Two J-K flip-flops with their.J-K inputs tied HIGH are cascaded to be used as counters. After four input clockpulses, the binary count is: a. 00 h. 11 c. 01 d. 10 اختیار Which of the following is correct for a gated D Latch? a. The output toggles if one of the inputs is held HIGH. b. Only one of the inputs can be HIGH at a time. c. The output complement follows the input when enabled. d. Q output follows the inpua Dwhen the enable is HIGH

Two J-K flip-flops with their.J-K inputs tied HIGH are cascaded to be used as counters. After four input clockpulses, the binary count is: a. 00 h. 11 c. 01 d. 10 اختیار Which of the following is correct for a gated D Latch? a. The output toggles if one of the inputs is held HIGH. b. Only one of the inputs can be HIGH at a time. c. The output complement follows the input when enabled. d. Q output follows the inpua Dwhen the enable is HIGH

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

1. Write the Boolean expression for output x in the following figure. Determine the value of x for all possible input conditions and list the values in a truth table. 2. Rewrite the output expression for the new circuit using only NAND gates. 3. Draw the circuit using only NAND gates. A B с D D
the statement that best describes the operation of D flip-flop if the clock is a negative-edge-triggered is: a. The logic level at the D input is transferred to Q on negative edge of the Clock b. The Q output is always the same as the clock input if the D input equals 1 c. The Q output is always the same as the D input at the positive edge of the clock. d. The Q output is always the same as the D input
1. Given the following circuit: 5 ns D. 1ons The gate delays are as shown above the gates. A, B, C are three input, and all of them are varying, as given below: A = 0 at time 0, and stays constant until time = 20 ns, when it changes to 1 and stays constant there after B = 1 at time = 0, and stays at 1 value until time = 35 ns, and then changes to 0 at35 ns, and stays constant after that. !3! %3D C= 0 at time 0 and changes to 1 at 50ns Plot A, B, C upto time = 70 ns.
The D flip-flop is created by connecting two gated D latches serially, and inverting the CLK input to one of them. The following figure shows the internal circuit of D Flip-flop composing of two latches (L1: Master, and L2: Slave) and NOT gate. Answers the following questions. (Note: You should show all the steps) Complete the truth table below. CLK D CLK1 N1 CLK2 Q Q' 0 0 1 0 0 1 1 1
Discussion: 1. NOR gate can be used as: a. operational amplifier b. buffer c. Not 2.What we get if connect A inputs short circuit in NOR gate? а. А b. А с. 0 3. The output of NAND gate is equal to: a. A+B b. АВ с. А+В 4. Which of the following gates can be used to construct a XOR gate when there are four of them? a. OR. b. NOT. c. NAND. 5. What we get if connect the inputs together in NAND gate? 6. What is the output if one input is logic 'l' for a XOR gate? 7. Prove using Boolean algebra that the circuit drawn in figure (2-6-b) is an XOR gate.
Write the three outputs of X, Y and Z in terms of the four inputs A, B, C and D for the follow logic gates configuration
3. Implement the four-variable function below using a 2-to-4 line decoder (with 'normal' outputs) and a 4-to-1 multiplexer. The selection bits of the multiplexer must be a (MSB) and c (LSB). No supplementary gates are allowed, except for inverters. Show the logic diagram. Assume line decoder's imputs are ordered so that the MSB is at the top. The function is given as: f(a, b,c, d) = Em(0,1,5,7,8,14), where a is the MSB.
omplete the timing diagram for the gated latch shown below. S R EN O Q is initially LOW S A EN S P 票。
A B. Output C. What is the truth table and cwhat logic gate it denotes?
Determine whether the two bipartite graphs below have a perfect matching. Justifyyour answer, either by showing a perfect matching or using Hall’s theorem to prove that it doesnot exist.
I need the answer as soon as possible
What will be the output of the clocked D flip-flop if i) Q is connected to input? ii) Q' is connected to input? Assume that initially Q (output of D flip-flop) = '0'.