Knowing that the maximum allowable stress is 43 MPa, determine the magnitude of the largest moment Mthat can be applied to the component shown. M B M' B 36 mm 150 mm 45 mm 135 mm The magnitude of the largest moment Mthat can be applied to the component is 14.41 kN-m.

Q: ults in a differential element at the poin a a 0.5 m

A:

Q: The 4000 mm long eyebar BC shown in the figure has an outside dimension of 80mm x 40mm and a uniform…

A:

Q: of the bronze bar and the rigid slab supported by two steel bars as shown. Neglecting the mass of…

A: In such assembly, the free stress will develop when, The free expansion in bronze > free…

Q: The major principal stress and deviator stress at a point are 100 kPa and 60 kPa, respectively.…

A: Calculate minor stress and angle of inclination between the given plane and the major principal…

Q: The solid rod shown in the figure is of diameter d 15 mm and passes through a hole of diameter D…

A:

Q: A typical aluminum-alloy scuba diving tank is shown in the figure. The outside diameter of the tank…

A: The given figure is shown below:

Q: The bar in figure has a constant width of 30 mm and a thickness of 20 mm. Determine the maximum…

A:

Q: Q4\ Calculate the increase in stress for each segment of the compound bar if the temperature…

A: Given Aluminum; A=2.0 in2  E=10×106 psiα=12.8×10-6/°F Steel ; A=1.5 in2  E=29×106 psiα=6.5×10-6/°F…

Q: Rods AB and BC have diameters of 4 mm and 6 mm, respectively. If the 3 kN force is applied to the…

A:

Q: The solid rod is subjected to the loading shown. Determine the state of stress at point C, and show…

A: The figure is shown below,

Q: At a point on the surface of a generator shaft the 10MPa and stresses are o = -50MPa, oy =…

A: A) Given data : σx = -50MPa and σy = 10 MPa To Find : A problem of solid mechanics.

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.