Mpa

Q: Which of the following is true about the relation of the Energy Grade Line (EGL) to the Hydraulic…

A: Which of the following is true about the relation of the Energy Grade Line (EGL) to the Hydraulic…

Q: As shown in the figure compute the amount and location of the vertical and horizontal components of…

A: Given data,radius is 7.5mL=10mFINDAmount and location of vertical and horizontal component

Q: A pump is installed in the pipeline between reservoirs A and E as shown in the figure below. Water…

A: Given, Hazan Williams  coefficient =120 discharge Q=10 ft3/s Elevation A and B is 25ft and 40 ft

Q: A 40 cm diameter pipe is carrying discharge in turbulent regime. The pipe's interior surface…

A:

Q: .Determine the minimum cylinder mass m1 required to cause loss of contact at A A 30° 21/3 m L/3 B m1

A: We need to determine minimum mass of cylinder m1 to cause loss of contact at A

Q: Glycerin at 20 °C flows upward in a vertical 75- mm-diameter pipe with a centerline velocity of 3.3…

A: Given: Diameter of pipe, D = 75 mm = 0.075 m Centerline velocity, Vc = 3.3 m/s Length of pipe, L =…

Q: Oil (SG = 0.8, y = 0.010 Pa-s) flows through a 10-cm smooth pipe (length: 100 m) at a discharge of…

A:

Beams

In structural engineering, a beam is a component made of a variety of materials (including steel alloys, and wood) that can resist loads applied laterally to the beam axis. Members, elements, rafters, shafts, and purlins are all terms used to describe beams.