True/False questions. 1 For filtration process: when the water level rises to the point that the filter bed must be cleaned. ) This point is called terminal head loss ( 2 As the temperature decreases the detention time in 7 slow-mix tank decreases. ( When CO₂ is bubbled in water with carbonate buffer system, the pH will decrease slightly and the reaction will shift to the left. ( The lower the water turbidity, the higher the allowable ) scour velocity in sedimentation tank.( For mixed-media filter the layer of garnet is used to catch the very fine particles ( ) ) 4 Slow-mixing can be accomplished by hydraulic As the weir lengths become shorter the scouring velocity becomes higher ( jump ( ) ) 5 Water with high turbidity requires more coagulant 10 Aluminum sulfate has a wider pH range for effective to be treated. ( coagulation than fèrric salts ( ) ) 3 The addition of polymers in coagulation process is called inter-particle bridging. ( 6 8 9

True/False questions. 1 For filtration process: when the water level rises to the point that the filter bed must be cleaned. ) This point is called terminal head loss ( 2 As the temperature decreases the detention time in 7 slow-mix tank decreases. ( When CO₂ is bubbled in water with carbonate buffer system, the pH will decrease slightly and the reaction will shift to the left. ( The lower the water turbidity, the higher the allowable ) scour velocity in sedimentation tank.( For mixed-media filter the layer of garnet is used to catch the very fine particles ( ) ) 4 Slow-mixing can be accomplished by hydraulic As the weir lengths become shorter the scouring velocity becomes higher ( jump ( ) ) 5 Water with high turbidity requires more coagulant 10 Aluminum sulfate has a wider pH range for effective to be treated. ( coagulation than fèrric salts ( ) ) 3 The addition of polymers in coagulation process is called inter-particle bridging. ( 6 8 9

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A Granulated Activated Carbon (GAC) adsorption laboratory column 10cm in diameter and 3m deep, is found to produce good results in COD removal when operated at a flow of 50L/h. The porosity of the GAC is 0.5 Calculate the following: The application rate in m/h. The residence time, t, in the column. The volumetric flow rate, Vb, in bed volumes per hour, for this residence time. You need to design a GAC system consisting of two columns in series for treating the same water at a rate of 0.5 ML/d. Practical considerations limit the diameter of the columns to 3m. Calculate the minimum required height of the columns.
TRUE/FALSE Give explanation and solve complete
Note:hand written solution should be avoided.
The return line in a secondary clarifier Returns sludge at a lower concentration than in the aerator O Returns only volatile material O Returns sludge at a higher concentration than in the aerator Returns sludge at the same concentration as in the aerator
Please answer all three With short explanation Otherwise please don't attempt The concentration of suspended solids in scration tanks of the activated slide process is called RAS SRT Ssr MLSS Trickling filtration process is a type of (a) Suspended growth processes (b) anaerobic Processes (c) Attached growth processes (d) Aerobic Processes (d) Aerobic Processes Sludge treatment includes (a) Softening (b) Digestion (c) Chlorination (d) All of the above
vated sludge. 12.61 A step-aeration activated-sludge system at a loading of 40 lb of BOD/1000 ft³/day requires an air supply of 1200 ft/lb of BOD applied to maintain an adequate dissolved-oxygen level. The measured average oxygen utilization of the mixed liquor is 36 mg/1/hr. Calculate the oxygen transfer efficiency. (Assume 0.0174 lb of oxygen per cubic foot of air, which is the amount at 20°C and 760 mm pressure.) 12.62 An air sunnly
Solve it 11
please anser 7 and 8
I need a step by step process on solving this homework question.
Liquid alum is delivered to a water treatment plant which contains 642.3 milligrams of alum per milliliter of liquid solution. Jar tests indicate that the best alum dose is 8 mg/L. Determine the setting on the liquid alum chemical feeder in milliliters per minute when the flow is 2.2 MGD.
Ex.3. Estimate the value of minimum particles diameter for (7m long) (1.2m height) settler chamber with gas velocity of (30 cm/sec).The air temperature is (26.6°c) and particles density is (2.5 gm/cm³) with dynamic viscosity of (1.9x 10-5Pa.sec).(for minimum particles diameter the efficiency is 100%).
Design rapid mix unit for 200,000 m3/day raw water, use G = 500 ses T = 40 sec, dynamic viscosity = 10.54*10- 4