Answered: To prepare a soil specimen of 500 cc…

To prepare a soil specimen of 500 cc volume having 10% water content and 8% air voids, the volume of water to be mixed is ml. (Take G = 2.7) A 85.2 ml B 12.6 ml C 62.6 ml D 97.8 ml

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Two days after heavy rain a 100 g soil sample was collected. The size of the remaining hole was 70 cm3. The air-dry soil weighs 80 g and contains 10% hygroscopic water. Calculate the oven-dry weight, the percentage of capillary water, bulk density and the percentage of pore space. Assume a particle density of 2.65 g/cm3
(detailed and clean solution please) large soil sample obtained from a borrow pit has a wet mass of 26.50kg. the in – place volume occupied by the sample is 0.013m3. A small portion of the sample is used to determine the water content; the wet mass is 135g, and after drying in an oven, the mass is 117g. a. Determine the soil’s water content. b. Determine the soil wet and dry density for conditions at the borrow pit.
A liquid limit test on a clay was performed with the following results. The natural water content of the clay is 38% and plastic limit is 21%. Number of Blows 6 12 20 28 32 Water content (%) 52.5 47.1 42.3 38.6 37.5 What is the liquid limit of this clay? (Use Interpolation) Group of answer choices 39.85% 39.99% 36.74% 38.63% Please answer this asap for upvote. Thanks
From Laboratory investigations, the Liquid Limit, plastic limit, natural moisture content and flow index of a soil specimen are obtained as 60%, 27%, 32% and 27, respectively. The corresponding toughness index and Liquidity index of the soil specimen, respectively, are
You are working in a lab and are tasked with determining the percent plant available water for a particular soil sample. You take a field soil sample. The mass of your sample was 152g and it had 18.3% moisture by mass. Then, you place the soil sample in your pressure plate extractor and determine that the soil sample weighs 164.2g when the moisture potential is -33kPa and 130.7g at -1500kPa. What is the percent plant available moisture by mass of this soil sample? Please answer to one decimal place.
Soil placed on a can has been weighed before and after an oven-drying procedure. The procedure yields the following results: Mass of soil + can before placing in the oven 84.6 g. Mass of soil + can after placing in the oven 72.9 g. Mass of can 32.1 g. If the specific gravity of the soil is 2.85, and the void ratio is 0.759, what will be the moist unit weight (kN/m3) of the soil? Round off to two decimal places.
Read the question carefully and give me right solution. Provide detailed solution with clear calculations. The hydraulic conductivity of a soil sample, measured at 25C, was 0.005 cm/s using water as the test fluid (density = 997.2 [kg m–3 ], viscosity = 0.0008872 [kg m–1 s –1 ]. Determine the conductivity for ethanol at 10C, density = 798 [kg m–3 ], viscosity = 0.001394 [kg m– 1 s –1 ]
A soils specimen has a total volume of 95000 mm3 and its mass is 175 g. The dry mass of the specimen is 167 g, and the density of the soil solids is 2.70 Mg/m3. Find: water content, void ratio, porosity, degree of saturation, wet density, dry density. Give the wet and dry density in both SI and British units.
05: The Figure below represents the data that was obtained from a liquid-limit test on a soil. 50 percent of its particles is passing sieve #200. Two determinations for the plastic limit gave water contents of 20.3 % and 20.8 %. Determine 1- Liquid Limit (LL). 2- Plasticity index. 3- Liquidity index if the water content is 27.4% 4- Void ratio at the liquid limit, if G, 2.7 5- Classify the soil based on AASHTO system. 30 10 20 40 60 80 100 Penetration, d (mm) Moisture content, w ()
1. A dry sand is placed in a container having a volume of 0.0092 cubic centimeter. The dry unit weightof the sample is 0.015 gram. Water is carefully added to the container so as not to disturbed thecondition of the sand. When the container is filled, the combined weight of soil plus water is 0.0182gram.a. Determine the specific gravity of soil particle.b. Determine the dry unit weight of soil.2. If the soil sample has a water content of 11% and a unit weight of 19.67 kN/m3 , determine thepercentage of air in voids and the degree of saturation if the specific gravity of soil solid is 2.75.3. If the soil sample has a specific gravity of 2.71 and a porosity of 0.345, determine the saturated unitweight and the bouyant unit weight.4. A soil sample having a liquidity index of 0.85, a plasticity index of 16.50 and a plastic limit of 11.45.The soil sample has a specicfic gravity of 2.68 and a void ratio of 0.77.a. Compute the degree of saturation.b. Compute the air void ratio.
A liquid limit test on a clay was performed with the following results. The natural water content of the clay is 38% and plastic limit is 21%. Number of Blows 6 12 20 28 32 Water content (%) 52.5 47.1 42.3 38.6 37.5 What is the plasticity index of this clay? (Use Interpolation) Group of answer choices 15.74% 18.99% 18.85% 17.63% Please answer this asap for upvote. thanks
The indicative properties of soil types A, B, and C were determined as follows: soil cil soil b 35% 60% 20% 28% 25% 43% 27% 40% 100% 110% 2.63 2.7 49% 26% 35% 10% 45% 2.65 soil A Property Liquidity limit Plasticity limit Percentage of clay materials moisture content Degree of Shiism Specific weight Either type 1 is more effective 2 Its edge density is greater 3 Greater overall density 4 Its porosity is greater .5 Classify soil according to the plasticity diagram.