Two irregular sections 80 m apart have areas in cut of 26 m2 and 34 m2. The base width is 8 m and the side slope is 1:1. Find the corrected volume of cut between the two stations using the prismoidal correction formula.

Two irregular sections 80 m apart have areas in cut of 26 m2 and 34 m2. The base width is 8 m and the side slope is 1:1. Find the corrected volume of cut between the two stations using the prismoidal correction formula.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Find the factor of safety of a slope of infinite extent with 8m thickness having a slope angle =25°.…

Q: FS 2.875 m 4.252 m 5.478 m 6.142 m BS ТР 1 ТР 2 4.325 m 9.542 m 9.631 m 8.133 m BM 1 Elev. = 56.287…

A: GIVEN Traverse Illustration To Determine HI, Elevation, Correction to be applied, and Corrected…

Q: What is the slope in a fixed support with a settlement of 1 mm? O undefined O 0.5 O1

A: Answer : slope will be zero at fixed support. Option (c) 0. Is correct.

Q: A rectangular channel (n=0.011) 18m wide is to carry water at a flow rate of 35 m3/s. The slope of…

Q: Summative Assessment - Virtual Work Method Determine Determine the Slope at C. Use the Virtual Work…

A: Given values: Consider the given beam. E = 29000 ksi I = 200 in4 = 0.0096 ft4 Using Virtual work…

Q: The center height of the road @ STA 7+110 is 2.0 m while @ STA 7+160, it is 1.20 m cut. From STA…

A: Given: The center height of the road at STA 7+110 is 2 m. The cut of the road at STA 7+160 is 1.2 m.…

Q: iven the following slope staking notes, the prismoidal correction factor in cu. Yds., to be applied…

A: Basic for cut = 48 ftbasic for fill =40 ftcut slope, s =2:5:1To find:Prismoidal correction factor

Q: A traverse line was measured in three sections: 295.85 m at slope 8°45', 4°29' and 373.48 m. at…

Q: Water is flowing in a rectangular channel at a rate Q= 1.50 m/sec. The channel has a bootom width…

Q: Given the following slope staking notes, the prismoidal correction factor in cu. Yds., to be applied…

Q: PROBLEM 2: Find the required slope of the channel bottom when water flowing at the rate of 5.82…

Q: The areas in cut of two points of level sections that are 75m apa are 36sqm and 72sqm. Side slope is…

Q: A rectangular channel has a width of 3.6m with a roughness coefficient of 0.013. Compute the…

A: Solution: Given: Width (b)=3.6m Manning's Roughness Coff. (η)=0.013 Mannings equation for critical…

Q: settlement of PL^3/24ei at a

A: Given that, Settlement atA=PL324EI. The objective is to determine the SFD and BMD.

Q: The center height of the (finished) road at the station 0+050 is 2.93 m fill; while at station 0+180…

A: To determine: a) Compute the value of slope of finished road b) Compute the Stationing of the point…

Q: The center height of the road at station 5+280 is 4.50 m cut while at a station 5+400 is 2.40 m…

Q: Given the following notes for three irregular sections, compute the volume of earthwork lying…

A: Answer : Data provided : Roadbed width = 20 Meter Side slope = 1.5: 1 Three level stations 1+200 ,…

Q: Determine the height required for a rectangular channel 20m wide laid on a slope of 0.0001 transport…

A: Width of channel = 20m Slope of channel = 0.0001 Discharge = 240m3/s Mannings roughness coficient =…

Q: Find the required slope of a rectangular open channel when the water flows at a rate of 20,000 L/s,…

A: Option (E) is most appropriate answer.

Q: The areas in cut of two points of level sections that are 75m apart are 36sqm and 72sqm. Side slope…

Q: Q.2. A five-sided closed field traverse has the following angles: A = (101°03'39"); B= (101°42'09");…

A: Surveying is the branch of civil industry in which the measurement between different points on the…

Q: Determine the most probable value of the elevation BM2. Route A: Distance from BM1 = 6.32 km and…

A: We have to find the value of most probable value of the elevation BM2.

Q: A contour map of the lake was prepared as shown below. The area bounded between contours are given…

Q: Q.1. A five-sided field traverse has the following angles: A = (101° 28'38"): B= (102° 10'54") : C =…

A: The downgraded level or the downtown line is also the same when testing to measure the level of a…

Q: Workout the Earthwork quantities in embankment and cutting for the chainage length of 600 meters.…

A: Given Data Formation Width of Road = 20m Side slopes in embankment = 2:1 Side slopes in Cutting =…

Q: The following data are the cross section notes at station 12+046.58 and 12+066.58. The natural…

A: (A) A= 20.25 m2 (B) A= 12.8 m2 (C) VC-VF= 70.3 m3

Q: . Calculate the volume of excavation if the formation width is 8.0

A: Calculate the required gradient, find the level difference b/w the first and last points, Level…

Q: Q.2. A five-sided closed field traverse has the following angles: A=(101°03'39"); B=(101°42'09");…

A: traverse survey - length and bearing both are measured for different line of a traverse. the…

Q: A close traverse has the following field data: Line QR has a bearing of S 8°51' W and a length of…

A: The length and bearings of traverse are given . To find the missing data i will use latitude and…

Q: 2) Slope Area Method A 26m reach of a certain stream AB was selected with cross section shown below.…

Q: Q2- Compute the factor of safety for Slope Number 2 using Janbu’s o = 0 charts (y = 15.77 kN/m³). Su…

A: From the given Data

Q: HW-2-: Compute the area of cross-section if the formation width is 12 m, side slopes are 1 to 1,…

A: Given data:- The given formation width, b=12 m The side slopes =1 to 1 The average height, (h)=5 m…

Q: The areas in cut of two points of level sections that are 75m apart are 36sqm and 72sqm. Side slope…

Concept explainers

Construction Surveys

A construction survey is a survey done on a construction site to mark construction activities and for laying out positions for construction equipment. It includes evaluating and estimating construction activities before the beginning of the project.

Question

100%

Two irregular sections 80 m apart have areas in cut of 26 m² and 34 m². The base width is 8 m and the side slope is 1:1. Find the corrected volume of cut between the two stations using the prismoidal correction formula.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Contour-area method
None
Q29 Please provide justified answer asap to get a upvote
19) Please include complete solution and diagram if possible.
7. From the following cross-section notes for a road grading work. -3.2 +1.2 +1.2 +2.8 XI 3.5 X2 The road bed is 9m wide and the side slope for cut is 1:1 and for fill is 1.5:1. Determine the area of cut of the section.
6. Three points A, B, C are marked on the centerline of a roadway. Line AB has an upward slope of 3.6% while BC has a downward slope of 2.5%. The horizontal distance AB is 75m and BC is 105m. Determine the difference in elevation between points A and C. a. 1.75m b. 0.70m c. 0.25m d. 1.10m PLS INCLUDE SOLUTION
16) Please include complete solution and diagram if possible.
The areas in cut of two irregular section 80 m apart are 128 sq. m. and 245 sq. m. respectively. Both sections are three - level section with base width of 8 m and Side slope of 3:2. Assume the ground slope uniformly between the two sections and use the prismoidal correction formula. At the depth of the cut (the center height) at section 2.
Geotechnical Engg
Using Differential Levelling. Given the traverse illustration, fill up and and complete the table. Show solution in solving HI, elevation, correction to be applied and corrected elevation.
7. From the following set of notes, estimate the cross-sectional area: 2.52 3.42 4.1 5.2 5.8 5.52 3 0 4.68 8.8 The roadwidth/formation width is 6 m and the side slope is 1:1. Calculate the area of the cross section.