Topic: Rockfall Netting and Guard Rail System Details and abstract and background about i

Q: A drain pipe is to be laid between two points. One point is 13'0" higher in elevation than the other…

A:

Q: Define direct shear test ?

A: Direct shear test: It is a laboratory or field test used to measure the shear strength of the soil.…

Q: Define Flood loads

A: The load expected to occur in case of floods due the the flood waters is called flood load. This…

Q: Apply the force method to determine the reactions at the supports. Assume C is fixed and A is…

A: Given A frame Required  Support reactions using force method

Q: Define timber  piles

A: To define: Timber piles.

Q: At what height is it necessary to install guardrails? O Sec 26.3 (1) O Sec 26.3 (2) O Sec 26.3 (3) O…

A: sec 26.3(2) where height is necessary to install the guardrails.

Q: Problem 2 Figures on page 3 show the partial framing plan and elevations of a three story steel…

A: Problem -2 Given, Dead load at roof,  DLR=15 psf=15 lb/ft2  Live load at roof, LLR=25 psf=25 lb/ft2…

Q: Draw at least 1 seismic design strategy/device. Make a brief statement about its application and…

A: The seismal design procedure depends in nice half on the physical properties of a building. To…

Q: A spillway model constructed to a scale of 1 : 4 gives a discharge of 10 m³/sec. The discharge from…

A: Spillway model scale Lr=1 : 4Discharge of model Qm=10 m3/sTo Find-The value of the discharge from…

Q: QUESTION TwO (a) Determine the side widths and areas of the following cross sections:- Fill section…

A: Given : Fill section consisting sides with slopes 1 in 3 and 1 in 3 Bottom side 1 in 10 Central…

Q: Gravity Dam & Spillways The maximum height of a low gravity dam of elementary profile made of…

A:

Q: Assignment-2 Describe basic loading conditions (loads combination for analysis and design of a…

A: Gravity dams are generally constructed of concrete and sometimes with masonry or a combination of…

Q: What is The downward load-movement plot?

A: Downward load movement plot is defined as the movement of the pile in downwards direction against…

Q: Q5. What is the minimum clearance required by OSHA regulations between a crane and a 150-kV power…

A: The Occupational Safety and Health Administration(OSHA)-The Occupational Safety and Health…

Q: Explain the process for checking Creeping of rails  ?

A: Creeping of rails: Creeping of rails is the phenomenon of longitudinal movement of rails in the…

Q: This is a static mechanics question Question : give a clear definition of the term “ Space Truss” (…

A: To define space truss

Q: List the precautions needed to use level rods.

A: The levelling rod should be always held straight along line of sight. Selection of rods must be made…

Q: V. The hardest part about considering block shear is identifying what the possible failure modes are…

A: Given three figures of failure mode of section subjected to tension and it is asked to choose a…

Q: What types of conduit are in general use?

A: Types of conduit that are generally used are Rigid Metal Conduit—RMC and IMC. Electrical Metallic…

Q: Describe about what is Rockfill Dams?

A: A rockfill dam is an embankment that consists of compacted free-draining earth granular with an…

Q: What is Uniformly loaded strip ?

A: Answer:- Uniformly loaded strip: A uniformly loaded strip is defined as that strip which is…

Q: Explain what is the sucker deck principle for variable depth bridge decks?

A: Solution:- Sucker deck principle for variable depth bridge decks: In variable depth bridge deck, the…

Q: https://www.chegg.com/homework-help/questions-and-answers/2-determine-required-cross-sectional-areas…

A: CALCULATION OF SUPPORT  REACTION: ∑MH=0RA×12-50×9-75×6-50×3=0RA=87.5 KN

Q: acceptability or otherwise in terms of; Overturning Il. Sliding Ill. Bearing capacity failure…

A: Overturning- Failure the retaining wall due to overcoming load on structure and naot capable to make…

Q: State any four safety related acts and regulations to be observed when carrying out underground…

A: Underground works: Drilling, blasting, guniting, rock bolting, and soft soil work are examples of…

Q: 1. How smart tunnel can be avoid flash flood

A: Given-    How smart tunnel can be avoid flash flood?

Q: Determine the horizontal and vertical components of reaction at A, B, and C of the three-hinged…

A: ∴ Dividing fw arch in to two segments i.e A B   &  B C .∴ The free body daiagramme of au arch…

Q: identify and explain the different types of slope protection

A: Slope Protection Protecting the slopes from the erosion will requires several actions which must be…

Q: What is electrical trench?

A: Trench : A trench is a kind of excavation in the ground that is typically deeper than breadth (as…

Q: ​​​​​​​Create CPM Diagram with forward pass and backward pass methods.

A:

Q: Define the term Fixed overhead?

A: The fixed overhead cost is defined as “the costs that do not change even while the volume of the…

Q: What is the similarity between a diversion and the check structure?

A: It is asked to answer the similarity between a diversion structure and a check structure.

Q: Define Cable structures.

A: Cable structures : Cable structure, a type of tension-prone long-span structure that uses suspension…

Q: What is the difference between partially and completely submerged gates

A: Given data Partially submerged gate Fully submerged gate To be find out Difference between two