ReviewConstantSIn the vertical jump, an athlete starts from a crouch andjumps upward to reach as high as possible. Even the bestathletes spend little more than 1.00 s in the air (their"hang time"). Treat the athlete as a particle and let ymaxbe his maximum height above the floor.Part ATo explain why he seems to hang in the air, calculate the ratio of the time he is above ymax/2 (moving up from ymax /2 to ymax and thenmoving down to ymax/2) to the time it takes him to go from the floor to that height. Ignore air resistance.ΑΣφ.?

Name: ReviewConstantSIn the vertical jump, an athlete starts from a crouch
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: ReviewConstantSIn the vertical jump, an athlete starts from a crouch andjumps upward to reach as high as possible. Even the bestathletes spend little more than 1.00 s in the air (their"hang time"). Treat the athlete as a particle and let ymaxbe his

The initial speed of the athlete when the athlete reaches the maximum height.…

Engineering

Mechanical Engineering

To explain why he seems to hang in the air, calculate the ratio of the time he is above Ymax /2 (moving up from ymax /2 to ymax and then moving down to ymax /2) to the time it takes him to go from the floor to that height. Ignore air resistance.

To explain why he seems to hang in the air, calculate the ratio of the time he is above Ymax /2 (moving up from ymax /2 to ymax and then moving down to ymax /2) to the time it takes him to go from the floor to that height. Ignore air resistance.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The figure on the left, below, shows a non-uniform bent rod with a mass of 5 kg. Your job is to determine the location of the center of gravity of this rod. You design an experiment: you connect a pin and cable to the rod such that it safely stays in static equilibrium under a force P that you apply. Then, you apply forces between 0-100 N, and measure the tension force on the cable using a cable tension meter. The results of your experiment are shown in the figure, on the right. Using this experiment, calculate (approximately) the horizontal distance (x in the figure) between point A and the center of gravity G of the bent rod. B C O I 20 cm 20 cm 60° D 50 cm Tension measurement [N] 60 50 40 30 20 -10 0 10 real data estimated fit 20 30 40 ܐܐܝ 50 P[N] 60 70 80 90 100
Calculate the weight of a 6.6-lbm wood on a planet where the acceleration due to gravity is 10 m/s²?
The figure shows the normal force on a jumping person as measured using a force table. A: From the graph, determine the weight of the jumping person. B: What is the maximum net force on the jumping person during the jump phase? C: Approximate the average net force during the jumping phase.
Given the weight of the hot-air balloon to be 600 lb. If the heated air inside the balloon has a temperature of 160 oF while the air outside has a temperature of 85 oF, determine the required volume of the balloon to support the weight (in ft3). Assume the inside and outside air to be at standard atmospheric pressure of 14.7 psia. If the balloon had a spherical shape, what would be the required diameter (in ft)? *Use 1 decimal place on partial and final answers.
plzzzzz help me What is the hydrostatic force (kN) that acts on the Gate A-B? Given that the specific gravity of liquid S=8.9.
Three boxes, A, B, and C, are placed on a frictionless surface as shown in the diagram below. B A If you push on box A with a force of 8.25 N, find the contact force (in N) between each pair of boxes. Here m, = 5.20 kg, m, = 4.05 kg, and m. = 1.50 kg. contact force between A and B contact force between B and C N
5. U-shaped manometer pressure gauge contains oil with a specific gravity of 0.95. A gas container is connected to one side of the pressure gauge and the other is in the atmosphere. The height of the oil connected to the atmosphere is 500mm higher than the height of the oil on the gas container side. What is the pressure of the gas in the container when the atmospheric pressure is 765mmHg? (However, gravity + 1 7 5 2 6 9.81m/s^ 2)
A mechanic is supporting a car with a hydraulic lift. The smaller piston has radius of 3 inches and the larger piston has a radius of 11 inches. How many pounds of force must be applied to the smaller piston to support a car weighing 2500 pounds? The pistons are located at the same vertical distance from the ground. Neglect the weight of the pistons.
In a forklift,cylinder has a bore area of 403 mm2 and pressure 669 N/mm2. Calculate the mass weighed by the forklift's cylinder. the mass weighed by the forklift's cylinder (in tonnes) is
Q1) Find the force Fon the bottom of the tank if : K=1.5 m, H= 6 m , D=5 m. Air Oil Mercury s.g=0.9 F
State Pascal’s principle and give one application of the principle. An object is dropped into a beaker of water. Two forces are operating on the object viz. the weight of object and the buoyant force FB due to the fluid. Explain, in terms of the forces when the object. a.) Sinks to the bottom of the beaker b.)Floats in the water A hydraulic press for compacting powdered samples has a large cylinder with a diameter of 10.0 cm and a small cylinder of diameter 2.0 cm. If a force of 350 N is applied to the small cylinder, what will be the force exerted by the fluid on the large cylinder? Be consistent with your units.
PROBLEM 4 To monitor the pressure in three pipes, a manometer setup was installed in one section of the system. At a particular instant, the gage pressure in pipe B is 7200 Ib/ft. Using the pressure at this pipe as determine (a) the absolute pressure (in psia) in pipe A and (c) the gage pressure (in psig) in pipe C. 3 in oil water 9 in (SG = 0.8) a starting point, manometer fluid (SG = 2.0) 14 in mercury (SG = 13.6) 3 in