TUTORIAL PROBLEIMS 1. Estimate the corona loss for a three-phase, 110 kV, 50 Hz, 150 km long transmission line consisting of three conductors each of 10 mm diameter and spaced 2-5 m apart in an equilateral triangle formation. The temperature of air is 30°C and the atmospheric pressure is 750 mm of mercury. Take irregularity factor as 0.85 Jonisatio umed to toke oltoga gradient of 30 V

TUTORIAL PROBLEIMS 1. Estimate the corona loss for a three-phase, 110 kV, 50 Hz, 150 km long transmission line consisting of three conductors each of 10 mm diameter and spaced 2-5 m apart in an equilateral triangle formation. The temperature of air is 30°C and the atmospheric pressure is 750 mm of mercury. Take irregularity factor as 0.85 Jonisatio umed to toke oltoga gradient of 30 V

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Answer all subpart I will thumbs up... Consider a three-phase single circuit transmission line 362 km long, rated voltage 200kV, 125 MW load and unity power factor. a)Calculate the incident and reflected waves on the source and load sides b)Calculate the voltage on the source side (phase-neutral and phase-phase) c)Calculate the wavelength and its propagation speed Given the following table: R = 0.1069 ohm/km L = 1.3549 mH/km C = 0.0085 microfared/km G = 0
A 219-2 lossless air transmission line is connected to a complex load composed of a 579-Nresistor in series with a 0.01-mH inductor, as shown below. At 4 MHz, determine the voltage standing wave ratio, S. Zo L S = Question 2 A 357-2 lossless air transmission line is connected to a complex load composed of a 740-2 resistor in series with a 0.02-mH inductor, as shown below. At 6 MHz, determine lmaz , the location of the voltage maximum nearest to the load. Zo L Imaz m %3D
i need the answer quickly
Find the Inductance per meter of a Three-Phase Transmission Line using 1.32 cm diameter conductors when these are placed at the corners of an equilateral triangle of each side 2.4 m.
Question 7 A Full explain this question very fast solution sent me
Q1. 30, 110 kV, 50 Hz, 150 km long transmission line consisting of three conductors each of 10 mm diameter and spaced 2-5 m apart in an equilateral triangle formation. The temperature of air is 30°C and the atmospheric pressure is 750 mm of mercury. Take irregularity factor as 0-85. Ionization of air may be assumed to take place at a maximum voltage gradient of 30 kV/ cm. Estimate 1. Critical disruptive voltage 2. Visual critical Voltage 3. Power loss due to corona
Please validate number 1 please
4. (a) A transmission line with a characteristic impedance of 100 has a load of 1 k2 resistance in parallel with a 0.005 µF capacitor connected across the far end. A surge voltage of magnitude 10 kV and unit function form (i.e. step function) travels along the line. Derive an expression for the time variation of the voltage across the load, and calculate the value of this voltage 10us after the arrival of the wave front of the surge
A three phase 60HZ, 85kV transmission line consisting of 3 conductors are placed at the comers of a triangle of sides 10, 5, and 18 meters. The radius of each line conductor is 2.5 cm. The length of the transmission line is 120 km. Assume En=8.854x 10 12. Determine a) Capacitance per phase per meter b)Capacitance per phase per km (L c) Total capacitance for 120 km ( d) Capacitance between the line (Cab) (C d) Capacitive reactance between the line( Xa) (* e) Charging Current for the 120 km
Two overhead lines AB (Z0 = 500 Ω, length = 300 km, attenuation factor = 0.8) and BC (Z0= 300 Ω, length = 120 km, attenuation factor = 0.9) feed a load of surge impedance 1700Ω at C. A triangular wave of peak height (875)/2 kV and duration 300 µs originates in theoverhead line AB at A and travels towards B. Using Bewley Lattice Diagram, determineand sketch the voltages at A, B and C for the first 2 ms. A to J z0=500 ohm, C to J z0 = 300 ohm B to J z0 = 400 ohm D to J z0 = 50 ohm.
1. The conductor used in a three-phase 60 Hz transmission line is 795000 cmil ACSR 54/3 and the lineIt is fully transposed and is 100 miles long. D₁2=7.5 m, 2 D31=1.3 m D23=7.5 m 3 a) Determine the line inductive reactance value. b) capacitive reactance per mile with respect to neutral and line capacitance with respect to neutralset its value.