Topic: Strema A 750-mm high cylinder carries a load P which produces a normal stress at its cross-sectional area and a shear stress at its lateral surface area. Find its diameter if these stresses are equal. Choices: A. 3.0 m B. 4.5 m C. 1.5 m D. 6.0 m

Topic: Strema A 750-mm high cylinder carries a load P which produces a normal stress at its cross-sectional area and a shear stress at its lateral surface area. Find its diameter if these stresses are equal. Choices: A. 3.0 m B. 4.5 m C. 1.5 m D. 6.0 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Knowing that the maximum allowable stress is 43 MPa, determine the magnitude of the largest moment M that can be applied to the component shown. M B M' A qu 36 mm 150 mm 45 mm 135 mm The magnitude of the largest moment M that can be applied to the component is 14.41 kN.m.
2)For the supporting frame shown below: a) Determine the internal forces acting at section a-a. b) Determine the stress components that act at points A and B. IN = 2.6525x10-7 mª -300 mm 150 mm 2.5 kN a 12 mm 6 mm 6 mm 6 mm 36 mm'36 mm Section a – a
Since P = 10 kN in the welded annex given in the figure,a) Write the equation for the neutral axis in the cross section.b) Draw the normal stress distribution
Problem 3 A block with a weight W hangs from a pin at A. Support bars AB and AC are pinned to the support at B and C. Bar AB has a cross-sectional area of 750mm2 and 500mm2 for bar AC. Neglecting the weights of the bars, determine the maximum safe value of W if the stress in bar AB is limited to 100MPa and that in bar AC to 125MPa. 40 A
The column is subjected to an axial force of 8 kN, which is applied through the centroid of the cross-sectional area. Determine the average normal stress acting at section a-a. Show this distribution of stress acting over the area’s cross section.
A steel rod 3 ft long with a cross-sectional area of 0.3 in.² is stretched between two fixed points. The tensile force in the rod is 1300 lb at 40°F. Using a = 6.5 x 10-6 / °F and E = 29 x 106 psi, calculate the temperature at which the stress in the rod will be (a) 10 ksi; and (b) zero.
please answer all parts step by step and clear answer.
Reg.no : 5395 MOS-2
A flat steel bar, 28 mm wide by 5 mm thick and 1.7 m long, is bent by couples applied at the ends so that the midpoint deflection is 28 mm. Compute the maximum stress in the bar. Use E = 230 GPa. Answer must be in MPa.
STRENGTH OF MATERIALS. Please show the complete solutions. NO LONG EXPLANATION NEEDED! Rate will be given. Answer ASAP! Please answer all. MULTIPLE CHOICE: CHOOSE THE CORRECT ANSWER 1. Using MOHR CIRCLE from the given stresses on two perpendicular planes what is the normal stress on plane a-a? a. 75 MPa b. 150 MPa c. 125 MPa d. 100 MPa
Q.uestion 23.
The tank shown in the Figure below is fabricated from a 10-mm steel plate. If the internal pressure in the tank is 1.2 MPa, calculate the tangential stress in the tank in MPa? ... 400 mm 600 mm