To determine the molar mass of an unknown gas, its effusion time was compared to Oscon gas, which has a molar mass of 42.005g - mol1. A sample of Oscon was found to effuse from a container in 41.71 Part A seconds. The same amount of the unknown gas requires 91.76 seconds. Rateoscon Rateunknown Determine the ratio Hint the times are not the individual rates themselves. Rates are an amount per time. Express your answer using four significant figures. ? RateOncon Ratenknown

To determine the molar mass of an unknown gas, its effusion time was compared to Oscon gas, which has a molar mass of 42.005g - mol1. A sample of Oscon was found to effuse from a container in 41.71 Part A seconds. The same amount of the unknown gas requires 91.76 seconds. Rateoscon Rateunknown Determine the ratio Hint the times are not the individual rates themselves. Rates are an amount per time. Express your answer using four significant figures. ? RateOncon Ratenknown

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Gases are different from solids and liquids. In a sample of gas, the molecules are far apart. The gas molecules also move around and collide with each other as well as with the walls of the container. These collisions generate pressure. The pressure of a gas can be measured in different units. One convenient unit of measure is called the atmosphere (atm) because it is based on atmospheric pressure. At sea level, the average pressure is 1 atm. As you get higher in altitude, the pressure steadily drops until you leave the atmosphere, where the pressure is very close to 0 atm. The table below shows the different commonly used units of measuring gas pressure. Use this table in the pressure unit conversions. Unit Abbreviation 1 atm equivalent FT atmosphere atm 1.00 atm (exact) millimeters of mercury mmHg 760 mmHg torr 760 torr inches of mercury in. Hg 29.9 in. Hg pounds per square lb/in.² 14.7 lb/in.² inch (psi) pascal torr Pa 101,325 Pa Part A Convert 1.20 atm of pressure to its equivalent…
Effusion is the process where a gas flows through a small hole in a container. Graham’s Law of Effusion says that the rate of effusion of a gas from a particular hole is inversely proportional to the square root of the MW of the gas (at constant temperature and pressure). Describe why normal balloons filled with He tend to go flat faster than the same balloons filled with air.
The rate of effusion of NO2 gas through a porous barrier is observed to be 3.05 x 10-4 mol/h. Under the same conditions, the rate of effusion of CO₂ gas would be mol/h.
At 287 K and 1.43*10^-2 atm, the density of a gas is 1.37*10^-5 g/cm^3. (a) Find the Vrms for the gas molecules. (b) Find the molar mass of the gas.
In a 0.5 L container of gas at sea-level where the temperature is 298 K, the collision rate between molecules, Z, is 1.2 x 104 s. If the collision cross-section, o, of 9 × 10-19 m² remains unchanged, what is the change in collision rate if the temperature is cooled to 170 K? Note: the relative average speed is assumed to remain unchanged. 17
The rate of effusion of CH_4 gas through a porous barrier is observed to be mol/h. 2.96 x 10^-4 Under the same conditions, the rate of effusion of Kr gas would be
Xenon hexafluoride was one of the first noble gas com-pounds synthesized. The solid reacts rapidly with the silicondioxide in glass or quartz containers to form liquid XeOF₄ and gaseous silicon tetrafluoride. What is the pressure in a 1.00-Lcontainer at 25°C after 2.00 g of xenon hexafluoride reacts? (As-sume that silicon tetrafluoride is the only gas present and that itoccupies the entire volume.)
Because of their different molar masses, H₂ and D₂ effuse at different rates . (a) If it takes 16.5 min for 0.10 mol of H₂ to effuse, how long does it take for 0.10 mol of D₂ to do so in the same apparatus at the same T and P? (b) Howmany effusion steps does it take to separate an equimolar mix-ture of D₂ and H₂ to 99 mol % purity?
6. On a certain day a laboratory barometer indicates that the atmospheric pressure is 786.2 torr. A sample of gas is placed in a flask attached to an open-end mercury manometer, and a meter stick is used to measure the height of the mercury in the two arms of the U tube. The height of the mercury in the open-end arm is 80.4 mm, and the height in the arm in contact with the gas in the flask is 123.5 mm. What is the pressure of the gas in the flask (a) in atmospheres, (b) in kilopascals?
A sample of O2 gas is observed to effuse through a porous barrier in 7.64 minutes. Under the same conditions, the same number of moles of an unknown gas requires 12.7 minutes to effuse through the same barrier. The molar mass of the unknown gas is g/mol.
Image from Pixabay: https://pixabay.com/photos/petrol-equipment-fire-extinguisher-3079094/ There is 17.0 g of carbon dioxide gas stored in a cylinder with a volume of 11.0. A pressure gauge shows the pressure to be 2.00 atm. R=0.0821 L-atm/(mol-K) In degrees Celsius, determine the temperature of the gas. Round your answer to a whole number. Answer: ____°C
A sample of O3 gas is observed to effuse through a pourous barrier in 1.06 minutes. Under the same conditions, the same number of moles of an unknown gas requires 0.736 minutes to effuse through the same barrier. The molar mass of the unknown gas is g/mol.