To disinfect 5 MGD of drinking water you propose treatment with HOCl using 4 CSTR tanks in series, each of the same volume. A 4-log reduction in Giardia is required. Given an inactivation rate constant k* of 0.53 min-1 , calculate the required volume of the tank in gallons

Q: The calibration curve shown below was used to analyze an unknown protein solution. What is the…

A: The calibration curve equation for the absorbance of the protein solution based on its concentration…

Q: The solubility of a certain salt in 100 g of water is 25 g. 15 g of the salt is placed in 80 g of…

A: Given: The solubility of a salt in water is given as 25 g in 100 g of water. It implies that 100 g…

Q: Given your choice of refractive index, UV-Vis, Fluorescence, conductivity, and mass spec (and…

A: Since you have asked a question with multiple parts, we shall answer the first three parts for you.…

Q: Given that 200 ton/h of commingled MSW with the composition shown in Table below are applied to a…

A: Trommel Screens or rotary screens are the mechanical devices used for the separation of materials.…

Q: Final purification stage in the preparation of a pharmaceutical product A from natural sources…

A: Flow rate of recycle stream is to be determined.

Q: Sufficient boron removal remains a serious challenge for seawater desalination. A plant is made to…

A: To design a two-pass RO system for seawater desalination with a boron removal requirement of 0.5…

Q: What concentration of stock solution should be prepared to allow the use of 10.00 mL of the stock…

A: Given, Volume of stock solution, V1 = 10.00 mL Volume of final solution, V2 = 500.0 mL Concentration…

Q: analysis öf the components in the combustion gases and the extinguishing water. Motivate the…

A: Combution analysis is a method used in both organic chemistry and analytical chemistry to determine…

Q: Q3 :- what is the percent of solution made by adding 40 mL of Methanol to 0.4 L of water

A: Given  Volume of methanol = 40 mL Volume of water = 0.4×1000                               = 400 mL…

Q: Calculate the mean free path of nitrogen gas with a collision diameter of 3.21 x 10 cm at 400 K and…

A: According to Bartleby policy, I can only solve one question at a time I request you to please upload…

Q: A compound had a molar absorptivity of 2.93 x 103 L cm-1 mol-1 What concentration of the compound…

A: Beer Lambert's law is a relationship between the physical properties of the solution and the…

Q: Q5//Magnesium erodes in sea water by 1.45 gmd what is the corresponding rate in, mpy, mm/y ,ipy…

A: Mg erodes in sea water by 1.45 gmd Asked- corresponding rate

Q: Final purification stage in the preparation of a pharmaceutical product A from natural sources…

A:

Q: - Determine the pH of a buffer solution made by adding 60 mL of 0.80 M HCIO to 40 mL of 0.2 M NACIO.…

A: Volume of HClO = 60 ml = 0.06 L  Molarity of HClO = 0.80 M Volume of NaClO = 40 ml = 0.04 L…

Q: An industrial rotary dryer is used to dry a 100 kg of granular solid under constant drying…

A:

Q: A filter press with an effective filtering area between 350m^2 operates constantly maintaining a…

A:

Q: . As a result of measuring the transportation of 0,05mol dm^3 KCI aqueous solution using interface…

A: Given :Concentration of  aqueous solution: Interface movement ():  (which is equivalent to )Flow…

Q: You would like to prepare a nickel catalyst supported in silica using incipient wetness…

A:

Q: Casein is to be washed, in a multistage system, by water. The casein curd has initially a water…

A: To determine the number of washing steps needed to reduce the lactose content of casein to less than…

Q: A water sample contains 0.4 mg/I VSS, 0.5 TDS and 1.2 mg/l TS. What is the FSS value? 0.3 0.1 0.8…

A: The water sample consists of various solids. Total solids (TS) comprise total suspended solids(TSS)…

Q: The company produces a whole broth, containing 4 wt% solids with a bioproduct concentration of 1.4…

A: Extraction is a liquid-liquid separation operation in which the solute form the liquid mixture…

Q: ay you have 2.50 M solution and you need 300. mL of 0.400 MCaSO How can you prepare this dilution ?

A: This question is based on the concept of dilution. Requirement : Concentration, M1 = 0.400 M Volume,…

Q: Q.4) Find the height of packed (absorption tower for the recovery of 97% mole of benzene vapor from…

A: Given data:

Q: What does the Brix (%) represent in terms of filtered juice? What is a refractometer and how does it…

A: 1) The degree Brix (oBx) is the commonly used scale used for the measurement of dissolved or soluble…

Q: How many grams of solute do you need to prepare a buffer (1.6 M Na Citrate 50 mM Tris-base) for a…

A: The Molecular mass of Na Citrate = 258.06g Molarity = 1.6 Volume = 500ml = 0.5l

Q: An oil sample from Ares field was subjected to flash vaporization, differential and separator tests.…

A: Given :Table 1: Flash Vaporization dataTable 2: Differential Vaporization Table 3: Separator test

Q: Final purification stage in the preparation of a pharmaceutical product A from natural sources…

A: Given that,  The mass flow rate of feed F = 100 kg/h The composition of feed = 0.2 kg of A/kg of…

Q: A feed solution with a solute concentration of 3 % by weight is treated by reverse  osmosis. The…

A:

Q: A simple air purifier is designed to remove tiny particles in the air. In order not to scarify the…

A: Permissible pressure drop, Δp = 0.25 atm = 25331.25 Pa Height of the purifier, L = 1.5 m Diameter of…

Q: Q.2// (A) Cyclon with width 0.15m is to be used to separate particle matter of density 1.5g/cm from…

A: Given: width is 0.15 m, particle density is 1.5g/cm3 (1500 kg/m3), velocity of air is 10m/s, density…

Q: simple air purifier is designed to remove tiny particles in the air. In order not to scarify the air…

A: Tiny particles from the air is removed by contacting it in a bed packed with activated carbon.…

Q: A- A filtration test was carried out with slurry on a laboratory filter press of 0.186 m² under a…

A: To estimate the quantity of filtrate that would pass through the cake in 1 hour in the plant scale…

Q: 30% mole of acetone will be subjected to flash distillation at 1 atm. Calculate the concentrations…

A: In an aqueous solution of acetone and water, 30% mole of acetone is present, which is first subject…

Q: The eluate concentration is 257 mCi/ml. You are to make an HDP kit with 300 mCi, and the desired…

A: Given: Eluate concentration = 257 mCi/ml HDP kit is to be made with 300 mCi The desired…

Q: 18. A continuous thickener is required to concentrate a slurry of calcium carbonate in water from a…

A: Calcium carbonate in water from a solids content of  The density of the dry calcium carbonate  The…

Q: 2. Dust particles are to be separated from an air stream at 40 °C and 1 atm. The dust particles…

A:

Q: Carbon is to be diffused into iron with an initial C concentration of 0.25 wt% at 763 °C. If the…

A: Given that Initial Concentration,Co = 0.25 Wt % surface  Concentration,Cs = 1.5 Wt % x = 0.9 mm t =…

Q: A conventional water treatment process is to provide EPA required virus inactivation for a water at…

A: Given data: Temperature of water = 15 0C pH= 7 Residence time = 40 min Travel time in minute = 10…

Q: a technician in a forensics lab is mixing 1500 ml of a 17% acid solution from the available 5% and…

A: