Transmission through thin layers. In the figure, light is incident perpendicularly on a thin layer of material 2 that lies between (thicker) materials 1 and 3. (The rays are tilted only for clarity.) Part of the light ends up in material 3 as ray r3 (the light does not reflect inside material 2) and r4 (the light reflects twice inside material 2). The waves of rz and r4 interfere, and here we consider the type of interference to be either maximum (max) or minimum (min). The table below provides the indexes of refraction ng, n2, and n3, the type of interference, and the thinlayer thickness L in nanometers. Give the wavelength that is in the visible range.

Transmission through thin layers. In the figure, light is incident perpendicularly on a thin layer of material 2 that lies between (thicker) materials 1 and 3. (The rays are tilted only for clarity.) Part of the light ends up in material 3 as ray r3 (the light does not reflect inside material 2) and r4 (the light reflects twice inside material 2). The waves of rz and r4 interfere, and here we consider the type of interference to be either maximum (max) or minimum (min). The table below provides the indexes of refraction ng, n2, and n3, the type of interference, and the thinlayer thickness L in nanometers. Give the wavelength that is in the visible range.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

An experiment is setup to measure the diameter of the sphere in the diagram using sizing measurements based on interference. A thin piece of glass slab is placed one side of a highly reflective substrate. A yellow light created by Sodium wavelength = 589.3nm having a normally incident. Fringes can be observed on the glass from the interference. With a gap between the two bright fringes is measured to be g = 0.118mm, with an overall length for the setup to be L = 20mm. The setup will be placed in air having n = 1. What is the diameter of the sphere? W
** 38. Two plastic plates (index of refraction n = 1.3) are separated by an air gap of 0.9 µm. Analyze the reflections of light of wavelength 600 nm and conclude whether it will be brightly reflected or not. 0.9 um gap ** 39. The air gap in the previous problem is now filled with a mineral oil whose index of refraction is n = 1.5. Analyze the reflections of light of wavelength 600 nm and conclude if it will be brightly reflected or not.
In an interference experiment using a monochromatic source emitting light of wavelength 1, the fringes are produced by two long, narrow slits separated by a distance d. The fringes are formed on a screen which is situated at a distance D >> d.Write down an expression for the fringe width w. Please use "*" for products (e.g. B*A), "/" for ratios (e.g. B/A) and the usual "+" and "-" signs as appropriate. Use "lambda" (without the quotes) for 1 in the equation box. For example, use d*lambda for d2. Please use the "Display response" button to check you entered the answer you expect. w=
air 1. n = 1 [a] The figure shows a soap film of thickness dį in air. Light impinges on the film with an angle of incidence 01 and is reflected and refracted at the interfaces. Rays 1 and 2 represents reflected light, while rays 3 and 4 represent light that has been transmitted into the glass. soap \[c] n, = 1.33 |d [b] air n= 1 3 4 The bracketed letters (a], [b], and [c] indicate reflections at the air-soap, and soap-air interfaces. For which of these reflections does a phase change of n occur? Check all that apply. [a] [b] O (c)
Please asap
The analysis of any two-point source interference pattern and a successful determination of wavelength demands an ability to sort through the measured information and equating the values with the symbols in Young's equation. Apply your understanding by interpreting the following statements and identifying the values of y, d, m and L. Finally, perform some conversions of the given information such that all information share the same unit. Two slits that are 0.200 mm apart produce an interference pattern on a screen such that the central maximum and the 10th bright band are distanced by an amount equal to one-tenth the distance from the slits to the screen. y= ________ d=________ m=_______ L=________
A thin film of oil (n=1.4) rests on the surface of a pool of water (n=1.33). Light with frequency 5.0x10^14 Hz traveling through air (n=1) is normally incident upon the oil, undergoing thin film interference. a) Will there be a relative phase shift? b) What is the wavelength of the light in the oil? c) What minimum thickness should the oil have if we wish to get constructive interference? d) What minimum thickness should the oil have if we wish to get destructive interference? Please write your answers in the space below and email your work. For the toolbar, press ALT+F10 (PC) or ALT+FN+F10 (Mac). B I U S Paragraph Arial V 10pt くく AV I XQ 5 ते EE ...
A thin film of cooking oil (n = 1.45) is spread on a puddle of water (n = 1.35). What is the minimum thickness Dmin of the oil that will strongly reflect blue light having a wavelength in air of 451 nm, at normal incidence? Dmin = nm What are the next three thicknesses that will also strongly reflect blue light of the same wavelength, at normal incidence? O 156 nm, 233 nm, and 3111 nm O 467 nm, 778 nm, and 1090 nm O 233 nm, 389 nm, and 544 nm O 363 nm, 606 nm, and 848 nm
Solutions to question 1 please
A beam of light of unknown wavelength λ is incident on a slit of width a = 0.2mm. The light exiting the slit is incident on a screen that is at a distance of L = 1m away. We notice that on the screen, the central maximum has a width of w = 2.7 mm (where the width is the distance between the first-order minima on each side of the central max). What is the wavelength of the incident light?
DS-3 Coherent, monochromatic light goes through a pair of slits which are spaced a distance 0.600 mm apart, and the interference pattern is projected onto a screen. You notice that there are 11 bright fringes within the central diffraction maximum. What is the width of each slit (a)?