To the point answers are required. Topic ; PID Controllers Question ;) Write one paragraph on each or more if required Part 1) What is PID control? Part 2) Briefly describe (in one or two sentences) what you understand from trial and error method of tuning PID controllers. Part 3) What are the advantages of tuning the gains of PID controller automatically?

Q: Difference in circuit breakerand isolator.

A: Isolator is also known as the disconnector. As the name suggest they are the isolating switches…

Q: overcurrent protection

A: Given :- Transformer rated at 1000V,              Primary overcurrent protection device is at 250%…

Q: If the cable in Figure ran for the whole of its length, grouped with others of the same size in a…

A: Ambient temperature – The standard or reference temperature for the installation of cables is…

Q: QUESTION 13 L1 Inputs o-S1 0-S2 0-53 0-S4 0-S5 0-S6 0-S7 -S8 o-Se oaS10 8 oo-S11 o-S12 0-S13 10 11…

A: The given ladder logic diagram is shown below. It is mentioned to assume all switches are turned…

Q: (2) Please explain each component and its function in Figure J Trip Figure KS KM1 Z III t III ZI Z…

A: Coil of Wire (Electromagnet): The coil of wire is wound around a metal core and serves as an…

Q: Refer to the National Electrical Code or the working drawings when necessary. Where applicable,…

A: We are authorized to answer one question at a time, since you have not mentioned question you are…

Q: Count Mounting method 15. From the information you have studied about the various electrical…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A 4" conduit installed with 4 # 750 kcmilTHWN-2, and 1 #1 THWN conductors. The conduit due to…

A: It is given that: Pull boxes are utilized in straight pull configuration so that the conduits enter…

Q: -6) Solid grounding is used for voltages

A: Solid is used for the voltages below:

Q: Where does 23/332 for N1/N2 come

A:

Q: Problem 1 is a review of your understanding of KVL (Kirchhoff's voltage law) Using KVL find the…

A: A simple question based on network analysis and the topics described in the solution are kirchoff's…

Q: Problem 6: For the Arduino Nano circuit shown in Figure 05-02(C), determine the (a) Equivalent…

A: In the given circuit the equivalent resistance seen by the Arduino pins needs to be calculated and…

Q: I ONLY NEED THE WINDING DIAGRAM. PLS I NEED IT RUSH

A: To create a winding diagram for a simplex-lap winding, we need to determine the number of coils, the…

Wheatstone Bridge Method

A Wheatstone bridge is a circuit used to measure unknown resistance by measuring the ratios of the two branches of the circuit such that each branch has two resistance and out of four resistance one is unknown. The two branches are joined in between with the help of galvanometer which is used to determine the direction of the current. The main advantage of this circuit is that it can provide the most accurate measurement (different from a simple voltage separator).