Two parallel gray planes that are very large have emissivities of ε1 = 0.8 and ε2 = 0.7; surface 1 is at 1100°F (866.5 K) and surface 2 is at 600°F (588.8 K). Use SI units for the following: (a) What is the net radiation from 1 to 2? (b) If the surfaces are both black, what is the net radiation?

Two parallel gray planes that are very large have emissivities of ε1 = 0.8 and ε2 = 0.7; surface 1 is at 1100°F (866.5 K) and surface 2 is at 600°F (588.8 K). Use SI units for the following: (a) What is the net radiation from 1 to 2? (b) If the surfaces are both black, what is the net radiation?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 3-in-diameter cylindrical wire is coated in 3 inches of polyethylene insulation. The wire can be modeled as a grey body with an emissivity of .85. Due to the electrical resistance, the wire is at a temperature of 300 degrees Celsius. The insulation is also a great body with an emissivity of .95, at a temperature of 40 degrees Celsius. (Assume F12=1). What is the heat flux (W/m^2) of the energy going from the wire to the insulation?
! Required information Irradiation on a semi-transparent medium is at a rate of 640 W/m². If 160 W/m² of the irradiation is reflected from the medium and 130 W/m² is transmitted through the medium, Determine the absorptivity of the medium. The absorptivity of the medium is 0.75 X
A rigid bar AB of length L = 1600 mm is hinged to a support at A and supported by two vertical wires attached at points C and D such that AC = 500mm and AD = 1200mm Both the wires have same cross sectional area of 16 mm² and made of the same material having Young's modulus of 200 GPa. The wire at C has a length of 400 mm and that at D has 800 mm. Determine the tensile stresses in the wires and downward displacement at point B of the bar when a load of 1 kN is suspended at B.
The parameter that measures how closely a surface approximates a blackbody is called Reflectivity Transmissivity Emmisivity Absorptivity
I need the answer as soon as possible
List this type of electromagnetic radiation in order of (i) increasing frequency and (ii) decreasing energy per photon: Gamma rays
Radiation heat transfer Example: Q1: A large slab of steel 0.1 m thick has in it a 0.1 m-diam hole, with axis normal to the surface. Considering the sides of the hole to be black, specify the rate of radiative heat loss from the hole in W. The plate is at 811 K, the surroundings are at 300 K. A₁ T₁ = 811 k -D=0.1 m- A₂ A3 Hole T S=0.1 m
A 0.6m diameter sphere is suspended in an enclosure. The ball is kept at aconstant 200oC, while the enclosure is kept at 25oC. a) If the enclosure is opaque, how much radiation is emitted by the ball into the enclosure? b) If the enclosure is not opaque, it does not form a black body. Let’s say the enclosure has a transmissivity of 0.6 and a reflectivity of 0.2. How much thermal radiation is absorbed by the enclosure?
= C, Wien's law is stated as follows: 2mT where C is 2898 μm.K and Am is the wavelength at which the emissive power of a black body is maximum for a given temperature T. The spectral hemispherical emissivity (s) of a surface is shown in the figure below (1Å = 10-10m). The temperature at which the total hemispherical emissivity will be highest is Ex 6000 7000 ^(Å) 5000
Please explain with steps.
Determine the following: a. Average emissivity of both surfaces b. Absorptivity of both surfaces c. reflectivity of both surfaces d. which surface is more suitable to serve as a solar absorber?
A typical person can detect light with a minimum intensity of 4.0 x10-11 W/m2. For light of this intensity and λ = 550 nm, how many photons enter the eye each second if the pupil is open wide with a diameter of 9.0 mm?